Akai TEM-35CHSABH Bedienungsanleitung

After Sales Support

TEL: 1300 886 649

Reverse cycle Split

System Air Conditioner

Instruction manual

Model Number TEM-35CHSABH

N13275

PROTECT YOUR WARRANTY

This unit must be installed by a registered,

licensed installer as required by

Government regulations.

FOR THE USER

After Sales Support 1300 886 649

Contents

2 Safety rules and recommendations for the installer

3 Safety rules and recommendations for the user

5 Safety rules and prohibitions

6 Parts list

7 Indoor unit display

8 Emergency function and Auto-Restart function

9 Remote control and remote control display

10 Preliminary instructions How to insert the batteries

DIP switch on position function

11 Modes of operation Swing control of the air ow

13 Cooling mode

Heating mode

14 Timer mode - Timer ON

Timer mode - Timer OFF

15 Fan mode

Dry mode

16 Feel mode

Sleep mode

17 Protection

After Sales Support 1300 886 649

• Read this guide before installing and using the appliance.

• During the installation of the indoor and outdoor units, access to

the working area should be forbidden to children.

Unforeseeable accidents could happen.

Make sure that the base of the outdoor unit is rmly xed.

• Check that air cannot enter the refrigerant system and check for refrigerant

leaks when moving the air conditioner.

• Carry out a test cycle after installing the air conditioner and record the

operating data.

•The ratings of the fuse installed in the built in control unit are 3.15A / 250V

for 220V type and 3.15A/125V for 110V type.

• The user must protect the indoor unit with a fuse of suitable capacity for

the maximum input current or with another overload protection device.

• Ensure that the mains voltage corresponds to that stamped on the rating

plate. Keep the switch or power plug clean. Insert the power plug correctly

and rmly into the socket, thereby avoiding the risk of electric shock or re

due to insucient contact.

• Check that the socket is suitable for the plug, otherwise have the socket

changed.

• Do not install the appliance at a distance of less than 50cm from

inammable substances (alcohol, etc.). Or from pressurised containers

(e.g. spray cans).

• If the appliance is used in areas without the possibility of ventilation,

precautions must be taken to prevent any leaks of refrigerant gas

from remaining in the environment and creating a danger of re.

• The packaging materials are recyclable and should be disposed of in the

separate waste bins. Take the air conditioner at the end of its

useful life to a special waste collection centre for disposal.

• Only use the air conditioner as instructed in this booklet. These

instructions are not intended to cover every possible condition and

situation. As with any electrical household appliance, common sense and

caution are therefore always recommended for installation, operation and

maintenance.

• The appliance must be installed in accordance with applicable national

regulations.

• Before accessing the terminals, all the power circuits must be disconnected

from the power supply.

Safety rules and recommendations for the installer

After Sales Support 1300 886 649

Safety rules and recommendations for the user

• Do not try to install the conditioner alone; always contact specialised

technical personnel.

• Cleaning and maintenance must be carried out by specialised technical

personnel. In any case disconnect the appliance from the mains electricity

supply before carrying out any cleaning

or maintenance.

• Ensure that the mains voltage corresponds to that stamped on the rating

plate. Keep the switch or power plug clean. Insert the power plug correctly

and rmly into the socket, thereby avoiding the risk of electric shock or re

due to insucient contact.

• Do not pull out the plug to switch o the appliance when it is in operation,

since this could create a spark and cause a re, etc.

• Never remain directly exposed to the ow of cold air for a long time. The

direct and prolonged exposition to cold air could be dangerous

for your health. Particular care should be taken in the rooms where there

are children, old or sick people.

• If the appliance gives o smoke or there is a smell of burning, immediately

cut o the power supply and contact the Service Centre.

• Have repairs carried out only by an authorised Service Centre of the

manufacturer. Incorrect repair could expose the user to the risk

of electric shock, etc. The prolonged use of the device in such

conditions could cause re or electrocution.

• This appliance has been made for air conditioning domestic environments

and must not be used for any other purpose, such as for drying clothes,

cooling food, etc.

• The packaging materials are recyclable and should be disposed of in the

separate waste bins . Take the air conditioner at the end of its

useful life to a special waste collection centre for disposal.

• Always use the appliance with the air lter mounted. The use of the

conditioner without air lter could cause an excessive accumulation

of dust or waste on the inner parts of the device with possible subsequent

failures.

