Alpha Alpha CB Boiler Bedienungsanleitung

Installation Instructions

Alpha CB/C/SY Boiler

Vertical FlueTerminal Assembly

Twin Pipe (80 mm) Flue System

(Kit Part No. 6.1000369)

KIT CONTENTS

1. GENERAL

a. The flue system must be installed in accordance with BS 5440:1:1990.

b. The boiler must be installed in accordance with the installation instructions supplied with the boiler and the twin

pipe flue instructions supplied with the boiler conversion kit.

c. The vertical flue terminal assembly is equivalent to 1.0 m of flue length.

d. Refer to the vertical flue options in Fig. 1 and ensure that the flue length (H) does not exceed the equivalent of

7.0 m.

e. Each 45° bend is equivalent to 0.5 m of length of flue and no more than four bends must be used in each flue

exhaust or air inlet duct.

Note: 90° bends must not be used with the vertical flue.

f. Additional flue/air ducting is available in 1.0 m lengths for extending the flue up to a maximum equivalent flue

length of 7.0 m.

g. The vertical terminal may be connected directly to the boiler via the conversion kit. However, under no

circumstances must the terminal be shortened in length.

h. To determine the total length (A) of flue/air ducting required (refer to Fig. 1).

Measure the distance (X) from the top of the boiler side panel to the weathering slate position and subtract 640

mm for the terminal assembly, i.e. C = X - 640 mm

A = 2 x C + (50 mm for each connection in straight ducting).

Compiled and designed by Publications 2000, Tel (01670) 356211 08/04/D131

Fig. 1

H = Equivalent length of flue or air duct

The Vertical terminal assembly is equivalent to 1.0 m of flue length and each 45° bend is equivalent to 0.5 m of flue length.

Note: 90° bends must not be used with the vertical flue.

2. INSTALLATION

Refer to the Twin Pipe Flue installation instructions supplied with the boiler conversion kit (Part No. 6.1000368).

a. Refer to Fig. 1 for positioning of the vertical terminal in the roof.

b. To enable direct connection of the flue and air ducts to the terminal the duct centres must be 120 mm apart.

c. At the required position cut a hole and/or remove tiles so that there is at least a 170 mm diameter hole in the roof.

Ensure there is at least a 25 mm gap between the outer duct and any combustible material.

d. Fit a weathering slate, suitable for a 125 mm outside diameter flue, over the hole in the roof. A suitable weathering

slate (Part No. 6.1000380) is available from Alpha Therm Ltd.

e. Fit the terminal assembly into the weathering slate and place it in position, ensuring the minimum distances given in

Fig. 1 are maintained.

f. After assembly of the ducts to the terminal, ensure it is not possible to disengage any part of the flue assembly.

Check that the weathering slate is fitted correctly and ensure that the flue assembly is supported at roof level using

suitable brackets.

These instructions have been carefully prepared but we reserve the right to

alter the specification at any time in the interest of product improvement.

Alpha Therm Limited.

Nepicar House,LondonRoad,WrothamHeath,

Sevenoaks, Kent TN15 7RS

Tel: 0870 3001 964

email: info@alphatherm.co.uk

website: www.alpha-innovation.co.uk

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Alpha Kessel Handbücher

Alpha

Alpha Alpha CD25C Bedienungsanleitung

Alpha

Alpha Evoke 28NX Bedienungsanleitung

Alpha

Alpha E-Tec 25R Benutzerhandbuch

Alpha

Alpha Alpha CD Bedienungsanleitung

Alpha

Alpha Alpha Plus DH Units Leitfaden

Alpha

Alpha Alpha CD50S Benutzerhandbuch

Alpha

Alpha 26C Benutzerhandbuch

Alpha

Alpha InTec 50CS Benutzerhandbuch

Alpha

Alpha ARES Pro 150 Benutzerhandbuch

Alpha

Alpha CB28X Service-Handbuch

Alpha

Alpha InTec2 20SE Benutzerhandbuch

Alpha

Alpha Alpha HE25 Bedienungsanleitung

Alpha

Alpha E-Tec 20S Benutzerhandbuch

Alpha

Alpha Alpha 240XP Bedienungsanleitung

Alpha

Alpha Alpha Twin Pipe Flue Systems Bedienungsanleitung

Alpha

Alpha Alpha CD25C Benutzerhandbuch

Alpha

Alpha Alpha CB Boiler Bedienungsanleitung

Alpha

Alpha DS 24 TF Produkthandbuch

Alpha

Alpha ARES Pro 150 Benutzerhandbuch

Alpha

Alpha ARES 150 Tec Benutzerhandbuch

Alpha

Alpha Alpha CB50 Boiler Stücklistenhandbuch

Alpha

Alpha Eco Bedienungsanleitung

Alpha

Alpha Alpha CB Boiler Bedienungsanleitung

Alpha

Alpha Alpha CD35C Bedienungsanleitung

Beliebte Kessel Handbücher anderer Marken

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Bedienungsanleitung

Radijator

Radijator BIO max 23.1 Bedienungsanleitung

Brunner

Brunner BSV 20 Bedienungsanleitung

Buderus

Buderus Logamax GB062-24 KDE H V2 Bedienungsanleitung

Potterton

Potterton 50e Datenblatt

UTICA BOILERS

UTICA BOILERS TriFire Bedienungsanleitung

Joannes

Joannes LADY Series Handbuch

ECR International

ECR International UB90-125 Gebrauchsanweisung

Froling

Froling FHG Turbo 3000 Bedienungsanleitung

Froling

Froling P4 Pellet 8 - 105 Bedienungsanleitung

U.S. Boiler Company

U.S. Boiler Company K2 Bedienungsanleitung

Henrad

Henrad C95 FF Bedienungsanleitung

NeOvo

NeOvo EcoNox EF 36 Bedienungsanleitung

Potterton

Potterton PROMAX SL 12 Bedienungsanleitung

Eco Hometec

Eco Hometec EC 25 COMPACT Bedienungsanleitung

Viessmann

Viessmann VITODENS 200 Leitfaden

Baxi

Baxi Prime 1.24 Bedienungsanleitung

REXNOVA

REXNOVA ISA 20 BITHERMAL Bedienungsanleitung