Acorp VS300-E Bedienungsanleitung
USB Phone
VS300-E
User’s Manual
Copyright Statement
No part of this publication may be reproduced in any form by any means without the prior
written permission. Other trademarks or brand names mentioned herein are trademarks or
registered trademarks of their respective companies.
Disclaimer
Information in this document is subject to change without notice. The manufacturer does not
make any representations or warranties (implied or otherwise) regarding the accuracy and
completeness of this document and shall in no event be liable for any loss of profit or any
commercial damage, including but not limited to special, incidental, consequential, or other
damage.
Skype is a registered trademark of Skype Technologies SA. Windows is a registered trademark
of Microsoft Corporation.
August 2005, Rev1.0
1. Introduction
This USB phone provides you more conveniences to make free call over the
Internet from PC to PC anywhere as easy as using normal telephones. Simply
plug the USB phone into the USB port of your PC, download Internet
telephony software like Skype®, and you can start making calls. You can easily
access the net and connect your friends, family members or colleagues. The
phone is fully compatible with Skype and can be used as audio device with
Yahoo Messenger, MSN Messenger, MS NetMeeting, Google Talk, net2phone
and etc for voice communication. It’s designed similar to a mobile phone with
quick dial and volume control buttons.
Package Contents
zUSB Phone with USB 2.0 Connector x1
zSoftware Utility CD x1
zQuick Installation Guide x1
System Requirements
zComputer with an available USB 1.1 port or higher
zWindows 98SE/ME*/2000/XP (All use Windows built-in audio driver)
zTo use Skype with the USB phone, your computer must meet the
following minimum system requirements**:
• PC running Windows 2000 or XP.
• 400 MHz processor
• 128 MB RAM
• 15 MB free disk space on your hard drive
• Internet Connection
* Skype doesn’t support Windows 98SE/ME. Under these systems, the USB Phone only works
as an audio input/output device and can be used with an instant communication software,
e.g., MSN Messenger, Yahoo Messenger and etc.
** The requirements are subject to Skype software. For the latest requirements, please visit the
Skype website.
Features
zCompatible with VoIP (Voice over Internet Protocol) solution such as Skype, X-Lite,
X-Pro, etc
zWorks as microphone & earphone with Google Talk, Yahoo Messenger, MSN
Messenger, MS NetMeeting and etc.
z5 types of ring tones for incoming alert
zBuilt-in hot-key functions to operate Skype software as easy as dialing a normal
telephone
zSupport volume control using hotkeys on the phone
zAs compact as a mobile phone, easy to carry
zNoise reduction for better sound quality
zCompliant with USB 1.1 specification
zBus-powered, no additional power adapter required
zSupport USB power-saving mode. Save power when computer goes to sleep mode.
zComplies with H.323, MGCP and SIP Protocol
zBuilt-in speaker and microphone
Exterior Overview
Keypads and Control Buttons (Skype Mode)
Numpads
0-9, *, #
Hang off/Clear all
entered numbers
Ends or rejects a call.
Up/Down
Moves up and down
in Skype contact list
and calling list; or
Volume Up/Down
during conversation
‘+’
Pressing for 2
seconds
Used for SkypeOut
Skype Tab
Dial/Answer/Redial
Switch between
Friend List /
Outgoing Call list or
Incoming Call list; or
Clear last entered
number when
entering numbers
Keypads and Control Buttons (X-Lite/X-Pro Mode)
Numpads
0-9, *, #
Hang off/Clear all
entered numbers
Ends or rejects a call.
Volume
Increase/Decrease
‘+’
Pressing for 2
seconds
Used for SkypeOut
Tab: Phone number
Completion
Dial/Answer
Dials, answers or
redials a call.
Backspace
Clear last entered
number
2. Hardware Installation
Connect the USB connector of the USB phone to your computer’s USB port.
When connected to your computer, Windows will automatically detect the
new device. Complete the driver installation according to your Windows
operation system.
For Windows XP/2000
Under Windows XP/2000, you don’t need to install the driver. The system will
automatically install Windows built-in audio driver. After that, you are ready to
use the USB phone.
For Windows Me
When the Add New Hardware Wizard screen pops up, select Automatic
search for a better driver and then click Finish to complete the Windows
built-in driver installation.
For Windows 98SE
Upon detecting the new device, take these steps:
1. When the Add New Hardware Wizard screen pops up, click Next.
2. Select Search for the best driver for your device. Click Next.
3. Clear all the selections and click Next.
Note: User may hang the phone on the wall like the following picture:
3. Application Installation
If you are using the USB phone simply as an audio input/output device in
combination with an instant communication software, e.g., Google Talk,
NetMeeting, MSN Messenger or Yahoo Messenger), you don’t need to install
any other software. Please ignore this chapter.
To use Skype with the USB phone in Windows 2000/XP, please follow the
instructions in this chapter to complete the installation.
Installing Skype Software
1. If Skype is not yet installed on your computer, please install the Skype
software from our CD or download Skype installation file from
www.skype.com.
2. Double-click the installation file you’ve downloaded and then follow the
on-screen prompts to complete the installation.
Installing the Phone Manager
Phone Manager is a tool that enables your USB phone to communicate with
Skype. You have to install the Phone Manager to allow the USB phone to
access Skype functionality.
1. Insert the provided Software Utility CD into your CD-ROM drive. Locate and
double-click the Setup.exe file in Software folder to launch the setup
program.
2. When the welcome screen appears, click Next.
3. Enter your information and click Next.
4. Select Complete and click Next.
5. Click Install to begin installation.
6. Click Finish to complete the installation.
7. When prompted to run the Phone Manager, click OK.
8. Select Allow this program to use Skype and click OK.
9. When the Phone Manager is launched, its icon will be displayed in the
system tray.
Allowing the Phone Manager to Use Skype
During the Phone Manager installation process, make sure to select Allow
this program to use Skype and click OK.
You can optionally select Allow this program to use Skype, but ask again in
the future option. But you should always let this program use Skype so
that you can use the USB phone.
Choose This Option
4. Using the USB Phone with Skype
Connecting the USB Phone
When the USB phone is connected to a powered on computer, the device will
start to connect to the installed Phone Manager. When the Phone Manager is
successfully connecting the phone to Skype, the Phone Manager icon in the
system tray will be changed, indicating the device is ready for use.
Icon in black and white color
when the Phone is not
plugged
Icon in Full color when the
Phone is plugged
When the “Linking…” message would disappear when the Phone commicae
with Phone Manager and softphone successfully.
V3.0.0.002.1
Linking...
○
s Skype
Specifying a Music Playback Device
When the USB phone is connected for the first time, Windows will reset its
audio settings to use the USB phone as the overall audio in/out device. In this
situation, you can manually specify a preferred music playback device, e.g.,
your sound card or USB speaker while at the same time still use the USB
phone as audio in/out device in Skype.
Inhaltsverzeichnis
Andere Acorp Telefon Handbücher
