4xem IPCAMENCLOHF Bedienungsanleitung
4XEM Camera Enclosure Mounting Instructions
For IPCAMENCLOHF
Mounting Configuration
1. Use the rear section of the Mounting Bracket (D) as a template for marking the
position on the wall of the Mounting Holes (H). Remove and drill to pattern
required.
2. Attach the Mounting Bracket arm to the wall using the plugs and screws provided.
3. Feed cables from the main Enclosure (C) through the hole of the Mounting Plate
(E) on the Mounting Bracket (D), then feed the cable again to the concealed cable
channel inside the Mounting Bracket throughout the wall outlet (A) or bracket
outlet (B).
4. Attach the main Enclosure (C) to the Mounting Plate (E) of the Bracket with 4 of
the ¼”-20 screws (F) provided.
5. Release Screw (G) on the Mounting Bracket to pan and tilt the Enclosure.
Position Enclosure as required for the correct camera coverage then tighten Screw
to secure.
Fig. 1 – Mounting Configuration
Fig. 2 – Fitting Instructions for camera
1. Heater (optional) 6. Cable Conduits (PGB11 x 2)
2. Heat Shield 7. Captive Retaining Screws x 4
3. Thermal Control Board 8. Heater & Blower Wires, Ground Wire
4. Camera Mounting Platform 9. Ground Wire
5. Terminal Block Assembly 10. Blower (optional)
Fitting Instructions for Camera
1. Unscrew the 4 captive Retaining Screws (C) and remove the Housing Cover (A)
from the Housing Base (B).
2. Release the 4 Keyhole Screws (F) and then slide and withdraw the Camera
Platform (G) from the Housing Base (B).
3. Mount the Camera (H) onto Platform (G) using the ¼” UNC Screw (I) supplied,
ensuring that the Installation Pad (J) is mounted between the Platform and the
Camera. Always ensure that the Camera is firmly attached to the Platform.
4. Connect the Camera/Heater power cable to the rear Terminal Block (E) through
the first Cable Conduit (D) referring to the circuit diagram shown in the section
tilted “Proper Wiring” for proper terminal designations.
5. Connect the video cable to the Camera through the second Cable Conduit (D).
Fig. 3 – Fitting Instructions for Camera Continued
IMPORTANT NOTE:
ALWAYS UNPLUG THE TOP SECTION OF THE GROUND WIRE
(EARTH WIRE) FROM THE BASE WHEN DISASSEMBLING THE HOUSING.
REMEMBER TO PLUG THE TOP AND BOTTOM TOGETHER AGAIN WHEN
REASSENBLING THE HOUSING.
Wiring Instructions
Figure 4 shows the internal wiring diagram of the IPCAMENCLOHF for the window
demister. A spare 6 way terminal block is provided at the rear of the enclosure for the
camera when required and for lens connections. Circuit identified as follows:
TB.1 6 way terminal block H.1 Heater 12 VDC
•
TB.2 3 way terminal block Heater 24 VAC
FTB.1 Fused terminal block Heater 110 VAC
FS.1 3 Amp. Fuse Heater 230 VAC
STAT.1 25°C Thermostat B.2 Blower 12 VDC
•
STAT.2 35°C Thermostat Blower 24 VAC
P.C.B.1 Thermal Control Board
Fig. 4 – Proper Wiring
Inhaltsverzeichnis
Andere 4xem Kamerazubehör Handbücher
