Alpha Technologies SA – Boulevard de l’Europe 131 – B-1301 Wavre – Belgium – ℡+32 10 438 510 – +32 10 438 213
www.alphatechnologies.eu
Ref 4804 872 50293
PE6500/50
Preparing before installation
CHARGING THE BATTERY
Charge the batteries during minimum one hour before using the equipment the first time.
MAINS CONNECTION
•Mains cable:
minimum requirements: 3 x 0.8mm² or AWG18 ( Line / Neutral / PE )
•Grounding:
for Safety, the battery box must be connected to the Protective Earth through the mains cable and a M4
grounding screw is also provided on the rear side.
•Leakage current:
maximum 3.5 mA
•Minimum value of the external fuse or breaker:
110V mains: 10A delayed action ( line current )
230V mains: 4A delayed action ( line current )
•The battery box has an internal fuse only in the Life line
The power supply cord is used as the main disconnect device, ensure that the socket-outlet is located / installed
near the equipment and is easily accessible.
PROTECTIVE EARTH (PE) CONNECTION
The grounding wire (yellow / green – central terminal) of the mains input must be connected to the PE through the
mains cables.
The mains and grounding connections must be made in accordance with local Norms, Standards and rules.
CONNECTION OF THE APPLICATION
The four outputs are available on the MATE-N-LOK connectors on the rear
Each output is protected by a 4A (5x20mm Slow action) fuse present on the front of the rack (F1 … F4).
For safety compliance, ( risk of fire ) replace only with same type and rating of fuse:
type of fuse: ( 5 x 20 )mm 4A slow
