3Z TELECOM Antenna W.A.S.P. Bedienungsanleitung

Antenna W.A.S.P.

User’s Guide

REGULATORY SPECIFICATIONS 4

FCC PART 15 4

INDUSTRY CANADA NOTIFICATIONS 4

CE MARK CONFORMITY 5

RADIO FREQUENCY NOTIFICATIONS 7

FCC NOTIFICATIONS 7

LIST OF APPROVED ANTENNAS 8

ANTENNA WASP SYSTEM OVERVIEW 9

ANTENNA WASP SENSORS 9

DATA COLLECTORS 9

DATA COLLECTOR MANAGER 9

WASP TELEMETRY AND SENSOR MEASUREMENTS 10

3-D ORIENTATION (AZIMUTH,TILT,AND ROLL) 10

TEMPERATURE 10

BATTERY LEVEL 11

WIRELESS SIGNAL STRENGTH 11

ANTENNA WASP INSTALLATION GUIDE 12

STEP 1-INSTALL THE DATA COLLECTOR MANAGER SOFTWARE 12

STEP 2-INSTALL THE DATA COLLECTOR 16

STEP 3-INSTALL THE DATA COLLECTOR ANTENNA 18

STEP 4-RUN THE DATA MANAGER SOFTWARE 19

STEP 5-CONNECT TO THE DATA COLLECTOR 20

STEP 6-UPDATE SYSTEM TIME 21

STEP 7-APPLY POWER TO THE ANTENNA WASP SENSORS 22

STEP 8-CONFIGURE THE DATA COLLECTOR WITH ANTENNA WASP SENSORS 25

STEP 9-WAIT FOR ANTENNA WASP SENSORS TO CONNECT 30

STEP 10 –INSTALL ANTENNA WASPS ON THE ANTENNAS 31

STEP 11 -COMMISSION EACH ANTENNA WASP SENSOR 33

DATA COLLECTOR MANAGER SOFTWARE GUIDE 35

RUNNING THE DATA COLLECTOR MANAGER 35

CONNECTING TO A DATA COLLECTOR 36

SUMMARY VIEW 38

GENERAL SETTINGS TAB 39

SITE NAME SETTING 40

LOCATION SETTING 40

ALARM SETTINGS 40

ETHERNET SETTINGS TAB 41

SNMP SETTINGS TAB 42

ANTENNA WASP STATUS TAB 43

3D VIEW 44

ANTENNA WASP SETTINGS 46

ANTENNA WASP IDENTIFICATION 46

TARGET ORIENTATION 46

DOWNLOADING ANTENNA WASP DATA 47

3D PLAYBACK VIEW 49

GRAPH VIEW 50

TABLE VIEW 52

EXPORTING ANTENNA WASP DATA 52

TEMPERATURE GRAPH 53

TEMPERATURE TABLE 54

SYSTEM HISTORY 55

SYSTEM STATUS 57

PREFERENCES 58

AUTOMATIC REFRESH SETTING 58

TEMPERATURE UNITS 58

TECHNICAL SUPPORT CONTACTS 59

Regulatory Specifications

FCC Part 15

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction

manual, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own expense.

Industry Canada Notifications

This device complies with Industry Canada’s license-exempt RSSs. Operation is subject

to the following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may

cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux

appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions

suivantes:

(1) l’appareil ne doit pas produire de brouillage;

(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,

même si le brouillage est susceptible d’en compromettre le fonctionnement.

CE Mark Conformity

3Z Telecom, Inc. declares that the WASP Sensor and Data Collector products conform

to their respective specifications, following the provisions of the European R&TTE

directive 1999/5/EC:

3Z Telecom, Inc. déclare que les produits est conforme aux conditions essentielles et

aux dispositions relatives à la directive 1999/5/EC:

• EN 301 489-1 General EMC requirements for Radio equipment.

• EN 300 328 Technical requirements for Radio equipment.

CAUTION—The products are intended to be used in all EU and EFTA countries.

Outdoor use may be restricted to certain frequencies and/or may require a license for

operation. Contact local authority for procedure to follow.

Note: ESD precautions should be used when attaching or removing the antenna from

the Data Collector.

Note: Combinations of power levels and antennas resulting in a radiated power level of

above 100 mW equivalent isotropic radiated power (EIRP) are considered as not

compliant with the above mentioned directive and are not allowed for use within the

European community and countries that have adopted the European R&TTEdirective

1999/5/EC. For more details on legal combinations of power levels and antennas,

contact 3Z Telecom, Inc.

Protect the Data Collector from water. Do not use if Data Collector gets wet.

Avoid using these products during an electrical storm. There may be a remote risk of

electric shock from lightning.

