N.B. This equipment must be installed by a competent installer/technician.
1. ASSEMBLY
Your trolley is supplied to you packed in cube
form. lease examine all components for any
damage before use. If you see any damage or
suspect a fault, please contact your supplier
immediately.
In this case, please do not use your product as it
may compromise the safety of the user.
The package contains the following components;
Main trolley body
4 x height adjustable legs with pin clips
2 x detachable arms
2 x clip on moulded table tops
Please read and follow the instructions carefully
1.1 Remove all the contents from the box
1.2 Ensure that you protect the paintwork of the trolley during assembly by placing the trolley on a
carpet or a large sheet of cardboard.
1.3 Take the trolley frame and place it upside down and carefully insert the tapered section of the
brown painted leg assembly into the body of the trolley frame.
1.4 Insert the leg retention clip. Ensure that the retention clip passes all the way through.
1.5 Ensure that all four extension legs are adjusted to the same height and then turn the fram upright.
1.6 Test the trolley for stability thoroughly and visually check that all four leg retention clips are in
place.
Do not use the leg retention clips to adjust the trolley height.
1.7 lace the two detachable arms into the locating holes with the higher part of the arms towards
the front of the trolley.
N.B Ensure both arms are fully located in place and the four
brass buttons are passed completely through the frame: they
should protrude approximately 5mm out from the main frame
1.8 Clip on both trolley trays with the flared edge towards the
front of the trolley.
Your completed trolley should now look like the image on the
right.
AIDAP BA HROOMS L D. Lancots Lane, Sutton Oak, St. Helens WA9 3EX
