Vers. 1.0 - 17.01.97 1
1. Preface
Topax Hygiene Systems are used for rinsing, foaming or spraying of detergents and
sanitisers. The formation of foam is performed by mixing water, detergent or sanitiser
and compressed air in a specially designed injector system.
It is important that your operational staff reads these directions for use prior to
installation and start of operation. Operation as laid down in the directions for use will
ensure an optimum level of hygiene in your factory and a minimum level of
maintenance and repair work.
1.0 Application
S 6000 and S 5000 are stationary cleaning stations designed to automatic cleaning.
Furthermore, manual S 3000 satellites can be connected to the S 6000. S 5000 is to be
connected to a main/pump station. We recommend the P3 Topax Hygiene Controller to
control the hygiene-cycles. The stations are made of corrosion resistant materials,
mainly stainless steel, and are therefore especially suitable for application within the
food industry. If you need further information, please contact Henkel-Ecolab.
Standard programmable hygiene stages are as follows:
a) pre-rinse with water
b) clean with foam
c) rinse off with water
d) sanitise with spray or foam
e) final rinse with water
1.1 Special Warnings
The special warnings CAUTION, ATTENTION and NOTE used in this Technical
Manual have the following meanings:
CAUTION: This term is used to highlight the fact that complete or even partial
failure to properly adhere to operating instructions, working
instructions, specified working sequences and similar can cause
personal injuries or accidents.
