3
3. Warranty
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your
satisfaction.Thiswarrantyappliesonlytotheoriginalpurchaserofthisproductfrom
an authorized iSimple dealer. This warranty covers any supplied or manufactured
partsofthisproductthat,uponinspectionbyiSimpleauthorizedpersonnel,isfound
tohavefailedinnormaluseduetodefectsinmaterialorworkmanship.Thiswarranty
does not apply to installation expenses. Attempting to service or modify this unit,
operating this unit under conditionsotherthantherecommendedvoltage willrenderthis
WARRANTY VOID.
Unless otherwise prescribed by law, iSimple shall not be liable for any personal
injury, property damage and or any incidental or consequential damages of any
kind (including water damage) resulting from malfunctions, defects, misuse,
improper installation or alteration of this product. All parts of this iSimple product
are guaranteed for a period of 1 year as follows:
Within the rst 12 months from date of purchase, subject to the conditions above,
iSimple will repair or replace the product at their discretion, if it is defective in
material or workmanship providing it is returned to an Authorized iSimple Dealer,
with PROOF OF PURCHASE from an authorized iSimple dealer.
Warning:
This equipment may be reset by unintentional electrostatic discharge during op-
eration. Exposure to direct sunlight or extreme heat may cause damage or mal-
function.
FCC Class B Radio Frequency
Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential instal-
lation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harm-
ful interference to radio communications. However, there is no guarantee that in-
terference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television recption, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
1. Reorientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from
that of which the receiver is connected.
4. Consult the dealer or an experienced radio / television technical for help.
Notice : The changes or modications not expressly approved by the party respon-
sible for compliance could void the user authority to operate the equipment.
