General safety information:
Safety information! If the
following information is not
observed, this can cause
injuries.
Read the pneumatic tool instructions
very carefully prior to commissioning.
All operators must be fully and
sufficiently informed on how to
operate pneumatic tools. Only
qualified and trained technicians are
allowed
to do servicing and repair work.
For the operation of impact drivers,
only impact sockets must be used.
Never use impact if the drive square
is worn or damaged. Prior to every
use, check that the drive square at
the impact sockets, the extensions
or the spindle of the impact driver is
not worn.
Make sure that the operator has a
solid and secure standing and
working position prior to using the
tool.
Prior to every use, check that the
torque is adjusted correctly. If the
torque is adjusted incorrectly, this
can cause uncontrollable tool
movements and the screw to
rupture.
Make sure prior to every start-up
that the reversible switch is in the
correct position.
Check the pneumatic hose and all
connections regularly for signs of
wear or damages.
Hold the tool on the handle only,
never on the hose.
Never exceed the recommended
maximum operating pressure (6.3
bar)
The tool is neither earthed not
electrically insulated. Never use the
tool where it could come into contact
with electricity.
It is advisable to disconnect the air
supply when replacing impact
sockets; the release must not be
actuated during this process.
When loosening screw connections,
make sure to have sufficient scope to
the back to prevent the guiding hand
from getting crushed.
If you notice any malfunctions or
irregular power prior to use, stop
using the tool immediately and
maintain or repair the tool.
Do not use overly long hoses to
prevent tripping hazards.
Read the compressor operating
manual and observe the safety
instructions for operating the
compressor.
ALWAYS use certified protective
goggles and hearing protection-
Take off watches, rings or similarly
interfering items. Loose clothing or
jewelry could get entangled in the air
compressor or the air device which
could cause severe injuries.
The trigger must not be operated
when the device is connected to the
air supply.
Disconnect the air supply from the
device when it is not used. NEVER
replace accessory parts and NEVER
execute maintenance work when the
device is connected to the air
supply.
Maintain the device thoroughly and
follow the instructions on greasing
and maintenance.
Do not damage the hoses and
connectors by carrying the device
holding the hose or disconnecting
the hose by tugging from the air
supply. Prevent the hose from being
exposed to heat or sharp edges.
The hose should be replaced if it is
damaged or worn.
NEVER operate the device with an
air pressure exceeding 6.3 bar. Use
a pressure regulator that reduces
the pressure to 6.3 bar.
Operate the device at a safe
distance from humans and animals
AT ALL TIMES.
Prior to start-up:
Air supply
Grease the device prior to operation
(see last page), we recommend to
use an oil-mist lubricator.
Assembly
Always disconnect the air-supply
hose before mounting/dismounting
impact sockets or attachments
to/from the device.
Safety information!
Wear protective goggles!
Wear hearing protection!
Make sure that only compressed air
free of condensate is used for
operation. It is sufficient to slot in a
water trap filter.
