Accusplit Healthengine AH120M9 Bedienungsanleitung
2 3
45
6 7
Operating Instructions
ACCUSPLIT
AH120M9 PEDOMETER
DISPLAYS
CURRENT DAY
Display
days
1
7644
MEMORY
display area (flashes when in memory mode)
MEMORY
Display
8922
16:30
The pedometer has two display modes: CURRENT DAY and
MEMORY.
1. CURRENT DAY display: Memory display area in
lower right of screen is blank and clock is present
in lower left corner.
2. MEMORY display: Memory display area in lower
right of screen shows which day’s results you are
viewing.To enter MEMORY display, press the gray
“M” button.
Return to CURRENT DAY display by repeatedly pressing
the gray “M” button until the memory display area is
blank, and clock returns.
Make sure you are in CURRENT DAY display when setting up
your pedometer and checking today’s steps.
2
SETTING UP YOUR PEDOMETER
ACCUSPLIT products use a common setting procedure,
S1-S2-S3-S4.
Press S1 for 2 seconds: Enter the SET mode
Press S2: Change the field to be set
Press S3: Change the field value
Press S4 for 2 seconds: Exit the SET mode
SETTING THE CLOCK
The clock must be set in order for the memory’s automatic
rollover function to work correctly.
1. Press and hold the gray S1 button for 2 seconds. The
HOUR display will start to blink, showing that you’ve
entered SET mode.
8922
16:30
2. Press the gray S3 button to increase the HOUR display.
Hold the button down to change hours quickly.
PM hours are displayed in military time (1:00 PM is
13:00, 2:00 PM is 14:00, etc.).
3. Press the yellow S2 button to switch from the HOUR
display to the MINUTE display.The MINUTE display
will start to blink.
4. Press the gray S3 button to increase the MINUTE
display. Hold the button down to change minutes
quickly.
5. Press and hold the yellow S4 button for 2 seconds to
exit SET mode and return to STEP mode.The display
will stop flashing.
990-003B
ACCUSPLIT, Inc.
2290A Ringwood Ave., San Jose, CA 95131
800-965-2008 • 925-226-0888 • FAX 925-463-0147
www.ACCUSPLIT.com/support • support@ACCUSPLIT.com
Eat Right! Walk More! Live Well!
The ACCUSPLIT Lifestyle
How to Open your pedometer.
See diagrams at right.
ACCUSPLIThealthengine
125379
15:15 785
MODE
MEMORY
RESET
10 11
8 9
12 13
14 15
Leash is already attached
to the pedometer.
Clasp the waistband of
your clothing with
the attached
alligator clip. Or, loop a
badge holder, then
put into pocket
(Badge holder
not included)
Or, loop a belt
or belt loop
SAFETY LEASH
This pedometer comes with a free safety leash, to help
prevent accidental loss.The leash comes pre-attached to the
pedometer.
To use the leash, simply clasp the waistband of your clothing
with the attached alligator clip. You can also use a safety pin
to fasten the leash to your clothing, loop the leash through
your belt or belt loop, or use a badge holder.
See sketch on next page for details.
VIEWING YOUR RESULTS
Viewing Today’s Results
Once you put on your pedometer and close the lid, it will
automatically begin to record your steps.
• STEP mode displays all the step count activity since
last automatic daily reset (at 3:50 AM)
• TIME OF DAY appears in lower left hand corner of
the display.
5:18
8722
Clock
STEP count
VIEWING PREVIOUS DAYS’ RESULTS
Your pedometer has 9 total memories.There are 7 days
of step memories, plus today’s step count, plus a TOTAL
memory of all steps taken during the past 7 days.
WEARING YOUR PEDOMETER
While gently holding the metal belt clip open, slide the pe-
dometer onto your belt or the top edge of your pants or skirt.
It should fit snugly and level, above one knee.
Note: the pedometer should be as vertical as possible.
Walkers with larger stomachs may find it helpful to wear the
pedometer farther back on the body, toward one hip.
