Acer Smart Touch Kit II Bedienungsanleitung

Smart Touch Kit

Ⅱ

INTPJ-STK2-UST/INTPJ-STK2

User’s Guide

Information for Your Safety and Comfort

Read these instructions carefully. Keep this document for future reference.

Follow all warnings and instructions marked on the product.

Caution for plugs when disconnecting devices

Observe the following guidelines when connecting and disconnecting power to

the external power supply unit:

• Install the power supply unit before connecting the power cord to the AC

power outlet.

• Unplug the power cord before removing the power supply unit from the

emitter module.

• If the system has multiple sources of power, disconnect power from the

system by unplugging all power cords from the power supplies.

Caution for Accessibility

Be sure that the power outlet you plug the power cord into is easily accessible

and located as close to the equipment user as possible. When you need to

disconnect power from the equipment, be sure to unplug the power cord from

the electrical outlet.

Warnings

• Do not install the camera module and the emitter under direct sunlight or

reflected sunlight. Please use the standard USB cable that came with our

product, and do not replace it with any other cable.

• Do not expose your eyes directly to the light outlet of the emitter within 40cm.

• Do not look into the bulb of the projector directly.

• Do not drop the product above 1m height.

The deviation of flatness for the projection whiteboard is +/-2mm.

• Do not use this product near water. Please use our product in an environment

with qualified temperature and humidity according to the product requirements.

• Be careful when fixing the camera module on the projector at a high position;

if the product drops, it could be seriously damaged.

Contents

Introduction and Features .......................................................1

Hardware Installation...............................................................4

System Adjustment..................................................................8

Calibration Software..............................................................12

Gesture recognition introduction ...........................................21

Educational Software ............................................................22

Troubleshooting Guide..........................................................28

Introduction

Product Profile

Smart Touch Kit

Ⅱ

is the first product in the world that supports finger touch

and is easy to carry around. It makes any projection screens or LCD screens

touchable with fingers.

Features

• Support finger touch: Use fingers instead of pens to write or control.

• Support Multi-touch: Up to ten people can write and erase simultaneously.

• Portable and easy to install: Just put the emitter above the projection screen

by magnets or screws, and mount the camera on the projector or the ceiling.

No need for professional technicians.

• Our product can turn any flat surface (like boards, walls, LCDs) into finger

touch screens.

• Able to operate on any non-transparent objects. In the active area, any

non-transparent object can be used as a pen.

Package Overview

Make sure your box contains everything listed below. If any of the pieces is

missing, please notify your dealer.

Camera Emitter Mount

(Optional) Mount

(Optional)

Security card

(Optional) User's guide

(CD-ROM) Security card

(Optional)

Magnets

Screws USB cables

(6m and 12m)

Pointer Adapter

Note: The package contents may differ by regions

Specifications

Smart touch kit II

Calibration Automatic / Manual

Multi-touch Ten point touch

Latency

< 30ms

Filter Software auto-control that enhances stability

Min Active Size

40 inches

Max Active Size

120 inches (rooms without sunlight); 100 inches(rooms

with sunlight, different throw ratios for different models)

Technology Laser Image Calibration Technology

Positional Accuracy

±1 Pixel

Aspect Ratio 4:3, 16:9, 16:10

Projection ratio

Ultrashort throw: 0.21, shortest installation distance:

0.45m;

Ultrashort throw: 0.28, shortest installation distance:

0.45m;

(Depends on 80” projection screen aspect ratio: 4:3)

Laser Beam 2

Wavelength of Laser 940nm

Output power for

adapter

3.3V / 2A

Output power for

camera

5V / 0.5A

Signal Refresh Rate

120fps

Weight for package 2kg

OS Requirement Win7, Win8, Win8.1, Win10

Software Calibration software and GLBoard (Application Software)

The compatible Acer

projector

INTPJ-STK2-UST: 0.21 for Acer UL and U5 series

INTPJ-STK2: 0.28 forAcer S1 series and other models

Hardware Installation

Install the camera module:

1st installation method (Bracket 1):

Install the camera on the top of projector by using the mounting component; fix

the camera firmly to prevent it from moving wobbly. Adjust the angle of the

camera to ensure that it can be detected by the emitter (as shown in the pic

below).

