Altec Lansing LF215-4A LF SPEAKER SYSTEM Bedienungsanleitung

FREQUENCY RESPONSE 1, 2

42 Hz - 650 Hz (±3 dB)

USABLE LOW FREQUENCY LIMIT (-10 dB) 1, 2

33 Hz

SENSITIVITY 3

103 dB SPL, (2.00 V input)

POWER HANDLING 4

500 W continuous; 2,000 W peak

MAXIMUM OUTPUT (1 m) 5

130 dB SPL continuous; 136 dB SPL peak

TRANSDUCER COMPONENTS

2x 15 in. Woofers (4156-8A)

IMPEDANCE 7

Nominal: 4.0 Ω

Minimum: 3.5 Ωat 41 Hz

HARMONIC DISTORTION 8

1% rated power

2nd Harmonic 0.30%

3rd Harmonic 0.40%

THD 0.63%

10% rated power

2nd Harmonic 1.38%

3rd Harmonic 0.49%

THD 1.54%

INPUT CONNECTIONS

2x 4 position barrier strip and 2x NL4

CONTROLS

Drivers in Parallel or Split Mode switch

ENCLOSURE MATERIALS & FINISH

18 mm, 13 ply Birch Plywood Finished with Charcoal

Grey or White Catalyzed Polyurethane

SUSPENSION SYSTEM 9

Working Load Limit (maximum weight applied to

uppermost mounting point): tbd lbs. (tbd kg)

(12) 3/8 in.-16 Threaded Mounting Suspension Points

(3 each top & bottom and 2 each sides & back)

DIMENSIONS

37.50 in. (H) x 24.13 in. (W) x 26.13 in. (D)

x 10.13 in. (W rear)

953 mm (H) x 613 mm (W) x 664 mm (D)

x 257 mm (W rear)

WEIGHT

Net 115 lbs. (52.3 kg)

Shipping 138 lbs. (62.7 kg)

LF215-4A

FEATURES - THE ALTEC LANSING DIFFERENCE

• Dual 15” / 380mm Low Frequency Speaker

•High Performance 500 W AES / 2,000 W Peak Power Handling

• Excellent Broadband Efficiency – 103 dB SPL, 1 W 1 m

• Matching Footprint To Altec’s DE6412 & DE9412

• Strong 13-Ply Birch Paintable Cabinet

• Steel Reinforced Suspension Points

• Forged Eyebolt Suspension Kit Included

• Available in Charcoal Gray or White Finishes

GENERAL PRODUCT DESCRIPTION

The LF215-4A is a dual 15” / 380mm subwoofer with the same

footprint as the Altec Lansing DE6412 and DE9412 Duplex®

full-range speaker systems. In addition to its use with Altec’s DE

& DS-series full-range speaker systems, the LF215-4A can be easily

incorporated into component-based sound systems. The

LF215-4A has been designed to provide extended low frequency

performance in Auditoriums, Performing Arts Centers, Houses

of Worship, or any facility requiring low frequency reinforcement

for full-range music reproduction.

Two of the Altec model 4156-8A 15” / 380mm woofers

are used in the LF215-4A. The drivers may be connected in

parallel (for a single four ohm load) or driven individually (for

two, eight ohm loads) via a switch and separate driver inputs.

This robust component has been designed to deliver tight,

punchy low frequency reproduction in vented speaker cabinets.

The 4156-8A has a corrosion resistant die-cast frame and

moisture-resistant cone for maximum durability in all

environments.

The 13-ply birch plywood enclosure is paintable, and features

steel reinforced suspension points. Altec Lansing includes a

forged eyebolt suspension kit with each subwoofer. Input

connections are via barrier strip or Neutrik®Speakon®connectors.

The LF215-4A is offered in either charcoal grey or white, with

contrasting cloth covered metal grille. Altec Lansing includes

neutral grille cloth with each subwoofer, allowing you to dye the

cloth to integrate the subwoofer into the surroundings.

The LF215-4A is designed to work in conjunction with Altec’s

DE6412 and DE9412 Duplex®12”/300mm full-range speaker

systems. Presets are available for the Altec Lansing 4048A

4-in x 8-out DSP Processor, allowing the system designer to easily

incorporate the LF215-4A into multi-channel applications.

