Instructions
Page 01
Your LJ-8 LasscoJog Paper Jogger comes ready to use. Simply plug in the power cord
and turn on the machine.
Note:
Setting Up Your Machine
To change the Jogging action, access the adjustment discs on the underside of the machine as
shown. Loosen Button Head Machine Screw and rotate one of the Adjustment Discs
attached to the Disc Shaft extending from the Motor . Tighten down the Machine Screw.
Adjusting the Jogging Speed
When the screws are located opposite each other on the shaft, the minimum action is
obtained. When the screws are located on the same side of the shaft, the maximum
action is obtained. Normal action is obtained when the screws are 80 to 90 apart.
To change the Jogging action, access the adjustment discs on the underside of the machine as
shown. Loosen Button Head Machine Screw and rotate one of the Adjustment Discs
attached to the Disc Shaft extending from the Motor . Tighten down the Machine Screw.
Underside View
Side View
L-1014: Motor
FM5-5008: Electric Cord
L-1020: #6 Hose Clamp
L-1019: Torque Tube
L-1021: Shaft Collar
L-1017: Eccentric Adjustment Disc
10-32 Screw x 3/4 Button Head Machine Screw
L-1018: Eccentric Disc Shaft
3/8” ID x 3/4” OD Fiber Washer
L-1016: Clevis
L-1034: Flange Bearing
