PURE 2.0 OPERATING INSTRUCTIONS
08/21/19 4211-1430 Page 2 of 4
Initial Set-up
If you are using an Elite with your PURE 2.0, you may use all the PURE 2.0 functions with the Elite but the Elite
set-up should be done first. If you are using only a PURE 2.0, there are no set-ups required. The PURE 2.0 starts
with the bath temperature set at 125°F (55°C) and the bath duration set at 60 minutes.
If using only PURE 2.0s to control your bath, you will be allowed to set the bath temperature from 86°F to 125°F
(30°C to 52°C and bath time from 6 to 60 minutes.
Using the PURE 2.0
The Light key may be used to turn a light on or off while the bath is off. The light will turn on automatically
when a bath is started; this key can then be used to turn the light off again. Note: the light will remain on
for 10 minutes after the bath stops unless switched off by the user.
The Start key is pressed to start or stop the steam bath.
The Change keys move your selection higher or lower on the 1-10 LED scale while making
adjustments.
The Function Select keys move your selection left or right through the function selections. Highlight
the function you want to adjust, then uses the Change keys to move through the LED range to
select your new value. The humidity function is not available for steam baths.
Setting the bath temperature (may be done with the bath off or on)
Touch a key on the PURE 2.0 to light the keyboard, if necessary. The Temperature function LED should be lit
and the current temperature setting should be indicated on the 1-10 LED scale. To change this setting, use the
Change keys to select the LED corresponding to the bath temperature you prefer. Turn the bath on then off to
save the new setting. See the approximate settings below:
86 91 95 98 104 107 111 116 120 125
30 33 35 37 40 42 44 47 49 52
Setting the bath duration (must be done with the bath off)
Touch a key on the PURE 2.0 to light the keyboard, if necessary. Use the Function Select keys to select the
Duration function (its LED is lit). The current bath Duration setting should be indicated on the 1-10 LED scale. To
change this setting, use the Change keys to select the LED corresponding to the bath duration you prefer. This is
the time limit where the bath will automatically shut off. Turn the bath on then off to save the new setting. See the
approximate settings below:
LED #
6 12 18 24 30 36 42 48 54 60
Setting delayed start (must be done with the bath off)
You can set the steam bath to start at a later time, such as setting it before bed at night so it is on and ready when
you get up in the morning.
Touch a key on the PURE 2.0 to light the keyboard, if necessary. Use the Function Select keys to select the
Delayed Start function (its LED is lit. Use the Change keys to select the LED corresponding to the start delay you
prefer. The delay can be up to 10 hours in one hour increments (the LEDs represent from 1 to 10 hours). At that
time, the bath will start automatically and run for the duration time already set. Press the bath Start key to save
your setting.