PROFESSIONAl

1000 W. Wilshire Blvd., Suite 362 • Oklahoma City, Oklahoma 73116 • Phone: 1-405-848-3108 • Fax: 1-405-848-3217 • www.altecpro.com

ARCHITECTS & ENGINEERS SPECIFICATION

The loudspeaker system shall be a low frequency, multi-

purpose trapezoid enclosure consisting of two 15-inch /

380mm cast frame loudspeaker components with moisture-

resistant cones. The loudspeaker system shall have an

operating bandwidth of 42 Hz - 650 Hz with a sensitivity

of 103 dB when measured at a distance of one meter. The

power handling capability shall be 500 W AES (2,000 W

peak). Nominal impedance shall be 4.0 ohms with a

minimum impedance of 3.5 ohms at 41 Hz. The unit shall

be a trapezoid enclosure constructed of 18 mm

birch plywood with a cloth covered metal grille. The

cabinet shall include integral steel-reinforced suspension

points. Forged shoulder machinery eye bolts shall be

included to facilitate the suspension of the speaker system.

The dimensions shall be 37.50 inches (953 mm) high by

24.13 inches (613 mm) wide by 26.13 inches (664 mm)

deep. The loudspeaker system shall weigh 115 pounds

(52.3 kg). The loudspeaker system shall be the Altec

Lansing Professional model LF215-4A.

As we are continually striving to improve Altec Lansing products, specifications are subject to change without notice.

Please visit www.altecpro.com for the lastest information on Altec Lansing Professional products.

Altec Lansing Professional

Oklahoma City, OK 73116

A division of Altec Lansing Technologies, Inc., Milford, PA 18337-0277 • Made in China

LF215-4A

PIN 1 +

PIN 1 -

INPUT

PARALLEL MODE

4 OHMS

SPLIT MODE

2x 8 OHMS

PARALLEL MODE

TOP DRIVER

SPLIT MODE

PIN 2 +

PIN 2 -

BOTTOM

DRIVER

SPLIT MODE --

PARALLEL MODE

TOP DRIVER

SPLIT MODE

BOTTOM

DRIVER

SPLIT MODE

PARALLEL

SPLIT

MODE

AW1139 REV01

1000 W. Wilshire Blvd., Suite 362

Oklahoma City, Oklahoma 73116

Phone: 1-405-848-3108 • Fax: 1-405-848-3217

Web: www.altecpro.com • Email: [email protected]

PROFESSIONAl

11.9 [301.51] 9.47 [240.47]

5.1 [128.33]

DIMENSIONS ARE IN INCHES.

DIMENSIONS SHOWN IN ( ) PARENTHESES ARE IN MILLIMETERS.

DENOTES CENTER OF MASS

1.7 [43.40]

6.33 [160.76]

6.65 [169.01]

24.1 [612.10]

37.40 [950.00]

26.10 [663.05]

1.71 [43.40]

9.47 [240.47]

16.19 [411.26]

18.70 [475.02]

26.11 [663.28] 16.64 [422.71]

10.10 [256.65]

7.56 [192.14]

MOUNTING DIMENSIONS

SPECIFICATION NOTES

1 The frequency response of the loudspeaker system is measured at a distance of no less than 3 meters to obtain full range data. The level is

then corrected to be equivalent to a 2.0 V 1 m measurement. A near field measurement of the loudspeaker system is performed for

frequencies below 500 Hz. This data is then combined with the full range measurement to give an accurate composite frequency response

curve.

2 The limits of the frequency response are referenced to -3 dB of the systems rated sensitivity.

3 The sensitivity of the loudspeaker system is the log based average SPL taken over the intended bandwidth of operation for the system with a

2.0 V swept sine stimulus. The data is measured and level corrected in a manner consistent with note 1.

4 The power handling capacity of the loudspeaker system is tested using a full range form of AES Standard 2-1984. The test stimulus is band

limited (30 Hz – 300 Hz) pink noise with a 6 dB crest factor. The applied RMS voltage is determined using the minimum impedance of the

system. The amplifier used to drive the system has a minimum operating headroom of 6 dB referenced to the RMS voltage.

5 The maximum output level of the loudspeaker system is calculated based on the sensitivity and the power handling capabilities of the

system.

