UH1118 P162B PIR Mobility Detection Handbook page 3 of 9 UH1118 P162B PIR Mobility Detection Handbook page 3 of 9
Installation
Location:
ŸThe unit has a horizontal window covering approximately 1.5 meters (the
length of a bed) from a distance of 1.5 meters. It also has a narrow vertical win-
dow (±20 cm from the base) at this point. Hence if positioned on the floor
pointing at a bedside, at a distance of 1.5-2.5m, it will detect feet descending to
the floor, while being immune to body movement in bed. This makes it ideal
for monitoring bed vacation,
ŸIf positioned on furniture or wall mounted using the bracket supplied, at a
height of approx. 50 cm above the bed height with a clear view of the bed, it
will detect someone sitting up while being immune to normal movement
around the bed.
ŸIf positioned viewing a door or on a corridor wall at body height it will operate
when someone comes into view, but can be immune to pets etc at floor height.
The range is up to 5 metres.
ŸIt can also be mounted centrally above a door, pointing down. It will then
alarm if someone passes through the doorway., but not if they are further away
than a typical door mat.
To ensure reliable operation it is essential to ensure that there are no sources of
rapid heat change within the viewed area. Such sources could be radiators,
windows, dangling decorations, bathroom doors
Securing
The bracket supplied should be used to secure the main unit to a wall or other fix-
ture. Screws and wall plugs are supplied
Pairing the Keyfob
After first enabling the battery power, or following battery replacement, the
supplied keyfob has to be paired with the main unit by pressing ARM while
pointed at the front. The red led should flash and pairing is complete.
Range Test
It is most important to check that the alarm signal will reach all the places where
the pager will be used. This is easiest achieved by temporarily setting the unit into
Securelink mode (see p 7) and taking the pager to the extremities of the building.
The message NEW! 0189 (or similar) should appear every 10 seconds to show that
the radio link is functioning
Securelink Mode
In health critical applications it is advisable to use the radio in secure mode (see p
7). This will shorten the battery life but ensure that any failure of equipment or ra-
dio path is reported