• The user is responsible for having the appliance installed by a qualied

technician, who must check that it is earthed in accordance with current

legislation and insert a thermomagnetic circuit breaker.

After Sales Support 1300 886 649

• Unhook the automatic switch if you foresee not to use the device for a

long time. The airow direction must be properly adjusted.

• The aps must be directed downwards in the heating mode and upwards

in the cooling mode.

• Only use the air conditioner as instructed in this booklet. These

instructions are not intended to cover every possible condition and

situation. As with any electrical household appliance, common sense and

caution are therefore always recommended for installation, operation and

maintenance.

• Ensure that the appliance is disconnected from the power supply when

it will remain inoperative for a long period and before carrying out any

cleaning or maintenance.

• Selecting the most suitable temperature can prevent damage to the

appliance.

After Sales Support 1300 886 649

Safety rules and prohibitions

• Do not bend, tug or compress the power cord as this could damage it.

Electrical shocks or re are usually due to a damaged power cord.

Only specialised technical personnel must replace a damaged power cord.

• Do not use extensions or gang modules.

• Do not touch the appliance when barefoot or parts of the body are wet or

damp.

• Do not obstruct the air inlet or outlet of the indoor or the outdoor unit.

The obstruction of these openings causes a reduction in the operative

eciency of the conditioner with possible consequent failures or

damages.

• In no way alter the characteristics of the appliance.

• Do not install the appliance in environments where the air could contain

gas, oil or sulphur or near sources of heat.

• This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience

and knowledge, unless they have been given supervision or instruction

concerning use of the appliance by a person responsible for their safety.

• Do not climb onto or place any heavy or hot objects on top of the

appliance.

• Do not leave windows or doors open for long when the air conditioner is

operating.

• Do not direct the airow onto plants or animals.

• A long direct exposition to the ow of cold air of the conditioner could

have negative eects on plants and animals.

• Do not put the conditioner in contact with water. The electrical insulation

could be damaged and thus causing electrocution.

• Do not climb onto or place any objects on the outdoor unit.

• Never insert a stick or similar object into the appliance.

It could cause injury.

• Children should be supervised to ensure that they do not play with the

appliance. If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualied persons in order to

avoid a hazard.

After Sales Support 1300 886 649

NOTE: The above gures are only intended to be a simple diagram of the appliance and may

not correspond to the appearance of the units that have been purchased.

Indoor Unit

1 Front panel

2 Air lter

3Optional lter (if installed)

4 LED Display

5 Signal receiver

6 Terminal block cover

7Ionizer generator (if installed)

8 Deectors

9 Emergency button

10 Indoor unit rating label

11 Airow direction aps

12 Remote control

Outdoor Unit

13 Air outlet grille

14 Outdoor unit rating label

15 Cover

16 gas valve

17 liquid valve

WALL AIR-CONDITIONER

• The conditioner is made up of two or more units connected between themselves

through copper pipes (properly insulated) and an electrical connecting cable.

• The indoor unit is installed on the walls of the room to be conditioned.

• The outdoor unit is installed on the oor or on the wall on suitable brackets.

• Technical data of the air conditioner are printed on the labels placed on the indoor

and outdoor units.

• The remote control has been designed for an easy and fast use.

12-3

4-5

11 8

10 7

DISPL AY HEAL TH Y

ON/OFF

SWING

FAN

TIMERSUPER

SLEEP MODE

ECO

CLOCK

Parts list

After Sales Support 1300 886 649

12 345

124 5

Indoor unit display

No. Led Function

1 POWER Shows that the unit is powered

2 SLEEP SLEEP mode

3 Temperature display

(if present)

Indicates the set temperature in C° or F°

4 TIMER TIMER mode

5 RUN Unit working

The shape and position of switches and indicators may vary according to

the model, but their function is the same.

After Sales Support 1300 886 649

Auto-restart function

The appliance is preset to auto-restart

function by manufacturer. With this

function, the air conditioner can keep

the selected settings after a blackout

or a voltage drop.

To deactivate the AUTO-RESTART

function, proceed as follows:

1. Switch the air conditioner o and

remove the plug.

2. Press the emergency button

meanwhile plug it in.

3. Keep pressing the emergency button

for more than 10 seconds until you

hear four short beeps from the unit.

The AUTO-RESTART function is o.

To activate the AUTO-RESTART

function, follow the same procedure

until you hear three short beeps from

the unit.

