© Copyright Aero-Spa®, LLC 2017 P/N102757 rev B
Occasionally GFCI breakers will experience nuisance tripping.
This will shut off the power to the equipment. If this occurs,
press the “reset” button. If pressing the “reset” button does not
start the equipment, unplug the cycle timer and press the
“reset” button again. If the “reset” button does not “hold in”,
replace the GFCI breaker. If the button does “hold in”, plug the
generator power cord into the GFCI breaker and circumvent the
cycle timer. Press the “reset” button again. If the “reset” button
does not “hold in” replace the GFCI breaker. If the “reset”
button does “hold in” contact Aero-Spa, LLC.
Do not operate this equipment without a GFCI breaker installed.
Maintenance and Care
This product has no user serviceable parts. If service is
required, contact Aero-Spa, LLC. Attempts to service the ozone
generator will void the customer satisfaction policy, Limited
Warranty, and expose the user to electrical shock which may
cause severe injury or death.
Keep the area around the product free of leaves and other
debris. If debris enters the product through the air intake holes,
unplug the product and carefully remove the debris. Restart
product.
The diffuser stone can be cleaned with a 3% hydrogen
peroxide solution or muriatic acid.
Fill & Start-Up Recommendations
Our customers have been using the Aero-Pool system as the
primary water treatment process for years with limited harsh
chemicals. Because we cannot control how your pool is
used/maintained and according to the EPA we must
recommend maintaining at 2 PPM of an approved residual
sanitizer to minimize cross contamination of users.
