Alpha Alpha 240 Boiler Range Gebrauchsanweisung

Instructions for setting the burner

pressures on the gas valve

Alpha 240, 280 and 500 Boiler Range

1. GENERAL

The maximum and minimum burner pressures are factory set and should not require adjusting. However, if the gas valve

has been replaced, then these burner pressures must be set by adjustment on the gas valve. Refer to the Installation and

Servicing instructions for gaining access to and for replacement of the gas valve.

Note: Ensure that the plastic tube between the gas valve and the room sealed chamber is fitted correctly.

2. SETTHE MAXIMUM BURNER PRESSURE

a. Loosen the burner pressure test point screw on the gas valve

and connect a pressure gauge.

b. Release the modulating coil spring and remove the coil from

the spindle (B).

c. Turn the screw (A) fully in by hand in a clockwise direction.

d. Release the locking nut (C) securing the spindle (B) to the gas

valve.

e. Set the selector switch to (DHW only) and fully open a hot

tap.

f. Rotate the spindle (B) to set the maximum burner pressure, i.e.

clockwise to increase the burner pressure, anti-clockwise to

decrease the burner pressure.

g. When the correct maximum burner pressure is obtained with

the room sealed chamber panel fitted, carefully tighten the

locking screw (C) to secure the spindle (B) - take care not to

allow the spindle to turn.

Note: With the locking nut tightened, check that the maximum

burner pressure is correct.

3. SETTHE MINIMUM BURNER PRESSURE

The maximum burner pressure must be correctly set as described

above before the minimum burner pressure is set.

a. Turn the screw (A) anti-clockwise until the minimum burner

pressure is obtained with the room sealed chamber panel

fitted.

b. Replace the modulating coil and ensure it is secured with the

spring clip. Recheck the maximum burner pressure. Continue

to adjust and check until both the maximum and minimum

burner pressures are as shown in the table below.

c. Set the selector switch to '0' to turn off the boiler. Disconnect

the pressure gauge and tighten the test point screw.

d. Test for gas soundness using a suitable leak detection fluid.

Burner pressure

test point

Room sealed

chamber

pressure tube

Inlet gas

pressure

test point

Modulating

coil spring

clip

Modulating

coil

Locking nut (C)

Spindle (B)

Minimum burner

pressure adjusting

screw (A)

Boiler Maximum Burner Pressure

LPG

240 Range

280 Range

500E

Nat gas LPG

mbar

9.6

11.8

10.8

in wg

3.84

4.70

4.32

mbar

36.6

35.0

in wg

14.6

14.0

mbar

1.1

1.5

1.9

in wg

0.44

0.60

0.76

mbar

6.2

4.0

5.8

in wg

2.84

1.60

2.32

Minimum Burner Pressure

Nat gas

02/04/D163

Compiled and designed by Publications 2000, Tel (01670) 356211

These instructions have been carefully prepared but we reserve the right to

alter the specification at any time in the interest of product improvement.

Alpha Therm Limited.

NepicarHouse,LondonRoad,WrothamHeath,

Sevenoaks, Kent TN15 7RS

Tel: 0870 3001964

email: [email protected]

website: www.alpha-boilers.com

Andere Handbücher für Alpha 240 Boiler Range

Dieses Handbuch passt für folgende Modelle

Andere Alpha Kessel Handbücher

Alpha

Alpha Alpha CD24 Benutzerhandbuch

Alpha

Alpha Alpha CD25C Benutzerhandbuch

Alpha

Alpha 240P Bedienungsanleitung

Alpha

Alpha Alpha 500E Bedienungsanleitung

Alpha

Alpha Alpha CD13R Benutzerhandbuch

Alpha

Alpha al357i-b Bedienungsanleitung

Alpha

Alpha Alpha CD Condensing Boiler Bedienungsanleitung

Alpha

Alpha GasSaver GS-1 Benutzerhandbuch

Alpha

Alpha Alpha CB24 Benutzerhandbuch

Alpha

Alpha Alpha CD18S Benutzerhandbuch

Alpha

Alpha Alpha CombiMax 350 Benutzerhandbuch

Alpha

Alpha Evoke 28 Benutzerhandbuch

Alpha

Alpha CB28X Service-Handbuch

Alpha

Alpha Alpha HE25 Bedienungsanleitung

Alpha

Alpha Alpha CD24C Benutzerhandbuch

Alpha

Alpha E-Tec 20S Benutzerhandbuch

Alpha

Alpha Alpha CB24 Bedienungsanleitung

Alpha

Alpha Alpha CB Boiler Bedienungsanleitung

Alpha

Alpha Alpha C23 Benutzerhandbuch

Alpha

Alpha Alpha CD Bedienungsanleitung

Alpha

Alpha InTec 40GS2 Benutzerhandbuch

Alpha

Alpha E-Tec 28 Bedienungsanleitung

Alpha

Alpha 26C Bedienungsanleitung

Alpha

Alpha Alpha HE25 Bedienungsanleitung

Beliebte Kessel Handbücher anderer Marken

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Bedienungsanleitung

Radijator

Radijator BIO max 23.1 Bedienungsanleitung

Brunner

Brunner BSV 20 Bedienungsanleitung

Buderus

Buderus Logamax GB062-24 KDE H V2 Bedienungsanleitung

Potterton

Potterton 50e Datenblatt

UTICA BOILERS

UTICA BOILERS TriFire Bedienungsanleitung

Joannes

Joannes LADY Series Handbuch

ECR International

ECR International UB90-125 Gebrauchsanweisung

Froling

Froling P4 Pellet 8 - 105 Bedienungsanleitung

Froling

Froling FHG Turbo 3000 Bedienungsanleitung

U.S. Boiler Company

U.S. Boiler Company K2 Bedienungsanleitung

Henrad

Henrad C95 FF Bedienungsanleitung

NeOvo

NeOvo EcoNox EF 36 Bedienungsanleitung

Potterton

Potterton PROMAX SL 12 Bedienungsanleitung

Eco Hometec

Eco Hometec EC 25 COMPACT Bedienungsanleitung

Viessmann

Viessmann VITODENS 200 Leitfaden

Baxi

Baxi Prime 1.24 Bedienungsanleitung

REXNOVA

REXNOVA ISA 20 BITHERMAL Bedienungsanleitung