Emergency function

If the remote control is lost, proceed as

follows:

Lift the unit’s front panel to reach the

emergency button of the air conditioner

1. If you press the button once (one

beep), the air conditioner will work in

forced cooling function.

2. If you press the button twice (two

beeps), the unit will work in forced

heating function.

3. To switch o the unit , you just need

to press the button again (a single

long beep). After 30 minutes in forced

function, the air conditioner will

automatically start working in FEEL

mode. The FEEL function is described in

page 18.

ON / OFF

POWER

SLEEP

TIMER

RUN

display PCB

front panel

The emergency button in some models

could be on the right part of the unit

under the front panel.

The shape and position of the emergency

button may vary according to the model,

but their function is the same.

NOTE: The external static pressure of the

heat pumps is 0Pa for all models.

ON/OFF

Emergency function and Auto-Restart function

After Sales Support 1300 886 649

1temp up Increase the temperature or time

by 1 unit

2temp down Decrease the temperature or time

by 1 unit

3ON/OFF To switch the conditioner ON and OFF

4FAN To select the fan speed

5 TIMER To set automatic switching ON/OFF

6 SLEEP To activate the SLEEP function

7 MODE To select the mode of operation

8 SWING To control the deectors

1 FEEL mode indicator

2 COOLING indicator

3Dehumidifying indicator

4 Fan only operation indicator

5 Heating indicator

6 Signal reception

7 Timer OFF indicator

8 Timer ON indicator

9 Auto fan indicator

10 Low fan speed indicator

11 Medium fan speed indicator

12 High fan speed indicator

13 SLEEP indicator

14 Deector SWING indicator

Remote control

Remote control display

NOTE: The unit conrms the correct reception of each press button with a beep.

Inhaltsverzeichnis

Andere Akai Klimaanlage Handbücher

Akai

Akai AUS-12H53R150P9 Bedienungsanleitung

Akai

Akai AK-9000WIFI Bedienungsanleitung

Akai

Akai MWF-18CRN1-QC1G Bedienungsanleitung

Akai

Akai AK-9000-F Bedienungsanleitung

Akai

Akai AK-9000-RC Bedienungsanleitung

Akai

Akai AK-12000-RC Bedienungsanleitung

Akai

Akai MWF-18CRN1-QC1G Bedienungsanleitung

Akai

Akai AK-T70R32 Bedienungsanleitung

Akai

Akai AK-T35R32 Bedienungsanleitung

Akai

Akai AK-9000WIFI Bedienungsanleitung

Akai

Akai MISTRAL912Dual-R32-K Bedienungsanleitung

Akai

Akai AC-ZP112 Bedienungsanleitung

Akai

Akai AK-9000-RC Bedienungsanleitung

Akai

Akai AUS-12H53R150P9 Bedienungsanleitung

Akai

Akai TAK-9000-25 Bedienungsanleitung

Akai

Akai AK-T51R32 Bedienungsanleitung

Akai

Akai AK-T25R32 Bedienungsanleitung

Beliebte Klimaanlage Handbücher anderer Marken

Panasonic

Panasonic CS-E12HKEW Bedienungsanleitung

nedis

nedis ACMB1WT7 Bedienungsanleitung

Daikin

Daikin FCFV50A Bedienungsanleitung

Fujitsu

Fujitsu Inverter ASBA30JFC Bedienungsanleitung

Toshiba

Toshiba RAS-M10SMUV-E Bedienungsanleitung

Daikin

Daikin FXLQ20MAVE Bedienungsanleitung

CIAT

CIAT Magister 2 Series Leitfaden

Bestron

Bestron AAC6000 Bedienungsanleitung

Frigidaire

Frigidaire FFRE0533S1E0 Bedienungsanleitung

Samsung

Samsung AS09HM3N Bedienungsanleitung

Frigidaire

Frigidaire CRA073PU11 Betriebsanleitung

Soleus Air

Soleus Air GB-PAC-08E4 Bedienungsanleitung

McQuay

McQuay MCK020A Bedienungsanleitung

Webasto

Webasto Frigo Top 25 DS Bedienungsanleitung

Frigidaire

Frigidaire FAZ12ES2A Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric MSC-GE20VB Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric PLA-M100EA Bedienungsanleitung

Daikin

Daikin Split Sensira R32 Bedienungsanleitung