LC100
SAFETY
LC100 OPERATING MANUAL
Designated use
The LC100 is intended exclusively for cross cutting cables, litz wires, shrink sleeves and
similar profiles up to a diameter of 8 mm.
Only finely stranded copper litz wires up to 10 mm² and single-strand copper cables up
to max. 2.5 mm² may be used. On no account may steel wires or similar be used, as
these would destroy the cutting blade.
Dangers
The LC100 may only be used with the front door closed.
Unplug LC100 from power source before carrying out maintenance work.
Ensure that there are no foreign objects inside the housing.
Places for Use
Avoid operation in:
•Damp or dusty locations
•Location exposed to high or low temperatures or direct sunlight
(operating range: 15 °C to 35 °C).
Condensation can form following a change of location from a cold to a warm place.
Before using the LC100, open the front door and allow condensation to evaporate.
Do not spill any liquid onto the LC100.
Do not subject the LC100 to strong vibrations and impacts.
Safety Devices
The LC100 is switched off by:
•The main power switch (0 pressed, display and red LED).
•Removing main power plug
•Opening the front door (via safety switch).
The front door is installed for the user’s safety. Under no circumstances may it be
modified, removed or bypassed.