Radio Frequency Notifications

FCC Notifications

RF Radiation: The Product is an intentional radiator of Radio Frequency (RF) energy.

In order to limit RF exposure to personnel in the immediate area, the Product should be

located and installed such that a separation of at least 20 centimeters is maintained

between the Product’s antenna and personnel in the vicinity of the device. The antenna

used for this transmitter must not be co-located or operated in conjunction with any

other antenna or transmitter.

Modification warning: Caution - changes or modifications to this equipment, not

expressly approved by 3Z Telecom, Inc. could void the user’s authority to operate the

equipment.

List of Approved Antennas

To reduce potential radio interference to other users, the antenna type and its gain

should be so chosen that the equivalent isotropically radiated power (E.I.R.P.) is not

more than that required for successful communication. This device has been designed

to operate with the antennas listed below. Antennas not included in this list are strictly

prohibited for use with this device. The required antenna impedance is 50 ohms.

Please note that the WASP Sensor is designed to only operate with an internal, non-

user-replaceable antenna. Therefore the list below is applicable only to the Data

Collector.

List of Approved Antennas for Data Collector

Manufacturer

Model

Type

Connector

Gain

(dBi)

Note

Telestone

STQJ-2400-5

Omnidirectional

SMA plug

reverse polarity

via provided

antenna cable

Galtronics

02008073-

05831

Omnidirectional

SMA plug

reverse polarity

via provided

antenna cable

2.5

Assembled within

same enclosure

as Antenna #3

Galtronics

02008073-

05831

Directional

SMA plug

reverse polarity

via provided

antenna cable

Assembled within

same enclosure

as Antenna #2

Antenna WASP System Overview

Antenna WASP Sensors

The antenna WASP sensors are designed with a highly sensitive digital compass and

inclinometer to precisely measure the orientation of cellular antennas and to wirelessly

relay the information back to the Data Collector.

Data Collectors

The Data Collector is an embedded computer installed at each installation site that

receives and records antenna WASP sensor information. The Data Collector is also

responsible for:

Monitoring the sensor data and raising alarms when out-of-range measurements

are detected.

Generate SNMP traps (optional)

Data Collector Manager

The Data Collector Manager is a Windows application which is responsible for:

Configuring the settings in one or more Data Managers.

Downloading and viewing antenna WASP sensor data from Data Managers.

WASP Telemetry and Sensor Measurements

3-D Orientation (Azimuth, Tilt, and Roll)

The antenna WASP sensor contains a highly sensitive magnetometer and inclinometer

which can detect very slight changes in orientation. The antenna WASP sensor

measures orientation on three different axes as illustrated below.

Azimuth –is an angular measure relative to the Earth’s magnetic field and is

specified in degrees offset from magnetic north. This value can range from 0

degrees (north) to 359 degrees.

Roll –is a measure of the sensor’s deviation from level with respect to the

horizon. This parameter can range from -180 degrees to 180 degrees.

Tilt –is a measure of the sensor’s deviation from vertical (zero degrees). This

parameter can range from -180 degrees to 180 degrees.

Temperature

The antenna WASP sensors are also equipped with a temperature sensor which will

measure and report the ambient temperature at the sensor location in degrees Celsius

or Fahrenheit.

Inhaltsverzeichnis

Andere 3Z TELECOM Antenne Handbücher

3Z TELECOM

3Z TELECOM 3Z Referenzhandbuch

Beliebte Antenne Handbücher anderer Marken

Alfa Network

Alfa Network APA-L01 Bedienungsanleitung

Naval

Naval PR-422CA Bedienungsanleitung

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Bedienungsanleitung

TERK Technologies

TERK Technologies TV44 Bedienungsanleitung

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Bedienungsanleitung

HP J8999A Bedienungsanleitung

MobilSat

MobilSat MSP-S Bedienungsanleitung

Steren

Steren ANT-UHF 13 Bedienungsanleitung

Novatel

Novatel 600-G Bedienungsanleitung

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Bedienungsanleitung

TRENDnet

TRENDnet TEW-AO12O Bedienungsanleitung

Radio Shack

Radio Shack 15-1837 Bedienungsanleitung

CommScope

CommScope CMAX-OMFX-43M-I53 Bedienungsanleitung

Ramsey Electronics

Ramsey Electronics DAP25 Bedienungsanleitung

COBHAM

COBHAM SAILOR 800 VSAT Gebrauchs- und Pflegehandbuch

Trango Systems

Trango Systems AD900-9 Bedienungsanleitung

Steren

Steren ANT-100 Bedienungsanleitung

Proxim

Proxim 5054-PA-23 Bedienungsanleitung