Agema Delta AGV424 Bedienungsanleitung
Delta Networking – Agema Family
AGV424 ToR/Leaf Switch
agema.deltaww.com
Installation Guide
ii
AGV424 ToR/Leaf Switch
Copyright
All specications and gures are subject to change without prior notice. Actual products may look
dierent from the photos.
All trademarks and logos mentioned in this guide are the properties of their respective holders.
Copyright © Delta Electronics, Inc. All rights reserved.
Regulatory and Safety Information
This product has been tested in accordance to, and complies with the following safety standards and
electromagnetic compatibility (EMC) inspection standards.
Emissions
Applicable standard
• AS/NZS CISPR 32: Class A
• ICES-003
• EN55032: Class A
• VCCI Class A
• FCC CFR 47 Part 15, Subpart B Class A
Safety
Applicable standard
• EN 60950-1, Second Edition
• UL 60950-1, Second Edition
• CAN/CSA C22.2 No. 60950-1-07, Second Edition
• IEC 60950-1, Second Edition Including All National
Immunity
Applicable standard
• EN 55024
• EN 61000-3-2: Harmonic Current Emissions
• EN 61000-3-3: Voltage Fluctuations and Flicker
• EN 61000-4-2: ESD
• EN 61000-4-3: Radiated Immunity
• EN 61000-4-4: EFT
• EN 61000-4-5: Surge
• EN 61000-4-6: Low Frequency Conducted Immunity
• EN61000-4-8: Power Frequency magnetic eld
• EN61000-4-11: Voltage dips and interruption
EU RoHS Compliant
Applicable standard All AG-Series components are EU RoHS compliant
iii
Warning: Fiber Optic Port Safety
When using a ber optic port, never look at the transmit laser while it is powered
on. Also, never look directly at the ber TX port and ber cable ends when they are
powered on.
Avertissement : Consignes de sécurité concernant le port de fibre optique
Ne regardez jamais le faisceau de laser émis activé lorsque vous utilisez un port de
bre optique. Également, ne regardez jamais le port de bre TX et les extrémités du
câble du bre directement lorsqu’ils sont activés.
CAUTION
Lithium Battery Caution
Danger of explosion if battery is incorrectly replaced. Replace only with same or equivalent type.
Dispose batteries according to manufacturer’s instructions.
Disposal of a BATTERY into re or a hot oven, or mechanically crushing or cutting of a BATTERY, that
can result in an EXPLOSION.
Leaving a BATTERY in an extremely high temperature surrounding environment that can result in an
EXPLOSION or the leakage of ammable liquid or gas.
A BATTERY subjected to extremely low air pressure that may result in an EXPLOSION or the leakage
of ammable liquid or gas.
Grounding Caution
This equipment must be grounded and the power cord for product should be connected to a socket-
outlet with earthing connection.
MISE EN GARDE
Mise en garde concernant la pile au lithium
Risque d’explosion si la pile est remplacée incorrectement. Remplacez-la avec une pile semblable ou
de même type uniquement. Éliminez les piles selon les directives du fabricant.
L’élimination de la PILE dans un feu, un four chaud ou un broyeur mécanique peut provoquer une
EXPLOSION.
L’exposition de la PILE à une température ambiante extrêmement élevée peut provoquer une
EXPLOSION ou la fuite d’un liquide ou d’un gaz inammable.
L’exposition de la PILE à une pression atmosphérique extrêmement basse peut provoquer une
EXPLOSION ou la fuite d’un liquide ou d’un gaz inammable.
