AEG Competence 6292D-M Bedienungsanleitung

Operating and installation instructions

Competence 6292D-M

Chimney Hood

CONTENTS

1. GeneralInformation Page1

2. SafetyWarnings Page1

3.InstallationInstructions Page2

4. UseandMaintenanceInformation Page4

5. Troubleshooting Page6

6.Diagrams Page7

7.GuaranteeConditions Page11

General Information

Carefully read the following important information regarding installation, safety

and maintenance of your appliance. This appliance has been designed for use in

the venting mode (air exhaust to the outside – Fig.1B), recirculation mode (air

circulation on the inside – Fig.1A) or with venting mode with external motor

(Fig.1C). The cooker hood is designed to extract unpleasant odours from the

kitchen, it will not extract steam

Safety Warnings

 Always cover lighted elements, to prevent excess heat from damaging the

appliance. In the case of oil, gas and coal fired cookers it is essential to

avoid open flames

 Also, when frying, keep the deep frying pan on the cooker top under careful

control



It is extremely important to note that overheating can cause a fire

 Never carry out flambé cooking under the hood

 There must be adequate ventilation in the room when the range hood is

used at the same time as appliances burning gas or other fuels

 It is very important to clean the hood and replace the filter at the

recommended intervals. Failure to do so could cause grease deposits to

build up, resulting in a fire hazard

 Always disconnect the unit from the power supply before carrying out any

work on the hood, including replacing the light bulbs

 The appliance is not intended for use by young children

 Ensure that the appliance is switched off before replacing the lamp to avoid

possibility of electric shock

 Do not check the status of the filters while the cooker hood is operating

 Do not touch bulbs or adjacent areas, during or straight after prolonged use

of the lighting installation

Before connecting the model to the electricity network

Check the data plate (positioned inside the appliance) to ascertain that the voltage

and power correspond to the local electrical requirements. If in doubt contact a

qualified electrician.

Installation Instructions

Qualified technicians must carry out the installation and electrical connections of

the appliance. We recommend that you contact our customer care center on

0860 234 481/2/3 for details of a qualified technician.

For the installer

 The appliance has been manufactured as a class I, therefore earth cable is

necessary.

 The connection to the mains is carried out as follows:

BROWN = L line

BLUE = N neutral

Yellow and green wire =Earth lead

 The cooker hood must be installed so that that the plug is easily accessible.

 An omnipolar switch with a minimum aperture of 3mm between contacts, in

line with the electrical load and local standards, must be placed between

the appliance and the network in the case of direct connection to the

electrical network.

 The minimum distance between the support surfaces of the cooking pots on

the cooker top and the lowest part of the cooker hood must be at least 65

cm. If a connection flue composed of two parts is used, the upper part must

be placed inside the lower part.

 Do not connect the cooker hood exhaust to the same conductor used to

circulate hot air or for evacuating fumes from other appliances generated

by other than an electrical source.

 Before proceeding with the assembly operations, remove the anti-grease

filter(s) (Fig.11) so that the unit is easier to handle.

 In the case of assembly of the appliance in the venting version prepare the

hole for evacuation of the air.

Hood assembly

 Remove the structure from the packaging and separate the upper part from

the lower part.

 Refer to Fig.2 and ensure that the arrow is positioned on the same side as

the appliance controls. Make 4, Ø8 holes in the ceiling and drive in 3 screws

without completely tightening them.

 Do not insert the screw into the hole marked with an X on the hole template

(the screws and expansion plugs must be suitable for the type of wall).

 Take the upper part of the structure B and insert the 3 slots onto the 3

screws that are not completely tightened. (Fig3)

 Rotate slightly to fit.

 Drive in the fourth screw X and tighten the remaining 3 to allow definitive

blocking of the upper part of structure B.

 Take the lower part of the telescopic structure C and insert it into the upper

structure B.

 Adjust the height (Fig.5) by referring to the amounts indicated in and block

it using the 8 unit screws G that are supplied (Fig.4)

Venting version

 Fix the flexible pipe to the prepared air evacuation hole (Fig.6)

 Take the upper chimney piece and fix it with 4 unit screws G. (Fig.7)

 Take the lower chimney and fix it with 2 unit screws G, drive in hood to

avoid it down (Fig.8)

 Insert the venting unit inside the structure and set in 4 mounting hole, drive

in 4 unit screw N (Fig.9)

 Fix the air evacuation pipe H (not supplied) onto the connection flange

(Fig.10)

 Unscrew the 2 screws G and rest the lower chimney piece above the cooker

hood (Fig.11).

 If the cooker hood is supplied with a lower chimney piece that must be fixed

to the hood body with screws, remove the anti-grease filters from the hood

by acting on the relevant handles (Fig.12). Then screw the lower chimney

piece pipe to the inside of the hood, using screws P (Fig.13). Re-locate the

filters in their seat.

Use & Maintenance

 It is recommended to operate the appliance prior to cooking

 It is recommended to leave the appliance in operation for15 minutes after

cooking is terminated in order to completely eliminate cooking vapours and

odours

 The proper function of the cooker hood is conditioned by the regularity of

the maintenance operations, in particular, the active carbon filter

 The anti-grease filters capture the grease particles suspended in the air,

and are therefore subject to clogging according to the frequency of the use

of the appliance

 In order to prevent fire hazard, it is recommendable to clean the filter at a

maximum of 2 months by carrying out the following instructions:

- Remove the filters from the cooker hood and wash them in a solution

of water and neutral liquid detergent, leaving to soak.

- Rinse thoroughly with warm water and leave to dry.

- The filters may also be washed in the dishwasher.