The cover must be closed for the pedometer to work.
yes
no
days
7total
87329
MEMORY
display area
(flashes when in memory mode)
(no clock in
memory mode)
To recall the daily memories from the previous 7-day period:
1. Press the gray “M” button to search for the specific
day’s records you would like to recall. For example, if
you would like to review the records of 2 days ago,
press the “M” button until the DAYS display shows
“2 days.”
2. “1 days” is the record for yesterday, “2 days” is for
2 days ago, etc. “7 days total” shows you the total
activity for the past 7 days.
3. Records older than 7 days are automatically
discarded.
REPLACING THE BATTERY
1. When the figures on the display start to blink, it is
time to replace the battery.
2. The unit uses oneType CR2032 3-volt lithium battery.
3. Insert a coin into the slot at the bottom of the body
case.Twist the coin to remove the front case.
4. Locate the BATTERY HOLDING PLATE at the bottom
left corner of the inside case. Remove the plate by
loosening the two small screws with a small Phillips
head screwdriver.
5. Take out the old battery and replace it with a new
battery. Place the battery’s positive (+) terminal
FACE UP while you install it into the pedometer.
CLEARING THE MEMORIES
Auto Reset: At 3:50 AM every day, the previous day’s STEP
record is automatically saved and STEP display resets to 0.
You do not need to press the RESET button every day.
Manual Reset: To reset today’s STEP data to 0, press and
hold the yellow RESET button for 2 seconds. Note: Resetting
today’s steps before automatic nightly rollover prevents them
from being tallied in memory.
System Reset: To reset all memories to 0 (including the clock),
press the recessed SYSTEM RESET button in the lower left
corner of the front of the display. (Use a pen or the end of
a paper clip.) Note: In case of irregular display due to static
electricity, pressing the SYSTEM RESET button, and then
resetting the CLOCK, will return the unit to normal.
Terminal
Screws
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
Free service for first year of ownership;
$12 fee for service thereafter. See label inside unit for date.
See www.accusplit.com/support for details
and back case together, then pressing the bottom of
the case together. If the two halves don’t go together
easily, check if the front case is upside down!
7. Reset the CLOCK to restore all functions to your
pedometer.
CAUTION: Please DO NOT TOUCH inner pedometer parts,
other than battery. Touching the sensor mechanism may
affect the accuracy of the pedometer.
6. Reinstall the BATTERY HOLDING PLATE
by tightening the two
screws. Put the case
back together by
matching the
top edges of
the front case
16 17
18 19
Inhaltsverzeichnis
Andere Accusplit Schrittzähler Handbücher
Accusplit
Accusplit AE2790 Bedienungsanleitung
Accusplit
Accusplit Eagle 998-299B Bedienungsanleitung
Accusplit
Accusplit AE2740 Bedienungsanleitung
Accusplit
Accusplit Eagle 1520M2 Bedienungsanleitung
Accusplit
Accusplit Eagle AE120XL Bedienungsanleitung
Accusplit
Accusplit Alliance 1540 Bedienungsanleitung
Accusplit
Accusplit Eagle AE180XL Bedienungsanleitung
Accusplit
Accusplit Healthengine AH190M28 Bedienungsanleitung
Accusplit
Accusplit Eagle AE140XL Bedienungsanleitung
Accusplit
Accusplit EAGLE™ 1120 Bedienungsanleitung
Accusplit
Accusplit 1590 Bedienungsanleitung
Accusplit
Accusplit Eagle 1540M2 Bedienungsanleitung
Accusplit
Accusplit Eagle 140S Bedienungsanleitung
Accusplit
Accusplit AE2720 Bedienungsanleitung
Accusplit
Accusplit Eagle 1620 Bedienungsanleitung
Accusplit
Accusplit Buster Bedienungsanleitung
Accusplit
Accusplit Eagle AE120XLM Bedienungsanleitung
Accusplit
Accusplit Healthengine AH190M28 Bedienungsanleitung
Accusplit
Accusplit AE1691M17 Bedienungsanleitung
Accusplit
Accusplit AE2740 Bedienungsanleitung
