10
“Disk N Detects a Bad Page!”: the SATA disk N has too many non-
recoverable bad sectors or has smart error state.
“Disk N Detects RAID sector Err!”: the SATA disk N has bad RAID
sector.
“Disk N Detects Signature Error!”: the SATA disk N replies the error
signature.
“Disk N Detects Read Page Error!”: the SATA disk N detects reading
error when system reads RAID information.
“Disk N Detects PIO Read Error!”: the SATA disk N detects reading error
when system executes PIO-read operation.
“Disk N Detects PIO Write Error!”: the SATA disk N detects writing error
when system executes PIO-write operation.
“Disk N Detects Read Log Error!”: the SATA disk N detects reading error
when system executes SMART-Read Log operation.
“Disk N Detects a Smart Error!”: the SATA disk N detects Smart Error.
5.3.2 Quick Setup Function set
The Quick Setup Function set is provided for easily and quickly
configuring RAID set by user. It contains two functions: Create One
RAID and Delete All RAID. The introduction is as follows:
Create One RAID: user can easily create a RAID from the existing disks
by this function. User only needs to select the created RAID level and
input the RAID password, and then a desired RAID set is configured.
However, if user doesn’t need RAID password, user can directly press the
‘Enter’key to bypass the RAID password stage and create a RAID set
without password.
Delete All RAID: user can easily delete all RAID sets in the existing
disks by this function. User only needs to input the RAID password of the
existing RAID sets, and then all the RAID sets will
be deleted. If there’s no password in the existing RAID set, user doesn’t
need to input the password. Besides if there are more than two existing
RAID sets with different passwords, user cannot delete these RAID sets
in this function. User can delete these RAID sets separately in RAID
Manager/Delete RAID function.
