American-Lincoln SR5730 Bedienungsanleitung

AMERICAN-LINCOLN 1-1

SR5730

All directions given in this book are as seen from the operator's position at the rear of the machine.

READ THIS BOOK

This book has important information for the use and safe operation of this machine. Failure

to read this book prior to operating or attempting any service or maintenance procedure to

your machine could result in injury to you or to other personnel; damage to the machine or to

other property could occur as well. you must have training in the operation of this machine

before using it. If you or your operator(s) cannot read English, have this manual explained

fully before attempting to operate this machine.

Part No. 2-86-00315 2003 Printed in the

American-Lincoln USA

ISO 9001

FILE A2287

American-Lincoln

Operators Manual & Parts Lists

Disc

Cylindrical Scrubber

5730

Scrubber

Beginning with Serial Number 180337

1-2 AMERICAN-LINCOLN

SR5730

NOTES

AMERICAN-LINCOLN 1-3

SR5730

Index

CONTROLS 21

CYLIDRICAL SCRUB (SEE CHAPTER 4)

DECIMAL-METRIC CONVERSIONTABLE 5

DISCLAIMER 4

ELECTRICAL SCHEMATIC 57

HARDWARE ABBREVIATIONS 6

HYDRAULIC TORQUE REQUIRENMENTS 8

INSTRUMENT PANEL WIRING 59

MACHINE PREPARATION 17

MAINTENANCE 39

OPERATING INSTRUCTIONS 30

ORDERING PARTS 10

POWER PANEL WIRING 60

SAFETY PRECAUTIONS 11

SPECIFICATIONS 14

STANDARD HARDWARE & TORQUE VALUES 7

SYMBOLS 9

TROUBLESHOOTING 50

WIRE HARNESS CONNECTIONS 58

WIRE HARNESS CONNECTIONS-SPRAY WAND 62

WIRE HARNESS ROUTING 61

1-4 AMERICAN-LINCOLN

SR5730

DISCLAIMER

The information contained in this manual is believed correct at the time of publication.

American Lincoln assumes no responsibility or liability for unauthorized changes made to this

manual or pages removed, causing indirect or consequential damages resulting from the use

of the information appearing herein.

WARNING!

In the event that machinery or controls described herein are modified in any way, or in the event

that such machinery or controls are not maintained in a proper manner, the instructional

material contained herein may be rendered inaccurate. The information contained herein is to

be used only by persons knowledgeable in the operation of machinery such as that described

herein, or other persons being directly supervised by such knowledgeable persons.

No portion of this manual may be reproduced without the express written consent of:

