ABB SREA-01 Fehlerbehebungshandbuch

ABB Drives

Quick Start-up Guide

SREA-01 Ethernet Adapter Module

3AUA0000042902 Rev A

Effective: 01.10.2008

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

SREA-01 Quick Start-up Guide

1. Connecting power and network

Connect 9–28 V AC/DC to Vin+ and Vin-.

Connect a cross-over Ethernet cable directly to the unit for start-

up. You can use a network after you have configured the unit.

2. Connecting to SREA-01 over Ethernet

The default Ethernet configuration is:

IP address: 10.200.1.1

Subnet mask: 255.255.255.0

Username: admin

Password: admin

Connection method 1:

Configure your PC to the same subnet (e.g. IP address 10.200.1.2

and subnet mask 255.255.255.0).

Use Internet Explorer or Mozilla Firefox and go to location

http://10.200.1.1.

Connection method 2:

Install the ABB IP Configuration Tool from the attached CD. When

you start the program, it will search for connected SREA-01

modules. You can change the network settings of the module by

double clicking it.

Use Internet Explorer or Mozilla Firefox and go to location

http://<ip of the SREA-01 module>, e.g. http://10.200.1.1.

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

SREA-01 Quick Start-up Guide

3. Connecting drive(s)

If you have a single ACS350, ACH550 or ACS550, it is easiest to

use the supplied RJ45 cable to connect to the panel port.

If you have multiple drives or an ACS800, use the RS-485

connection. Connect the A- channels of the SREA-01 unit and the

drives together, the B+ channels together and the COM connector

to the data ground connectors of the drives. Use 120 ohm

terminating resistors in the network.

4. Basic drive settings

Check the communication settings of the drive (either group 52 or

53 in most drives, depending on the connection type).

Station id/number has to be unique for each drive! The baud rate

selection and parity have to be same on all drives and

SREA-01. You can use for example 9600 bit/s, no parity, 1 stop bit.

5. Basic SREA-01 settings

You can change the Ethernet settings under Setup – Ethernet.

Select the correct drive connection settings under Setup –

Modbus.

• Select Physical Interface.

• Usually most other settings are suitable by default (RTU,

9600 bps, no parity, 1 stop bit).

SREA-01

X1 pin Wire

Panel port

RJ45 pin

RX (RS-232) white-orange 1

TX (RS-232) white-blue 3

COM orange and blue 2 and 6

X1 RS-232: Select EIA-232

X1 RS-485: Select EIA-485

X2: Select EIA-232 D-sub

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

SREA-01 Quick Start-up Guide

To search for connected drives, go to page Configuration –

Devices and select autodetect.

6. More information

For more detailed information, please refer to the SREA-01 User’s

Manual located on the attached CD-ROM.

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

Andere Handbücher für SREA-01

Inhaltsverzeichnis

Andere ABB Steuereinheit Handbücher

ABB

ABB MOD 30ML Bedienungsanleitung

ABB

ABB REC650 ANSI Gebrauchsanweisung

ABB

ABB ACL30-04 Series Fehlerbehebungshandbuch

ABB

ABB MNS-MCC Bedienungsanleitung

ABB

ABB ACQ580-04 Bedienungsanleitung

ABB

ABB IMASI13 Bedienungsanleitung

ABB

ABB COM600 series Bedienungsanleitung

ABB

ABB AC500 PLC Bedienungsanleitung

ABB

ABB Relion 670 series Kurzanleitung

ABB

ABB SmissLine TP ZLS 260 Benutzerhandbuch

ABB

ABB TOTALFLOW WellTell Wireless IS Benutzerhandbuch

ABB

ABB HD5-B-901 Bedienungsanleitung

ABB

ABB ret650 Kurzanleitung

ABB

ABB Relion REC670 Gebrauchsanweisung

ABB

ABB RED615 ANSI Gebrauchsanweisung

ABB

ABB ACS880-1604 Bedienungsanleitung

ABB

ABB i-bus EIB Bedienungsanleitung

ABB

ABB BCU-02 Bedienungsanleitung

ABB

ABB Relion 670 series Gebrauchsanweisung

ABB

ABB Welcome M2306 Bedienungsanleitung

ABB

ABB RPBA-01 Bedienungsanleitung

ABB

ABB HD5-B Series Bedienungsanleitung

ABB

ABB COM600 series Bedienungsanleitung

ABB

ABB RMBA-01 Bedienungsanleitung

Beliebte Steuereinheit Handbücher anderer Marken

Festo

Festo Compact Performance CP-FB6-E Stücklistenhandbuch

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung

JS Automation

JS Automation MPC3034A Bedienungsanleitung

JAUDT

JAUDT SW GII 6406 Series Kurzanleitung

Spektrum

Spektrum Air Module System Bedienungsanleitung

BOC Edwards

BOC Edwards Q Series Bedienungsanleitung

KHADAS

KHADAS BT Magic Bedienungsanleitung

Etherma

Etherma eNEXHO-IL Bedienungsanleitung

PMFoundations

PMFoundations Attenuverter Bedienungsanleitung

GEA

GEA VARIVENT Bedienungsanleitung

Walther Systemtechnik

Walther Systemtechnik VMS-05 Bedienungsanleitung

Altronix

Altronix LINQ8PD Montageanleitung

Eaton

Eaton Powerware Series Bedienungsanleitung

WAGO

WAGO 750-407/040-000 Bedienungsanleitung

Sony

Sony CCU-590 Bedienungsanleitung

Graco

Graco 25D614 Bedienungsanleitung

Task Force Tips

Task Force Tips YE-RF-900 Programmierhandbuch

Shini

Shini SPV-U Series Bedienungsanleitung