American DJ Rover Bedienungsanleitung

User Instructions

American DJ

4295 Charter Street

Los Angeles Ca. 90058

www.americandj.com

Introduction:

Thank you for purchasing the American DJ Rover.

™ To optimize the per-

formance of this product, please read these operating instructions care-

fully to familiarize yourself with the basic operations of this unit. This

unit utilizezes a unique barrel type mirror. The barrel mirror will rotate

back and forth to the beat of the music, shooting the colored beams

in serveral directions all at once. The American DJ® Rover™ is sound

active and has three different operating modes (Sound Active, Continu-

ous Rotation, and Static).

Customer Support:

American DJ® provides a toll free customer support line, to provide set

up help and to answer any question should you encounter problems

during your set up or initial operation. You may also visit us on the web

at www.americandj.com for any comments or suggestions.

Service Hours are Monday through Friday 9:00 a.m. to 6:00 p.m. Pacic

Standard Time.

Voice: (800) 322-6337

Fax: (323) 582-2610

E-mail: suppor[email protected]

Warning! To prevent or reduce the risk of electrical shock or re, do

not expose this unit to rain or moisture.

Caution! There are no user serviceable parts inside this unit. Do not

attempt any repairs yourself, doing so will void your manufactures war-

ranty. In the unlikely event your unit may require service please contact

your nearest American DJ dealer.

Do not discard the shipping carton in the trash. Please recycle when

ever possible.

HALOGEN LAMP WARNING!

This fixture is fitted with a halogen lamp which is highly susceptible

to damage if improperly handled. Never touch lamp with your bare

fingers as the oil from your hands will shorten lamp life. Also, never

move the fixture until the lamp has had ample time to cool. Remember,

lamps are not covered under warranty conditions.

Rover™ Introduction

©American DJ Supply® - www.americandj.com - Rover™ Instruction Manual Page 2

American DJ

ROVER™

General Operation:

This fixture is designed to operate as a stand alone unit, there is no

need of a controller. It has been tested and lamped at the factory there

is no assembly necessary. The Rover™ is ready to be plugged in, out

of the box. There is no power switch. After plugging the unit if there is

no lamp output check the fuse and bulb, sometimes during shipping

the fuse and bulb become loose. If the fuse and bulb are good, please

return the unit for servicing. After plugging this fixture in, the units’

barrel mirror will spin back and forth. The Rover™ features a multi-color

dichroic dish that will also rotate. This fixture features a light weight

case design and a hanging bracket. This unit can be operated in three

different modes. This fixture is designed for mobile DJ’s, clubs, bands,

roller rinks and any arena that requires a compact, light weight, easy

to use fixture.

Operating Modes:

This unit comes with a 3-way multi-operating switch located on the rear

of the unit. The switch controls three (3) different operating modes;

Static, Sound Active, and Continuous Rotation. When the switch is

in the "I" position the internal dichroic dish spin continuously and the

barrel mirror will react to sound, via its internal microphone. When the

unit is in the "0" position the internal dichroic dish is static (does not

rotate) and the barrel mirror will react to sound. When the switch is

in the "II" position the unit's internal dichroic color wheel and barrel

mirror will react to sound.

Rover™ Operation

©American DJ Supply® - www.americandj.com - Rover™ Instruction Manual Page 3 ©American DJ Supply® - www.americandj.com - Rover™ Instruction Manual Page 4

Fixture Cleaning:

Due to fog residue, smoke, and dust cleaning the internal and external

optical lenses must be carried out periodically to optimize light output.

1. Use normal glass cleaner and a soft cloth to wipe down the

outside casing.

2. Use a brush to wipe down the fan grill.

3. Clean the external optics with glass cleaner and a soft

cloth every 20 days.

4. Clean the internal optics with glass cleaner and a soft cloth

every 30-60 days.

5. Always be sure to dry all parts completely before plugging

the unit back in.

Cleaning frequency depends on the environment in which the fixture

operates (I.e. smoke, fog residue, dust, dew). In heavy club use we

recommend cleaning on a monthly basis. Periodic cleaning will ensure

longevity, and crisp output.

Fuse Replacement:

Disconnect from the main power supply. Insert a standard flat head

screw driver in to the fuse holder housing as illustrated in figure two.

Turn the screwdriver in counter-clockwise direction to remove the fuse

holder. Remove the old fuse and discard it, replace the fuse with the

same type. Insert the fuse back into it’s housing.

If you continue to blow fuses, STOP using the unit. Returning the unit

for servicing. Continuing to use the unit may cause serious damage.

Caution: Always replace with the exact same type lamp and fuse,

unless otherwise specified by an authorized American DJ® technician.

Rover™ Cleaning

Use a at head screwdriver

to remove the fuse holder

3 Position Mode SwitchFuse Holder

Rover Bottom Housing

©American DJ Supply® - www.americandj.com - Rover™ Instruction Manual Page 6©American DJ Supply® - www.americandj.com - Rover™ Instruction Manual Page 5

Trouble Shooting:

Listed below are a few common problems that you may encounter,

with solutions.

No light output from the unit;

1. Be sure you have connected your unit into a standard 110V wall

outlet.

2. Be sure the external fuse has not blown. The fuse is located on

the rear panel.

3. Remove the lamp cover and be sure the lamp is seated in its socket

properly. Occasionally lamps become loose during shipping be

sure the lamp is push in to its socket all the way.