7 The minimum impedance of the loudspeaker system is taken over its intended band of operation.

8 The distortion measurements of the loudspeaker system are performed at a distance of 1 m with RMS input voltages corresponding to 1%

and 10% of rated system power handling calculated using minimum system impedance. The distortion percentages are log based averages

from 30 Hz – 300 Hz.

9 Before attempting to suspend the loudspeaker system, consult a certified structural engineer. This loudspeaker system can fall from

improper suspension, resulting in serious injury and property damage. Maximum enclosure rigging angle is 45°. Use only the correct mating

hardware, forged shoulder machinery eye bolt, Mil Spec MIL 51937-3. All associated rigging is the responsibility of others.

VISIT WWW.ALTECPRO.COM FOR

• Authorized EASE®data on Altec Lansing Professional speakers.

• Specification sheets in .pdf format. Download page 1 of the specification sheet for your submittals.

• One paragraph A & E Specifications in .doc format.

Andere Altec Lansing Lautsprechersystem Handbücher

Altec Lansing

Altec Lansing FX5051 Bedienungsanleitung

Altec Lansing

Altec Lansing 1203A SPEAKER SYSTEMS Bedienungsanleitung

Altec Lansing

Altec Lansing ADA745 Bedienungsanleitung

Altec Lansing

Altec Lansing Duplex EP925 Series Bedienungsanleitung

Altec Lansing

Altec Lansing 938-8AD Bedienungsanleitung

Altec Lansing

Altec Lansing ADA305 Bedienungsanleitung

Altec Lansing

Altec Lansing VS4221 Bedienungsanleitung

Altec Lansing

Altec Lansing M602 Bedienungsanleitung

Altec Lansing

Altec Lansing 305 S Bedienungsanleitung

Altec Lansing

Altec Lansing IMT 237 Bedienungsanleitung

Altec Lansing

Altec Lansing inMotion iMmini Bedienungsanleitung

Altec Lansing

Altec Lansing Duplex EP405-8T Bedienungsanleitung

Altec Lansing

Altec Lansing BXR1220 Bedienungsanleitung

Altec Lansing

Altec Lansing ATP4 Handbuch

Altec Lansing

Altec Lansing 849-8B SPEAKER SYSTEM Bedienungsanleitung

Altec Lansing

Altec Lansing VS2420 - QUICK CONNECT CARD Stücklistenhandbuch

Altec Lansing

Altec Lansing DTS200 SPEAKER SYSTEM Bedienungsanleitung

Altec Lansing

Altec Lansing BX21 Bedienungsanleitung

Altec Lansing

Altec Lansing VS4221 Bedienungsanleitung

Altec Lansing

Altec Lansing DTS-212 SPEAKER SYSTEM Bedienungsanleitung

Altec Lansing

Altec Lansing BXR1120 Bedienungsanleitung

Altec Lansing

Altec Lansing VS2321 Stücklistenhandbuch

Altec Lansing

Altec Lansing DTS94 SPEAKER SYSTEM Bedienungsanleitung

Altec Lansing

Altec Lansing ACS90 Bedienungsanleitung

Beliebte Lautsprechersystem Handbücher anderer Marken

JVC

JVC CA-MXK5R Bedienungsanleitung

LG NB4532B Bedienungsanleitung

JVC

JVC CA-FSH100 Bedienungsanleitung

5Core

5Core Pro Series Bedienungsanleitung

EAW

EAW MQV1394e Bedienungsanleitung

Lynx

Lynx GXR-LA10A Bedienungsanleitung

iLive

iLive ITB066B Bedienungsanleitung

RDX

RDX QuickStation 4 Bedienungsanleitung

Electro-Voice

Electro-Voice S-122 Bedienungsanleitung

Sven

Sven SPS-619 GOLD Bedienungsanleitung

Pioneer

Pioneer CS-7070 Bedienungsanleitung

EAW

EAW UB82e Bedienungsanleitung

Sondpex

Sondpex Active Speaker System and Digital Music... Bedienungsanleitung

JVC

JVC NX-PN7 Bedienungsanleitung

Marshall Amplification

Marshall Amplification AR-DM61-BT Bedienungsanleitung

Yamaha

Yamaha NX-A01 - Speaker Sys Bedienungsanleitung

SE Audiotechnik

SE Audiotechnik I-LINE Bedienungsanleitung

Gemini

Gemini WRX-843 Series Bedienungsanleitung