AFINIA LABEL L801 Bedienungsanleitung
Installment 1796
Replacing Microfiber Roller:
Why do we do this?
Throughout the life expectancy of the printhead a lot of media comes in contact with printhead. This
media carries debris and other artifacts across the printhead which can get stuck and cause poor print
quality with time. The microfiber roller wipes the printhead down and absorbs residual ink left over from
past print jobs. Over time this microfiber roller becomes warped and needs to be changed.
Steps to follow:
•Replace microfiber roller
Equipment Needed:
•Nitrile Gloves
•Screw Driver - Eye Glass Repair Kit
•Piece of cardboard / Lint free cloth
Directions for Replacing Microfiber Roller:
Eject the service tray from the printer:
In order to access the setting to eject the service station –you will need to log on through the touch
panel. Enter “Configuration Mode”by selecting the gear found in the lower left hand corner of the touch
panel. Select “Setup”, while in “Setup”scroll down to “Security”and select “Level 2”. The operator will
be prompted to enter a password, the password is “123”. At this point in time after hitting enter you can
scroll through the “Configuration”menu to option 4 labeled as “Service Station”. Before ejecting the
service station lift up on the hood of the printer as well as the clamshell.
For additional support call the Vivid Data Group Support Team at 855-848-4332 and select Option 2
1
Installment 1796
Slide the Service Station out of the Service Station port. NOTE: Do not pull Station all the
way out until you disconnect the Ribbon Cable. Slide the Latch open on the Service Station
Circuit Board to release the Ribbon Cable. Remove the Service Station.
Figure 1. Ejecting service tray Figure2. Opening and closing ribbon cable
2
Installment 1796
After the service station has been disconnected from the ribbon cable and removed from the print
engine place the service station down on a piece of cardboard. The service station holds all of the
discarded ink from the printhead and funnels that ink down on to the ink wastepad.
Remove each of the following four compartments from the service tray:
•Micro-Fiber Roller (Yellow)
•Platen (Burgundy)
•Cap (Blue)
•PCB Chip (Red)
•Service Tray (Grey)
Figure 3. Overview of compartments contained in the service tray
3
Installment 1796
With these components accessible –isolate your Micro-Fiber Roller. Utilizing a small Phillip’s head screw
driver. Loosen, but do not remove the screws, holding the plastic locking clips on the left and right side
of the Micro-Fiber Roller in place. After loosening these screws enough, the plastic locking clips should
release.
Figure 4. Loosening screws & unlocking latches holding Micro-Fiber Roller in place
After loosening the screws up and unlocking the plastic latches the Micro-Fiber Roller is accessible.
Remove the used Micro-Fiber Roller install the new Roller after locking the plastic latches back in place
and fasten the screws down.
Final Directions:
At this time the you have completed replacing the Micro-Fiber Roller. Assemble the service station
components back in the correct order. All that is left to do is connect the ribbon cable and return
the service tray back to the print engine.
4
Inhaltsverzeichnis
Andere AFINIA LABEL Drucker Handbücher
