QUICK REFERENCE COME2ASCOS AND COME2ASCOS BLUE
9
The configuration dialog shown in figure 3 will appear. Here you can enter
your individual configuration settings. The meaning of the items will be
explained in detail below.
SERIAL INTERFACE
As long as it is not necessary to change the baud rate, leave it at 9 00
baud, which is approved and common for correction data transmission.
CONNECTION TYPE
By this radio button you make the general choice, if the connection is built
up modem-to-modem via GSM whether a GPRS internet connection is
used. Accordingly the dialog mask for both connection types differs.
GPRS SETTINGS (GPRS)
Provider dependant parameters for the internet access are specified in this
field. A pre-selection of the mostly used providers in Germany can be
accessed by the drop-down list instead of manual input. If your provider is
not listed it is explained below how you can add your individual entries to
the pre-defined settings.
CORRECTION DATA SETTINGS (GPRS)
In this field the login details of your reference service provider are set. You
will receive username and password from your reference service provider.
Some ascos services are already pre-defined. If you choose a pre-defined
setting also the optional parameters are included automatically.
OPTIONAL PARAMETERS (GPRS)
„Set static mount point“ allows to set the mount point manually.
„Disable source table download“ disables the source table download. The
come2ascos will not select a suitable mount point automatically, but go
directly to the manually specified one.
„Require GGA message“ activates control by GGA messages from your
GNSS receiver.
„Disable control by NMEA“ can be used for modem tests without a GNSS
receiver connected. The connection will be built up without receiving GGA –
just to see if dialling in works. Afterwards the reference service will cut the
connection because a GGA is normally needed.