Mise en garde concernant la mise en terre
Cet équipement doit être mis à terre et le cordon d’alimentation du produit doit être branché à une
prise mise à terre.
iv
AGV424 ToR/Leaf Switch
Table of Contents
Chapter 1: Introduction -------------------------------------------------------------------1
1.1 Overview ------------------------------------------------------------------------------------ 1
1.2 Package Content ------------------------------------------------------------------------- 1
1.3 Features------------------------------------------------------------------------------------- 2
Chapter 2: Appearance and Mechanism --------------------------------------------3
2.1 Product Overview ------------------------------------------------------------------------- 3
2.2 LED Identication ------------------------------------------------------------------------- 4
2.3 System Requirements ------------------------------------------------------------------- 6
2.4 Data Center Deployment --------------------------------------------------------------- 7
2.5 Internal Power Supply ------------------------------------------------------------------- 7
2.6 Internal System Fan --------------------------------------------------------------------- 8
Chapter 3: Installation ---------------------------------------------------------------------9
3.1 Rack Mounting ---------------------------------------------------------------------------- 9
3.2 Installing an Optional Transceiver and Cable ------------------------------------12
3.3 Connecting to the Console Port ------------------------------------------------------13
3.4 Connecting to a Power Source -------------------------------------------------------14
Chapter 4: Making the Network Connections ----------------------------------- 15
4.1 Twisted-pair Connections --------------------------------------------------------------15
4.2 Fiber Optic Connections ---------------------------------------------------------------16
4.3 Ethernet Cabling -------------------------------------------------------------------------17
Appendix 1 : Technical Specifications--------------------------------------------- 18
Appendix 2 : Warranty------------------------------------------------------------------- 19
Limited and Support Warranty -------------------------------------------------------------19
Technical Support -----------------------------------------------------------------------------19
1
Chapter 1: Introduction
1.1 Overview
The AGV424 is the next generation leaf switch for Data Center Networks, as well as for
common Enterprise Aggregation network deployments.
It leverages the 100G technology (4x25G Serdes) to oers 24-port 25G SFP28 and 4-port
100G QSFP28 in a compact form factor of 1U chassis height and half width. 2.5 times speed
upgrade from current 10G leaf switch. The 24ports 25G are backward compatible to 10G and
the 100G uplink oer dual speed – 40G and 100G. Total I/O bandwidth upgrade to 1Tbps and
switch also provide customers x86 CPU as modular design which oers the exibility for CPU
solution.
1.2 Package Content
After unpacking this switch, check the contents to be sure you have received all the
components. Then, before beginning the installation, be sure you have all other necessary
installation equipment.
•The AGV424 switch
•AC power cords
•Installation guide
If any item is missing or damaged, contact the vendor immediately, see “Technical Support”.
2
AGV424 ToR/Leaf Switch
1.3 Features
The following lists the key main features of AGV424 switch:
•24x 25G SFP28 ports, support 10G/25G speeds and 4x 100G QSFP28 ports, support
10G/25G speed by fanout cable, and also supports 40G QSFP transceiver
•1 x RJ45 OOB management port
•1 x RJ45 Console port
•1 x Type A USB port
•System / Fan / Power status LED indication and per port LEDs
•On board high performance CPU system with high density memory
•Support Jumbo Frame up to 12KB
•2 x Non-pluggable 300 Watts AC Power Supply
•Standard 1U chassis height and half width
•1 Tbps switching bandwidth
•Automatic address learning function to build the packet-forwarding information table. The
table contains up to 288K MAC addresses
•Low pin-to-pin latency: Cut-Through & Store and Forward Mode
•32MB of packet buer memory
3
Chapter 2: Appearance and Mechanism
2.1 Product Overview
2.1.1 Front View
SFP28 ports x 24
QSFP28 ports x 4
RJ-45 Console
port x 1
USB port x 1
Management
port x 1
(Figure 2-1: Front View)
2.1.2 Rear View
Redundant PSU Redundant PSU
(Figure 2-2: Rear View)
4
AGV424 ToR/Leaf Switch
2.2 LED Identification
This section provides an overview of the front LEDs.
