STEP 2. Connect the plug to the main power switch.
STEP 3. Select desired ice cube size by pressing 'SELECT'
Note: Select the (S) when ambient temperature is below 15°c. When the ambient
temperature is higher than 30°C, large ice cube sizes are recommended.
STEP 4. Press 'START' button to switch unit on. The ice maker begins to work.
STEP 5. If indicator 'DEFICIENT' is red accompanied with a beeping noise, take out the basket then add water
as per step 1.
STEP 6. If indicator 'ICEFULL' is in red with a beeping noise, scoop out the ice.
Note: When the ice collecting tray is full, remove the ice immediately. Do not allow
the ice collecting tray to overfill.
You must press 'STOP'then the 'START'button to restart the Ice Maker after you add water
or remove some of the ice.
STEP 7. Press 'STOP' button to stop the machine.
STEP 8. Remove the drain plug to drain remaining water from the water reservoir. Screw the drain plug back in
place after the water has been drained.
CARE AND MAINTENANCE
Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently. When cleaning,
unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside
and outside surface of the Ice Maker. Do not spray Ice Maker with chemicals or other diluted cleaning
agents. Rinse thoroughly before starting.
Keep ventilation openings in the appliance enclosure or in the built-in structure clear of obstruction. Do not use
any mechanical device or other means to accelerate the defrosting process.
If the Ice Maker is reused after a long time in storage, the water pump may not pump sufficient water due
to an air block (the deficient water indicator switches on in this case). To correct this, press the START
button again. The Ice Maker will then work normally.
To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced every 24
hours.
If the compressor stops for reasons such as water shortage, too much ice, the appliance switched off, etc.,
do not restart the system right away. Wait 3 minutes before restarting the Ice Maker.
Always use fresh water before starting ice production either at initial installation or after a long shut-off
period.
TROUBLESHOOTING
1. Please note, if a power failure occurs due to disconnection of the power cord or the off power button has
been pushed accidentally during an ice-making cycle, small ice chips may form and lodge in the automatic
shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the power cord and
gently pushing the shovel to the rear of the cabinet and removing the ice chips then restarting the appliance.
2. Restart the ice maker by pressing Stop and then Start. If the ice shovel does not push the ice into the ice
collector, check to see if the water tray is horizontal or balanced. If not then adjust by pressing the ice shovel
lightly with your finger. Then restart the Ice Maker.
