The
ErgoReJoy
assessment kits are shipped in a custom box with each component labeled with part
numbers to facilitate installation. We recommend storing the 5” and 8” adjustable arms; double
ball adaptor; and
JoyPad™
with 3” extension arm in the sample case until required for use during
the assessment.
I. Install socket brackets (30380) (with pre-installed sockets 30200) to PWC armrest using
the Stealth universal round tube mounting brackets (refer to gure A). f the PWC’s
armrests do not have mounting slots for the brackets’ nuts, then it may be necessary to drill
and tap holes in the armrests’ pads brackets (refer to gure ). f the Stealth brackets are
not compatible with the PWC armrests, please call -00-- ext .
. nsert mini mast (0) in socket (000) (refer to gure a). Press down on the top of
the mini-mast to make sure it is fully inserted (refer to gure b).
. nstall PWC joystick to
ErgoReJoy
platform (00). efore removing joystick from PWC,
photograph a side view in its standard armrest position.
A. Remove joystick harness from controller joystick port located on the PWC base noting
its location
. Remove joystick and joystick mounting bracket from PWC.
C. Ret joysticks have two different joystick cable congurations
. f the Ret joystick has a removable harness, install the Active Controls joystick
harness (0) in place of the original harness
a. Route the 0 cable through the long slot of the
ErgoReJoy
platform (00)
. f the Ret joystick has a xed harness, route the harness through the long slot of the
joystick platform (00)
D. nstall Ret joysticks with xed harnesses and
R joysticks with M- screws in the front two
holes which are -” apart (see gure ) to
platform (00)
E. nstall Ret joysticks with removable harness in
the two rear holes which are ” apart
(see gure )
F. nstall -ogic , or , E, Shark joysticks
with two M- screws using the holes which are
-” apart (refer to gure )
Modular ERGOnomic REpositioning
JOYstick Platform Installation Instructions
figure 1a
figure 1B
figure 2a
figure 2B