Unit does not respond to sound;

1. Be sure the unit's mode switch is in the "I" position, this is the only

mode that allows the unit to operate in sound active mode.

2. Low frequencies (bass) should cause the unit to react to sound.

Tapping on the microphone, quiet or high pitched sounds may not

activate the unit.

Rover™ Trouble Shooting Rover™ Cleaning

Lamp Replacement:

Disconnect from the main power supply. Be sure the unit has had

ample time to cool before attempting to replace the lamp. On the front

of the unit there is a single thumb screw. Remove the thumb screw and

pull back the front case housing. The housing is hinged which allows

it to pull back without being removed. Remove the old lamp from the

socket assembly. Carefully install the new lamp, be sure to follow all

the installation guide lines that are included with your new lamp. Close

the front cover and replace the thumb screw.

Caution: Always replace with the exact same type lamp and fuse,

unless otherwise specified by an authorized American DJ® technician.

Remove the thumb screw on the rear of the unit as illustrated below.

Remove the lamp from the socket and insert a new one as illustrated above.

©American DJ Supply

American DJ World Headquarters:

4295 Charter Street Los Angeles, CA 90058 USA

Tel: 323-582-2650 / Fax: 323-582-2610

Web: www.americandj.com / E-mail: inf[email protected]

Technical Specifications:

Model: Rover™

Lamp: ZB-BRL 12v/50w

Voltage: 110~120v

Dimensions: 4.25H x 6.25W x 16.5L

Colors: Multi-colored dichroic dish

Gobos: None

Weight: 6.5 Lbs.

Fuse: 3 Amp GMA

Duty Cycle: 15min on/off

Optics: High Quality Glass Lens

Reflective Surface mirror

Internal Dichroic Color Dish

Ventilation: Fan Cooled

Operating Mode: 3-position Mode Switch (Static,

Sound Active, & Continuous)

Rover™ Specifications

©American DJ Supply® - www.americandj.com - Rover™ Instruction Manual Page 7

Please Note: Specications and improvements in the design of

this unit and this manual are subject to change without any prior

written notice.

Inhaltsverzeichnis

Andere American DJ DJ-Equipment Handbücher

American DJ

American DJ Torch Light Bedienungsanleitung

American DJ

American DJ FS-6C Bedienungsanleitung

American DJ

American DJ Jewel LED Bedienungsanleitung

American DJ

American DJ Mini Mine Bedienungsanleitung

American DJ

American DJ Mega Panel LED Bedienungsanleitung

American DJ

American DJ Mini Tri Ball Bedienungsanleitung

American DJ

American DJ LED Trispot Bedienungsanleitung

American DJ

American DJ Barrel Flex Bedienungsanleitung

American DJ

American DJ Flat Par Tri7X Bedienungsanleitung

American DJ

American DJ Fusion Scan 250 EX Bedienungsanleitung

American DJ

American DJ Quadra Force/Sys Bedienungsanleitung

American DJ

American DJ MULTI-LED CURTAIN Bedienungsanleitung

American DJ

American DJ Double Twist Bedienungsanleitung

American DJ

American DJ Atmospheric RG LED Bedienungsanleitung

American DJ

American DJ S-10S Bedienungsanleitung

American DJ

American DJ Jewel Bedienungsanleitung

American DJ

American DJ Micro Image RGB Bedienungsanleitung

American DJ

American DJ DJ Scan 250 Bedienungsanleitung

American DJ

American DJ DJ Spot LED Bedienungsanleitung

American DJ

American DJ Flash-2C Bedienungsanleitung

American DJ

American DJ LED Beam Scan Bedienungsanleitung

American DJ

American DJ Sunray-150D Bedienungsanleitung

American DJ

American DJ AVIATOR-SP8 Bedienungsanleitung

American DJ

American DJ Jelly Jewel LED Bedienungsanleitung

Beliebte DJ-Equipment Handbücher anderer Marken

ALPHA LITE

ALPHA LITE ALPHA 1500 Betriebsanleitung

Chauvet

Chauvet OVATION E-930VW Bedienungsanleitung

Snow Masters

Snow Masters Zig Oscillator Bedienungsanleitung

EuroLite

EuroLite 50530554 Bedienungsanleitung

Beamz

Beamz BUV243 Bedienungsanleitung

thomann

thomann Stairville DJ Lase 40-G MK-III Bedienungsanleitung

Eagletone

Eagletone 6 Eyes Flower Bedienungsanleitung

EuroLite

EuroLite FLD-1508 Bedienungsanleitung

Technical Pro

Technical Pro LG8xSEA Bedienungsanleitung

JB Systems

JB Systems Lounge Laser DMX Bedienungsanleitung

Lightmaxx

Lightmaxx Vega Halo 90 Bedienungsanleitung

Elation

Elation FUZE WASH Z350 Bedienungsanleitung

Maverick

Maverick MK3 WASH Bedienungsanleitung

Infinity

Infinity TF-260C7 Fresnel Bedienungsanleitung

Chauvet

Chauvet EVE E-50Z Bedienungsanleitung

Eliminator Lighting

Eliminator Lighting E 138 Bedienungsanleitung

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Bedienungsanleitung

KAM

KAM DMX Laser80 FScan Bedienungsanleitung