AMERICAN LINCOLN

Product Engineering

1100 Haskins Road

Bowling Green, OH, 43402

(419) 352-7511 Fax: (419) 373-4284

Printed in USA March 2003

DISCLAIMER

AMERICAN-LINCOLN 1-5

SR5730

FRACTION FRACTIONDECIMAL DECIMALMILLIMETER MILLIMETER

16 16

0.015625

0.03125

0.046875

0.0625

0.078125

0.09375

0.109375

0.125

0.140625

0.15625

0.171875

0.1875

0.203125

0.21875

0.234375

0.25

0.265625

0.28125

0.296875

0.3125

0.328125

0.34375

0.359375

0.375

0.390625

0.40625

0.421875

0.4375

0.453125

0.46875

0.484375

.05

0.515625

0.53125

0.546875

0.5625

0.578125

0.59375

0.609375

0.625

0.640625

0.65625

0.671875

0.6875

0.703125

0.71875

0.734375

0.75

0.765625

0.78125

0.796875

0.8125

0.828125

0.84375

0.859375

0.875

0.890625

0.90625

0.921875

0.9375

0.953125

0.96875

0.984375

1.00

0.3969

0.7938

1.1906

1.5875

1.9844

2.3813

2.7781

3.1750

3.5719

3.9688

4.3656

4.7625

5.1594

5.5563

5.9531

6.3500

6.7469

7.1438

7.5406

7.9375

8.3344

8.7313

9.1281

9.5250

9.9219

10.3188

10.7156

11.1125

11.5094

11.9063

12.3031

12.7000

13.0969

13.4938

13.8906

14.2875

14.6844

15.0813

15.4781

15.8750

16.2719

16.6688

17.0656

17.4625

17.8594

18.2563

18.6531

19.0500

19.4469

19.8438

20.2406

20.6375

21.0344

21.4313

21.8281

22.2250

22.6219

23.0188

23.4156

23.8125

24.2094

24.6063

25.0031

25.4000

C2001/9905

DECIMAL-METRIC CONVERSION TABLE

1-6 AMERICAN-LINCOLN

SR5730

HARDWARE ABBREVIATIONS

ABBREVIATIONS - SCREWS

ADJ = Adjusting Screw

ADJ.SP = Adjusting Plunger Screw

BHM = Binding Head Machine Screw

BHS = Button Head Socket Screw

CAPT.SL = Captivated Slotted Screw

CAPT.WG = Captivated Wing Screw

FHM = Flat Head Machine Screw

FIL.HM = Filister Head Machine Screw

HHC = Hexagon Head Cap Screw

HHM = Hexagon Head Machine Screw

HIHD = 1/2 High Head Screw

HSHC = Hexagonal Socket Head Cap Screw

HSFHC = Hexagonal Socket Flat Head Cap Screw

KNH = Knurled Head Screw

MHHC = Metric Hexagon Head Cap Screw

PHM = Pan Head Machine Screw

RHD = Round Head Drive Screw

RHM = Round Head Machine Screw

RHW = Round Head Wood Screw

SHC = Shiny Crown Cap Screw

SHTB = Shoulder Thumb Screw

SQ = Square Head Screw

TB = Thumb Screw

THM = Truss Head Machine Screw

WELD = Weld Stud

WG = Wing Screw

ABBREVIATIONS - SETSCREWS

HS = Hexagonal Socket Setscrew

S= Slotted Setscrew

SH = Square Head Setscrew

-KCP = Knurled Cup Point Setscrew

-CP = Cup Point Setscrew

-OP = Oval Point Setscrew

-FDP = Full Dog Point Setscrew

-HDP = Half Dog Point Setscrew

-FP = Flat Point Setscrew

-COP = Cone Point Setscrew

C-2004

AMERICAN-LINCOLN 1-7

SR5730

SAE - Grade 5 SAE - Grade 8

Screw

Size

Grade

Plated

Grade

Plated

410H

Stainless

Brass Type

F&T

&BT

Type

B, AB

*10

*1/4

5/16

3/8

7/16

1/2

9/16

5/8

3/4

7/8

135

239

387

579

108

110

153

267

130

138

191

338

545

818

151

108

155

216

378

114

132

120

156

120

CCC

FFF F

C = Coarse Thread

F = Fine Thread

* = Torque values for #6 through 1/4 are lb./in. All others are lb./ft.

NOTE

Decrease the torque by 20% when using thread lubricant

The torque tolerance is ± on torque values.

C2000/9905

STANDARD HARDWARE & TORQUE VALUES

1-8 AMERICAN-LINCOLN

SR5730

HYDRAULIC TORQUE REQUIREMENTS

HYDRAULICTORQUE REQUIREMENTS

Refer to the following chart for torque values on all hydraulic hoses and fittings.

NominalO-Ring Face SealEnd SAE O-Ring Boss End

SAE Thread SwivelThread Str.Fitting

Dash Size Nut Size or Locknut

SizeInch Torque Inch Torque

LB-FT LB-FT

-3 * * 3/8-248-10

-4 9/16-18 10-12 7-16-20 14-16

-5 * * 1/2-20 18-20

-6 11/16-16 18-20 9/16-18 24-25

-8 13/16-16 32-35 3/4-16 50-60

-10 1-1446-50 7/8-1472-80

-12 1 3/16-12 65-70 1 1/16-12 125-135

-141 3/16-12 65-70 1 3/16-12 160-180

-16 1 7-16-12 92-100 1 5/16-12 200-220

-20 1 11/16-12 125-140 1 5/8-12 210-280

-242-12 150-165 1 7/8-12 270-360

*O-Ring face sealtype end not defined for this tube size.

NOTE

Parts must be lightlyoiled with hydraulicfluid.

C-2002

AMERICAN-LINCOLN 1-9

SR5730

Scrub Brush Down Heavy Pressure

Squeegee Down & Vacuum On

Squeegee Up & Vacuum On

Solution Tank Low

Solution Flow Control

Throttle

Read Machine Manual

No gas or combustibles in tank

Keep Away From Flames/

Wear Eye Protection

Electrical Hazard

Stay Clear

Moving Fan Blade

Pinch Point/Crush Hazard

Cover or Hopper Could Close/

Turn Key Off/Lock Wheel

WARNING! / ATTENTION!

