Ambirad SmartCom3 Service-Handbuch

INDEX Section

General Information--------------------------------------------------------1

Parts Requirement ---------------------------------------------------------2

Instructions -------------------------------------------------------------------3

WARNINGS

AmbiRad equipment must be installed and maintained in accordance with the relevant

provisions of the Gas Safety (Installations and Use) Regulations 1998 for gas fired products,

and the current edition of the OFTEC regulations for oil fired products. Due account should

also be taken of any obligations arising from the Health and Safety at Works Act 1974 or

relevant codes of practice. In addition the installation must be carried out in accordance with

the current IEE wiring regulations (BS 7671), BS 6896:2005 (Industrial & Commercial) and

any other relevant British Standards and Codes of Practice by a qualified installer. All exter-

nal wiring MUST comply with the current IEE wiring regulations.

SMARTCOM3FM TOCABINET HEATER

MOUNTING KIT INSTALLATION

Technical Bulletin.

SC3-FM-VKIT (VCH 100/150, VCHE 30/40) or

SC3-FM-HKIT (all other vertical models)

The kits contain the parts in the following table:

This bulletin describes the procedures to be

carried out when fitting the new SmartCom 3 FM

controller as a replacement for the original

thermostat controls, CAL 01 controller, or earlier

Smartcom and SmartCom2 controllers onto

VCH/VCHE gas/oil fired vertical cabinet heaters.

See Figs.1 and 2

1.General Information.

Fig.1

The SmartCom 3 FM controller is supplied

under AmbiRad part Nos.SC3-FM-VKIT and

SC3-FM-HKIT complete with a kit of parts

containing the components required to fit the

controller onto the cabinet heater.

CAL 01

Fig.2

SmartCom 3 FM

* The kit required depends on the size of the

cabinet heater. AmbiRad part Nos. are:

Part No. Quantity Description

SC3-FM 1 SmartCom 3 FM controller

300048 1

Vertical mounting plate *

(SC3-FM-VKIT)

300049 1

Horizontal mounting plate *

(SC3-FM-HKIT)

CHFH 1 Fuseholder

2617 1 Fuse (6.3A)

202165 4 Fixing screws

TB/046/12090 1 Technical bulletin

2. Parts Requirement.

Old style controls

SmartCom +

SmartCom2

Before commencing any work ensure

that both the gas/oil and electricity

supplies are turned OFF.

1: Remove the four screws securing the original

controls panel to the heater, and withdraw to

reveal the interconnecting wiring.

2: Identify the four cables which run into the

heater (red, blue, black, grey). These should

already be connected to heater terminals 1,2,4

and 6respectively.

3: Disconnect these four cables from the old

controls.

3. Instructions.

LINK

140

SC3-FM CONTROLLER

124

2SMARTCOM TERMINALS

CABINET TERMINALS

4: Connect cables to the new SmartCom FM

terminals as shown in the wiring diagram below.

5: Fit the new SmartCom FM to the heater using

the four screws provided in the kit.

6: Re-instate the gas/oil and electricity supplies.

7: Set up the new SmartCom FM if required

following the instructions in the supplied manual.

8: Test the heater for correct operation.

Wiring diagram

AmbiRad Limited Fens Pool Avenue

Brierley Hill West Midlands DY5 1QA

United Kingdom.

Telephone 01384 489700

Facsimile 01384 489707

Email [email protected]

Website www.ambirad.co.uk

Technical Support www.s-i-d.co.uk AmbiRad is a registered trademark of AmbiRad Limited. Because of continuous product

innovation, AmbiRad reserve the right to change product specification without due notice.

Document reference number TB/046/1209

Notes.

Andere Handbücher für SmartCom3

Inhaltsverzeichnis

Andere Ambirad Heizung Handbücher

Ambirad

Ambirad UCA 25 Bedienungsanleitung

Ambirad

Ambirad VPlus40 Bedienungsanleitung

Ambirad

Ambirad AIRBLOC ACR Series Bedienungsanleitung

Ambirad

Ambirad VPlus40 Bedienungsanleitung

Ambirad

Ambirad Scorpio SC 12 Bedienungsanleitung

Ambirad

Ambirad QUARTZ GLOW Bedienungsanleitung

Ambirad

Ambirad VISION VSO Montageanleitung

Ambirad

Ambirad SCA 45 Leitfaden

Ambirad

Ambirad VISION VSXE20UT Benutzerhandbuch

Ambirad

Ambirad TORNADO Bedienungsanleitung

Ambirad

Ambirad Vision VSX Bedienungsanleitung

Ambirad

Ambirad Vision Range VSXUS Bedienungsanleitung

Ambirad

Ambirad SCA45 Technisches Handbuch

Ambirad

Ambirad OFSU32 Betriebsanleitung

Ambirad

Ambirad VSUS Bedienungsanleitung

Ambirad

Ambirad ARO Series Bedienungsanleitung

Ambirad

Ambirad NRV12LR Service-Handbuch

Ambirad

Ambirad Vision VSXUS 90 Datenblatt

Ambirad

Ambirad Vision VSO Series Installationsanleitung

Ambirad

Ambirad VCH Series Benutzerhandbuch

Ambirad

Ambirad VISION VT Series Bedienungsanleitung

Ambirad

Ambirad Vision Series Betriebsanleitung

Ambirad

Ambirad Tornado 600 Installationsanleitung

Ambirad

Ambirad VCLUS 40-S10 Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

IRSAP

IRSAP The Radiator Company Ovali Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung