myaccess.ca | 1-866-363-2225
C033_DigitalBox_SelfInstall_Guide
Step 2: Activate your service.
A. Confirm that all the correct connections are made into the
correct ports on the back of the AccessTV box.
B. Confirm that the TV input is set to the same input as where
the HDMI cable was plugged into on the back of the TV
(HDMI 1, HDMI 2, HDMI 3, etc).
Tip: If you are unsure where the HDMI cable was plugged into, look for a
button labeled INPUT or SOURCE on your factory TV remote. Pressing this
button repeatedly will cycle through all the TV’s inputs. If the incorrect HDMI
port on the TV is selected, the TV will display NO SIGNAL
.C. Make sure your TV and set-top box are both turned on. Once the digital box is powered on, the box will
begin to load. This process can take between 2 to 30 minutes depending on your digital box model.
D. While the digital box is loading, your remote can be programmed to the TV to control volume, on/o
function and mute. This can be done with the remote manual that was provided in the self-installation kit.
E. When the loading process is complete, the channels that you are subscribed to will be available
for viewing.
Note: The TV guide information may take 2-20 minutes to fully load. If some channels in the guide say
NO DATA, the box may still be loading the guide information.
Need more assistance?
Find your answers here
1. Visit us online at myaccess.ca/support.