2nd installation method (Bracket 2)：

Fix the camera to projector by using the matched black supporting bracket

(shown as the following image):

First, fix the camera to the black supporting bracket with the matched screw via

a screwdriver and make sure the camera should be at the right position (shown

as the following images):

At last, fix the supporting bracket to the projector with matched small screws

(shown as the following images):

Note:

Bracket 1 and bracket 2 are optional. Please refer to actual packaging

accessories.

Install the emitter module:

Install the module approximately 3cm above the projection surface and make it

aligned with the center of the image.

The module is equipped with magnets, allowing it to be attached to

whiteboards directly. If the module needs to be installed on a location where

magnets cannot be used, it can be fixed in place using 3M adhesive tapes or

screws.

Device connection:

Connect the camera module to your computer (USB port) using the 12m USB

cable. Connect the emitter module to power using the 6m USB cable and the

3.3V / 2A power adapter. The wireless infrared connection is used to connect

the camera module and the emitter module.

Software Installation:

1. Our software supports Win7, Win8, and Win10 OSes. Put the software CD

into the computer and start the software by double clicking. Choose the

language from the prompted message, and select the throw ratio type

according to the product model.

Note: Select Throw Ratio0.21 for INTPJ-STK2-UST and Throw Ratio0.28 for

INTPJ-STK2

2. Choose the installation path to continue.

3. Be patient and wait for the installation to finish in several minutes.

4. When the installation is complete, an IWB icon will be added to the

desktop.

Uninstall the Software

1. Open “Control Panel”

2. Click “Program and Function”

3. Right-click the software and click “Uninstall”

4. Reboot the computer once the software has properly completed

uninstallation.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Acer Digitalkamera Handbücher

Acer

Acer CU-7530 Bedienungsanleitung

Acer

Acer Digital camera 8.1 Mega pixels CCD Bedienungsanleitung

Acer

Acer CL-6300 Bedienungsanleitung

Acer

Acer CE-6430 Bedienungsanleitung

Acer

Acer CE-5430 Bedienungsanleitung

Acer

Acer Digital camera 6.20 Mega pixels Bedienungsanleitung

Acer

Acer Holo360 Bedienungsanleitung

Acer

Acer CR-5130 Bedienungsanleitung

Acer

Acer DC 300 Bedienungsanleitung

Acer

Acer Digital camera 6.2 Mega pixel CCD Bedienungsanleitung

Acer

Acer Digital camera 7.40-megapixel CCD Bedienungsanleitung

Acer

Acer CR-6530 Bedienungsanleitung

Acer

Acer Digital camera 6.36 Mega pixels Bedienungsanleitung

Acer

Acer Digital camera 6.20 Mega pixels Bedienungsanleitung

Acer

Acer CS-5530 Bedienungsanleitung

Acer

Acer Digital camera 10.1 Mega pixels CCD Bedienungsanleitung

Acer

Acer Digital kamera 8.28 Mega pixels Bedienungsanleitung

Acer

Acer CAM570 Bedienungsanleitung

Acer

Acer Holo360 Bedienungsanleitung

Acer

Acer Digital kamera 8.28 Mega pixels Bedienungsanleitung

Acer

Acer CP-8660 Bedienungsanleitung

Acer

Acer Digital camera 6.36 Mega pixel CCD Bedienungsanleitung

Acer

Acer CU-6530 Bedienungsanleitung

Beliebte Digitalkamera Handbücher anderer Marken

Mercury

Mercury 350K Bedienungsanleitung

Pentax

Pentax Optio LS 465 Bedienungsanleitung

Sanyo

Sanyo VPC-S1085 Bedienungsanleitung

GE SMART A1255 Bedienungsanleitung

Point Grey

Point Grey Gazelle Bedienungsanleitung

Nikon

Nikon COOLPIX A Bedienungsanleitung

Pentax

Pentax P-5 Bedienungsanleitung

BlazeVideo

BlazeVideo A280 Bedienungsanleitung

Sony

Sony MCA-20 Bedienungsanleitung

Sony

Sony Alpha DSLR-A290 Bedienungsanleitung

ATIK Cameras

ATIK Cameras One Bedienungsanleitung

CohuHD Costar

CohuHD Costar 3930 Series Bedienungsanleitung

Leica

Leica M10-R Bedienungsanleitung

FujiFilm

FujiFilm FinePix A700 Bedienungsanleitung

Lorex

Lorex LNZ81P25 Series Bedienungsanleitung

GE J1470S Bedienungsanleitung

Sony

Sony A6700 Benutzerhandbuch

Canon

Canon EOS ELAN7 Bedienungsanleitung