PRINCIPALS OF OPERATION
The Scale Hopper is used for weighing out a precise amount of coffee that is then
loaded into either a roaster or a mixer. The coffee is loaded into a bin and weighed
using a scale with 0.05 lb accuracy. Then with the help of a venturi or vacuum loader
the beans are sucked out of the bin through a hole in the bin. There is a 2-inch feral
provided to attach to the top of the scale hopper base to allow for connection to venturi
or RV loader.
INSTALLATION INSTRUCTIONS
1. Unpack all parts for Scale hopper from box and from inside of scale
bin.
2. Attach casters to base plate as shown in image on pg. 3.
3. Place scale on base in holes and run wire up back post.
4. Attach scale display to L shaped display control bracket and then
attach bracket to side of back post using 2 of the small ¼ 20 screws
provided (This can go on either side.)
5. Put bin in place on the scale and attach place back post place with
loader connection on back post if not already connected.
6. Slide the hose over the elbow and over the bottom of back plate feral
as to connect the two. Tighten the hose clamps after to keep it
together.
7. Place side post plates on bin and use ¼ 20 screws to attach them to
the side post with the spill guard on top.