Squeegee Up & Vacuum Off

Battery Charger

Choke

Fan On

Filter Shaker On

Forward/Reverse

Headlights

Hopper Dump

Hopper Return

Horn

Main Broom & Side Broom Up

Main Broom & Side Broom Down

No Step

Off

Power

Recovery Tank High

Scrub Brush Down & On

Scrub Brush Up and Off

THESE SYMBOLS IDENTIFYCONTROLS, DISPLAYS/FEATURES, AND SAFETYSYMBOLS ON THE MACHINE.

Before Operating or Servicing

NO Smoking

Engage Support

Before Leaving Seat

SYMBOLS

1-10 AMERICAN-LINCOLN

SR5730

Parts may be ordered from American-Lincoln authorized distributors.

Record the information from the American-Lincoln serial number plate

to avoid delays in filling your order.

Parts may be ordered from American-Lincoln authorized distributors.

Record the information from the American-Lincoln serial number plate

to avoid delays in filling your order.

1. Use the model number, catalog number, and serial number when ordering.

. Give the part number, description, and quantity of parts needed.

. Give shipping instructions for either freight, UPS, or parcel post.

Parts and supplies listed in this manual can be ordered from the following address

1. Use the model number, catalog number, and serial number when ordering.

2. Give the part number, description, and quantity of parts needed.

3. Give shipping instructions for either freight, UPS, or parcel post.

Parts and supplies listed in this manual can be ordered from the following address:

American-Lincoln American Lincoln

Distributor

American Lincoln

Distributor

1100 Haskins Road

Bowling Green, Ohio 4302

1-800-331-7692

1100 Haskins Road

Bowling Green, Ohio 4302

1-800-331-7692

MACHINE CATALOG NUMBERS

505-945 SR5730 (34”) DISC SCRUBBER

505-946 SR5730 (38”) DISC SCRUBBER

505-959 SR5730 (34”) CYLINDRICAL SCRUBBER

MACHINE CATALOG NUMBERS

505-945 SR5730 (34”) DISC SCRUBBER

505-946 SR5730 (38”) DISC SCRUBBER

505-959 SR5730 (34”) CYLINDRICAL SCRUBBER

MODEL NO. SERIAL NO.

Manufactured By

AMERICAN LINCOLN

TECHNOLOGY

BOWLING GREEN, OHIO

ORDERING PARTS

Inhaltsverzeichnis

Andere American-Lincoln Schrubber Handbücher

American-Lincoln

American-Lincoln Encore S28 Bedienungsanleitung

American-Lincoln

American-Lincoln 7760 Bedienungsanleitung

American-Lincoln

American-Lincoln Encore R Installations- und Betriebshandbuch

American-Lincoln

American-Lincoln SC7740 Installations- und Betriebshandbuch

American-Lincoln

American-Lincoln 56515851 Bedienungsanleitung

American-Lincoln

American-Lincoln 7760 Bedienungsanleitung

American-Lincoln

American-Lincoln 505-945 Bedienungsanleitung

American-Lincoln

American-Lincoln Alto SR7770HC Bedienungsanleitung

American-Lincoln

American-Lincoln ALTO SMART 2000 Bedienungsanleitung

American-Lincoln

American-Lincoln SC7750 IC Bedienungsanleitung

American-Lincoln

American-Lincoln SR9772 510-016 Bedienungsanleitung

Beliebte Schrubber Handbücher anderer Marken

Olympus

Olympus M200H Bedienungsanleitung

Clarke

Clarke BEXT 100H Installations- und Betriebsanleitung

JOHNY VAC

JOHNY VAC JVC70BCT Bedienungsanleitung

RCm

RCm Elan Series Handbuch

Kärcher

Kärcher B 120 W Bedienungsanleitung

Truvox

Truvox Orbis MotorScrubber 20 Bedienungsanleitung

Numatic

Numatic TTB 4045/100 Bedienungsanleitung

U.S. Products

U.S. Products PEX 500-C-TICK Betriebsanleitung

Mclennan

Mclennan C510 Bedienungsanleitung

Tennant

Tennant T20 LPG Bedienungsanleitung

Columbus

Columbus ARA 66 BM 100 Bedienungsanleitung

Numatic

Numatic TTV 678G / 300T Bedienungsanleitung

Floorpul

Floorpul ruby 48 blt Benutzerhandbuch

Onyx

Onyx RX-34 Bedienungsanleitung

Dustbane

Dustbane Hurricane 400 Bedienungsanleitung

Sana

Sana EUJ-702 Bedienungsanleitung

REMS

REMS Twist Bedienungsanleitung

Tennant

Tennant 7200 Bedienungsanleitung