10 AFTER SALES SUPPORT
www.aquarius-service.com 00800-36 46 36 00
MODEL: 9163901 PRODUCT CODE: 91500 08/2014 Hotline free
AFTER SALES SUPPORT 11
00800-36 46 36 00 www.aquarius-service.com
Hotline free MODEL: 9163901 PRODUCT CODE: 91500 08/2014
1. Place the battery charger on a level surface.
2. Insert the wall power supply into an easily accessible socket.
3. Place the device onto the charging station. During the charging
process, the red LED is lit continuously. If the charging is completed,
the red LED switches off and the green LED lights up. After removing
the wall power supply or taking the device off the charging station,
the green LED switches off. The operating time with fullycharged
batteries is approximately 60 minutes.
06. Operation
NOTES:
• The hair to be cut must be dry.
• The cutting length may deviate depending on the cutting angle.
• First, start with a comb attachment with a longer cutting length
and then, in the course of the cutting process, use shorter cutting
lengths step by step.
Regardless of the state of battery charging, the device may be used
with mains operation at any time.
1. In order to use the device with mains operation, ensure that the
device is switched off.
2. If necessary, pull out the wall plug transformer cable from the
charging station and connect the wall power supply to the device.
3. Insert the wall power supply into an easily accessible socket.
4. Use the on/off switch to switch on the device.
Using the switch lock
This function prevents the unintentional switching on of the device
during transportation. For switching the device on/off, the switch D
must be turned to position π(ready for operation) or øLOCK (locked).
05. Charging
Connect charging station:
• An oval recess for the connection line of the wall plug transformer
is located on the bottom side of the charging station at the back edge.
• A round opening is located at the front edge of the charging station.
It is covered by a latch on the bottom side ➀for fixing the connector
socket of the wall power supply.
1. Move latch towards side ➁, guide the cable of the connector line
through the oval recess at the edge, and plug the connector
socket through the round opening ➂, so that the socket protrudes
through the mounting into the charging station.
2. Move back latch to secure socket ➃.
➀➁➂➃
Charge rechargeable batteries:
CAUTION! Risk of material damage
• Please note that the battery capacity will decrease during
extended periods of storage.
For this reason, long recharging times should be avoided because of
the interruption between the charging and discharging cycles.
NOTES:
• Prior to the first use (without cable), charge the device for approx.
12 hours.
• With regular use, it takes approximately 8 hours to fully charge the
batteries.
• The red LED flashes, if the battery performance is too low.
