A&B Home D69517 Bedienungsanleitung

AssemblyInstructions

TheZen Bowl Fountain is packed in two separate

cartons. Cartons are identified as 1/2 and 2/2.

Cartons must be unpacked and contents removed.

1A. Open Carton 1/2 and carefully remove all items,

which include one bowl, one braided hose, and a complete

Pump Kit.



1B. Open Carton 2/2 and carefully remove content,

which includes a pedestal and an inner container.

(The inner container holds the water for the fountain).

Position the inner container in the fountain’s desired

location. Then, carefully lift the outer pedestal and

set it over the inner container Make sure the hatch

faces the power source.

ZEN BOWL Outdoor Fountain #D69517 by A&B Home Inc.

NOTE : Your new fountain has been designed for easy assembly. It should take a team of two less than

one hour to complete the process. Assemble the fountain in its desired permanent location.







Note Lay Carton 2/2 on its side for easy content removal.

Locate and prepare the Access Hatch.

The pedestal has a small access hatch on one side.

With the hatch facing the power source, remove

hatch cover with provided screwdriver, and set

aside. (Screwdriver is shipped with the pump kit).

Note Red valve and short side of braided hose must be

positioned as shown in photo.

Insert long end of braided hose through hatch,

and then through hole in top pedestal.

Instruction pg. 1 of 3

Note Because the electrical cord and plug will come

out through the notch at the bottom, the hatch must face

the power source.

Place and prepare the Braided Hose.



Connect and prepare the Pump.

Locate the pump kit. The pump kit contains 3

threaded connectors (small medium and large).

Select the largest diameter connector and screw

that firmly into the pump body. Loosen hose

clamp and position hose clamp over connector

for pump.

Tighten with provided screwdriver.



Connect the Hose to the Bowl.

Loosen hose clamp on the top portion of

braided hose. Slip hose onto connector found

on bottom of bowl. Tighten hose clamp with

provided screwdriver.

Place the Pump.

Carefully insert pump through hatch opening.

Place pump at bottom of the inner container.

Replace the Hatch Cover.

Thread plug and cord between inner container

and the inner wall of the pedestal. While

threading the plug and cord between the inner

container and the inside of the pedestal, tilt

the fountain and pull all excess cord through

the notch on the bottom edge. Do not allow the

fountain base to rest on the cord; the cord must

be positioned through the notch, as shown in

this photo.

Fill with water to 80% capacity. (Do not overfill).

Insert plug into power source. Run the fountain

for a few minutes to confirm that the pressure

base is at your desired setting. If the flow of

water needs to be adjusted, unplug fountain

from power source. Adjust flow as per Care and

Maintenance document provided with pump kit.

Once you are satisfied with the pressure, replace

the hatch cover and enjoy your new Zen Bowl

Fountain.

Instruction pg. 2 of 3

Note Hose must fully cover the connector.

IMPORTANT 

Check and adjust water level periodically,

Due to evaporation, clean water must be added periodically.Failing to do

so could cause the water pump to run dry, resulting in a damaged pump.

Damage to the water pump due to an inadequate water level in the fountain

base will void the limited warranty.

Winterization of Your Fountain -In colder climates, where temperatures can reach

below 32 degrees Fahrenheit on a regular basis, or where temperatures will drop

substantially below freezing, even for short periods of time, it is recommended that all

water be removed from the fountain kit during the cold months. Also, remove the water

pump by disconnecting the pump from the braided hose. Store the pump in a temperature-

controlled atmosphere (above freezing).

WARNING 

NEVER REMOVE THE GROUND PIN FROM THE ELECTRICAL PLUG. FOR YOUR

PROTECTION, ALWAYS UNPLUG THE PUMP UNIT FROM ITS POWER SOURCE

BEFORE INSTALLING OR SERVICING YOUR FOUNTAIN.

SHOULD THE UNIT APPEAR TO NOT BE WORKING PROPERLY, DO NOT REACH

FOR, REMOVE, OR DISASSEMBLE THE PUMP BEFORE YOU DISCONNECT THE

POWER.

Instruction pg. 3 of 3

While installing, keep children and pets out of reach.

Remember to make sure the plug is dry and clean before inserting into the outlet.

If having trouble with the water flowing evenly from the bowl to the pedastal, or

in the event you need to level the surface of your fountain, use the included

shims to even out the water flow. To use the shims, place the shim{s} underneath

the base opposite the side that that is not flowing evenly. Once shim{s} are in

position break them off at the crease and this will hide the shim but keep the

fountain level.

Read the pump’s manual regarding water pressure control.

For electrical precautions, always use a properly grounded outlet.

NOTES 

For questions and inquires on this item,

please contact Customer Service at A & B Home.

Email - [email protected]

Telephone - 1 888 868 1808

Inhaltsverzeichnis

Andere A&B Home Freiluftbrunnen Handbücher

A&B Home

A&B Home HYDRIAN Betriebsanleitung

Beliebte Freiluftbrunnen Handbücher anderer Marken

Sunnydaze Decor

Sunnydaze Decor XSS-578 Bedienungsanleitung

Campania International

Campania International Bibendum FT-400 Bedienungsanleitung

Elkay

Elkay FLEXI-GUARD EFHA8 1M Series Installationshandbuch

S.R.Smith

S.R.Smith Color Light Stream 2CLSLBK Bedienungsanleitung

Hozelock Cyprio

Hozelock Cyprio Cascade 1500 Bedienungsanleitung

Campania International

Campania International Juliet Fountain Bedienungsanleitung

YARDART

YARDART FT-155 Bedienungsanleitung

Alpine

Alpine WIN732 Bedienungsanleitung

Campania

Campania Valencia Bedienungsanleitung

Campania International

Campania International FT-320 Bedienungsanleitung

GardenWize

GardenWize SWGSL230 Bedienungsanleitung

Kelkay

Kelkay Easy Fountain Rustic Windmill Bedienungsanleitung

Alpine

Alpine WIN258 Bedienungsanleitung

Bond

Bond Signature Series Bedienungsanleitung

Kenroy Home

Kenroy Home 51112COPBL Installationsanleitung

EasyPro

EasyPro Tranquil Décor HBB39 Bedienungsanleitung

Angelo Decor

Angelo Decor Castillo Bedienungsanleitung

Campania International

Campania International Girona FT-102A Bedienungsanleitung