2.2.1 Front LEDs
Fan LED
System LED
Upper QSFP28 Port LED
Lower QSFP28 Port LED
Lower SFP28
Port LED
Power 1 LED
Power 2 LED
Middle SFP28
Port LED
Upper SFP28
Port LED OOB Port LED
(Figure 2-3: Front LED Identification)
LED Description
System LED
• Solid Green – Normal operation
• Blinking Green – Booting progress
• Solid Amber – I/O Port Module Fault
• Blinking Amber – CPU Hang, System over current, or System over Voltage
• Off – No Power
Power 1 LED
• Solid Green – Power supply 1 operating normally
• Solid Amber – Power supply 1 failed
• Off – Power is disconnected
Power 2 LED
• Solid Green – Power supply 2 operating normally
• Solid Amber – Power supply 2 failed
• Off – Power is disconnected
Fan LED • Solid Green – All fans are operating normally
• Solid Amber – One fan or more failed
25G SFP28
Slots
• Solid Blue – A valid link 25G link
• Solid Purple – A valid link 1G/10G link
• Blinking – Packet transmission or reception in progress
• Off – No Link
• Appearance and MechanismChapter 2
5
LED Description
100G QSFP28
Slots
LED1 (Solid Lighting – Linkup; Blinking – Activity)
• Solid Green – 100G Operation
• Solid White – 50G Operation
• Solid Amber – 40G Operation
• Solid Blue – 25G Operation
• Solid Purple – 1/10G Operation
• Off – No Link
LED 2 (Solid Lighting – Linkup; Blinking – Activity)
• Solid Blue – 25G Operation
• Solid Purple – 1/10G Operation
• Off – No link
LED3 (Solid Lighting – Linkup; Blinking – Activity)
• Solid White – 50G Operation
• Solid Blue – 25G Operation
• Solid Purple – 1/10G Operation
• Off – No Link
LED 4 (Solid Lighting – Linkup; Blinking – Activity)
• Solid Blue – 25G Operation
• Solid Purple – 1/10G Operation
• Off – No link
OOB Port
Link LED (On the Left Side)
• Solid Green – A valid link at 1000Mbps
• Solid Yellow – A valid link at 10/100Mbp
• Off – No link is established on the port
Act LED (On the Right Side)
• Blinking – Activity, transmitting or receiving packet at this port
• Off – No link is established on the port
6
AGV424 ToR/Leaf Switch
2.3 System Requirements
Component Requirement
System Requirements
Switch Fabric Capacity 1Tbps on all packet sizes
Forwarding Architecture Store and Forward or Cut-through
Port Packet Forwarding
Rate (at 64 Bytes)
• 148,800,000 pps (100Gb)
• 59,520,000 pps (40GbE)
• 14,880,000 pps (10Gb)
MAC Address Entries
Supported Up to 288K entries
Memory Type 32MB buer memory
OOB Port 10/100/1000Mbps, auto sensing, auto negotiation
BMC Port 10/100/1000Mbps, auto sensing, auto negotiation
Priority Queues 96K virtual queues for system
MAC Address Aging
Support
• 10 ~ 1,000,000 seconds programmable
• Default 300 seconds
Serial Console • Provide visual feedback of the boot process to the user
• Timeout after period of inactivity
Spanning Tree Support
• Support IEEE802.1d STP
• Support IEEE802.1s MSTP
• Support IEEE802.1w RSTP
L3 Hosts IPv4 up to 168K; IPv6 up to 100K
L3 LPM
• w/o uRPF: IPv4 up to 324K; IPv6/64 up to 168K; IPv6/128 up to
40K
• w/ uRFP: IPv4 up to 128K; IPv6/64 up to 40K; IPv6/128 up to 10K
• T-CAM-only: IPv4 up to 32K; IPv6/64 up to 16K; IPv6/128 up to 8K
L3 Multicast 16K
Port Trunking IEEE802.3ad Link Aggregation Protocol (LACP)
Port Requirements
Speed Capability per Port
• 1G/10G/25Gbps (SFP28 port)
• 40G/100Gbps (QSFP28 port)
• 10G/25G/50Gbps (QSFP28 port, working in breakout cable)
Full-Duplex Flow Control Support the IEEE 802.3x PAUSE frame
Inhaltsverzeichnis
Andere Agema Schalten Handbücher