 The aluminium panels may alter in colour after several washes. This is not

cause for customer complaint nor replacement of panels.

 The active carbon filters purify the air that is replaced in the environment.

 The carbon filters are neither washable nor reuseable and must be replaced

at maximum every four months.

 The saturation of the active carbon filter depends on the frequency of use

of the appliance, by the type of cooking and the regularity of cleaning the

anti-grease filters (Fig 14)

 To remove the charcoal filters place on hand on one filter at a time and turn

it toward the front part. The charcoal filter can now be removed. Always

ensure to replace both filters at the same time.

 Clean the fan and other surfaces of the cooker hood regularly using a damp

cloth moistened with denatured alcohol or non-abrasive liquid detergent.

 The illumination installation is designed for use during cooking and not for

prolonged general illumination of the environment. Prolonged use of the

illumination installation notably reduces the duration of the bulb.

 Use a one-edged screwdriver or any other appropriate tool to lift and

remove the overhead light fixture. Replace the damaged lamp. Use only

halogen lamps of a maximum of 20w, avoiding contact with hands. Return

the light fixture to its position (snap fastening). (Fig. 15)

Control Panel – Fig 16

A = TIMER – 15 MINUTES

B = SPEED I / OFF

C = SPEED II / OFF

D = SPEED III / OFF

E = LIGHT

If your appliance does not have the INTENSIVE speed function, press key A for

two seconds and it will be activated for 15 minutes after which it will return to the

previously set speed. When the function is active the LED flashes.

By pressing any key for the exclusion of the hood light the hood will return

immediately to its normal functioning.

The “automatic stop timer” delays stopping of the hood, which will continue

functioning for 15 minutes at the operating speed set at the time this function is

activated.

Troubleshooting

Problem Possible reason Solution

Check the plug is connectedHood doesn’t work No electric supply

Check the main switch is turned on

Aluminum grease filters

clogged

Clean the filters and replace when dryPoor airflow

Charcoal filters clogged Replace the charcoal filters

Motor running but no

air flow

Butterfly valve jammed Contact technician

High temperature safety

device activated

The kitchen is not sufficiently

ventilated

Motor cuts after a few

minutes

The hood is installed too

near the cooking stove

The hood must be least 65cm from

stove

Strong cooking smell Charcoal filters not

installed

In re-circulating mode, charcoal filters

must be installed

Oil cup missing or not

installed

Remove aluminum filter and replace oil

cup

Oil dripping onto stove

Aluminum grease filter

saturated

Wash the aluminum grease filters

Whirring sound Something in contact

with fan blade

Contact with technician

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR EVENTUAL

DAMAGES CAUSED BY BREACHING THE ABOVE WARNINGS.

Fig.1

Fig.2

Fig.3

Fig.4

Inhaltsverzeichnis

Andere AEG Dunstabzugshaube Handbücher

AEG

AEG DE 60 V Bedienungsanleitung

AEG

AEG 502 D Bedienungsanleitung

AEG

AEG 710 D Bedienungsanleitung

AEG

AEG X68163BV1 Bedienungsanleitung

AEG

AEG DVK6980HB Bedienungsanleitung

AEG

AEG DE 3161 Bedienungsanleitung

AEG

AEG DIK8190HG Bedienungsanleitung

AEG

AEG Perfekt Glide-24 Bedienungsanleitung

AEG

AEG X89384md02 Bedienungsanleitung

AEG

AEG DU 3150 Bedienungsanleitung

AEG

AEG X89384MD01 Bedienungsanleitung

AEG

AEG X66453MDO UK Bedienungsanleitung

AEG

AEG DTB3651M Bedienungsanleitung

AEG

AEG CHDD 8510 Bedienungsanleitung

AEG

AEG DGK6681HM Bedienungsanleitung

AEG

AEG DI7490-M Bedienungsanleitung

AEG

AEG DUB2621M Bedienungsanleitung

AEG

AEG X56133MT1 Bedienungsanleitung

AEG

AEG DVB5860B Bedienungsanleitung

AEG

AEG X91384MIO Bedienungsanleitung

AEG

AEG AWS6600GM Bedienungsanleitung

AEG

AEG CHDF 6260 Bedienungsanleitung

AEG

AEG DE 3160 Bedienungsanleitung

AEG

AEG DH 1690 Bedienungsanleitung

Beliebte Dunstabzugshaube Handbücher anderer Marken

emmeti

emmeti RECUPA MED A-140 Leitfaden

Nibe

Nibe F135 Bedienungsanleitung

Kuppersberg

Kuppersberg INTRO 60 Montage- und Wartungsanleitung

Zephyr

Zephyr Spruce AK9834BS Installationsanleitung

Hisense

Hisense MH6INBG Bedienungsanleitung

Miele

Miele DA 1255 Bedienungsanleitung

Broan

Broan 46000 Bedienungsanleitung

GE Profile PV977 Originalbetriebsanleitung

FALMEC

FALMEC FFRIA24W5FS Bedienungsanleitung

Whirlpool

Whirlpool RH2600XL-1 SERIES Bedienungsanleitung

Küppersbusch

Küppersbusch DX ISLA Bedienungsanleitung

ETNA

ETNA AV360RVS Bedienungsanleitung

JUNO

JUNO JDF603E6 Bedienungsanleitung

Miele

Miele DA 6708 D Bedienungsanleitung

Tricity Bendix

Tricity Bendix LE 150 Handbuch

Smeg

Smeg KSEV97X Bedienungsanleitung

Nibe

Nibe S Series Benutzerhandbuch

Caple

Caple CCH100 Handbuch