AMobile IOT-800 Bedienungsanleitung

IOT-800

8" Risc-based IoT Terminal

User's Manual

Version 1.0

- II -

This page is intentionally left blank.

- i -

Revision History

Version Release Time Description

1.0 2015.11 Initial release

- ii -

This document contains proprietary information protected by copyright. No

part of this manual may be reproduced by any mechanical, electronic, or other

means in any form without prior written permission of the manufacturer.

Disclaimer

The information in this document is subject to change without prior notice in

order to improve the reliability, design and function. It does not represent a

commitment on the part of the manufacturer.

Under no circumstances will the manufacturer be liable for any direct, indirect,

special, incidental, or consequential damages arising from the use or inability

to use the product or documentation, even if advised of the possibility of such

damages.

About This Manual

This user’s manual provides the general information and installation

instructions for the product. The manual is meant for the experienced users

and integrators with hardware knowledge of personal computers. If you are not

sure about any description in this manual, consult your vendor before further

handling.

We recommend that you keep one copy of this manual for the quick reference

for any necessary maintenance in the future. Thank you for choosing AMobile

products.

- iii -

Contents

Preface...........................................................................................................v

Declaration of Conformity.....................................................................................v

CE ................................................................................................................v

FCC Class B ................................................................................................v

RoHS...........................................................................................................vi

SVHC / REACH...........................................................................................vi

Safety Symbols .................................................................................................. vii

Important Safety Instructions ............................................................................. vii

General Cleaning Tips.........................................................................................ix

Cleaning Tools.............................................................................................ix

Recommended Cleaning Procedures ..........................................................x

Disposing of the Equipment ................................................................................xi

Additional Information & Technical Support ....................................................... xii

Warranty............................................................................................................. xii

Chapter 1 Introduction................................................................................1

1.1 Product Highlights..........................................................................................2

1.2 Package Contents..........................................................................................2

1.3 Optional Accessories......................................................................................3

1.4 Parts of the Device.........................................................................................4

1.5 Dimensions ....................................................................................................5

1.6 Specications.................................................................................................6

Chapter 2 Installation..................................................................................8

2.1 microSD Card Installation ..............................................................................9

2.2 Wi-Fi/Bluetooth Antenna Installation ..............................................................9

2.3 SIM Card and 3G/4G Antenna Installation (Optional) ..................................10

2.4 Power Connection........................................................................................11

2.4.1 Using the DC Terminal Block Connector...........................................11

2.4.2 Using the Power Adapter (Optional)..................................................12

2.5 GPS Mouse Connection (Optional)..............................................................12

2.6 Mounting the Device ....................................................................................13

2.7 Connector Pintouts.......................................................................................13

2.7.1 PWPIN ..............................................................................................13

2.7.2 GPIO and CAN Bus ..........................................................................13

Chapter 3 Using the Device......................................................................15

3.1 Turning On/Off the Device............................................................................16

3.2 Home Screen ...............................................................................................16

- iv -

Contents

3.2.1 Using the Quick Settings Panel.........................................................18

3.3 Congurations..............................................................................................19

3.3.1 Conguring Your SIM Card (Optional)...............................................19

3.3.2 Enabling Wi-Fi and Connecting to a WLAN ......................................20

3.3.3 Enabling Bluetooth and Pairing with Bluetooth Device .....................20

3.3.4 Enabling the Ethernet Feature ..........................................................22

3.3.5 Enabling Location Service (Optional)................................................23

3.3.6 Enabling and Using the NFC Features (Optional).............................23

- v -

Preface

Declaration of Conformity

The CE symbol on your product indicates that it is in compliance with the

directives of the Union European (EU). A Certicate of Compliance is available

by contacting Technical Support.

This product has passed the CE test for environmental specications when

shielded cables are used for external wiring. We recommend the use of

shielded cables. This kind of cable is available from AMobile. Please contact

your local supplier for ordering information.

FCC Class B

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference

that may cause undesired operation.

Any changes or modications not expressly approved by the guarantee of this

device could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of

the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

Preface

- vi -

Preface

•Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

RoHS

AMobile Intelligent Corporation certies that all components in its products

are in compliance and conform to the European Union’s Restriction of Use

of Hazardous Substances in Electrical and Electronic Equipment (RoHS)

Directive 2002/95/EC.

The above mentioned directive was published on 2/13/2003. The main purpose

of the directive is to prohibit the use of lead, mercury, cadmium, hexavalent

chromium, polybrominated biphenyls (PBB), and polybrominated diphenyl

ethers (PBDE) in electrical and electronic products. Member states of the EU

are to enforce by 7/1/2006.

AMobile Intelligent Corporation hereby states that the listed products do not

contain unintentional additions of lead, mercury, hex chrome, PBB or PBDB

that exceed a maximum concentration value of 0.1% by weight or for cadmium

exceed 0.01% by weight, per homogenous material. Homogenous material

is dened as a substance or mixture of substances with uniform composition

(such as solders, resins, plating, etc.). Lead-free solder is used for all

terminations (Sn(96-96.5%), Ag(3.0-3.5%) and Cu(0.5%)).

SVHC / REACH

To minimize the environmental impact and take more responsibility to the

earth we live, AMobile hereby conrms all products comply with the restriction

of SVHC (Substances of Very High Concern) in (EC) 1907/2006 (REACH

--Registration, Evaluation, Authorization, and Restriction of Chemicals)

regulated by the European Union.

All substances listed in SVHC < 0.1 % by weight (1000 ppm)

- vii -

Preface

Safety Symbols

This symbol of “CAUTION” indicates that there is a danger of injury to

the user or a risk of damage to the product, should warning notices be

disregarded.

This symbol indicates electrical warning.

Important Safety Instructions

Read these safety instructions carefully:

1. Read all cautions and warnings on the equipment.

2. Place this equipment on a reliable surface when installing. Dropping it or

letting it fall may cause damage

3. Make sure the correct voltage is connected to the equipment.

4. For pluggable equipment, the socket outlet should be near the equipment

and should be easily accessible.

5. Keep this equipment away from humidity.

6. Disconnect this equipment from the A/C outlet before cleaning it. Use a

moist cloth. Do not use liquid or sprayed detergent for cleaning.

7. To fully disengage the power to the unit, please disconnect the power from

the AC outlet.

8. Do not scratch or rub the screen with a hard object.

9. Never use any of the solvents, such as Thinner Spray-type cleaner, Wax,

Benzene, Abrasive cleaner, Acid or Alkaline solvent, on the display. Harsh

chemicals may cause damage to the cabinet and the touch sensor.

10. Remove dirt with a lightly moistened cloth and a mild solvent detergent.

Then wipe the cabinet with a soft dry cloth.

11. The openings on the enclosure are for air convection and protect the

equipment from overheating. DO NOT COVER THE OPENINGS.

12. Position the power cord so that people cannot step on it. Do not place

anything over the power cord.

- viii -

Preface

13. If the equipment will not be used for a long time, disconnect it from the

power source to avoid damage by transient overvoltage.

14. Never pour any liquid into openings. This may cause re or electrical

shock.

15. Never open the equipment. For safety reasons, the equipment should be

opened only by qualied service personnel.

16. If one of the following situations arises, get the equipment checked by

service personnel:

a. The power cord or plug is damaged.

b. Liquid has penetrated into the equipment.

c. The equipment has been exposed to moisture.

d. The equipment does not work well, or you cannot get it to work

according to the user’s manual.

e. The equipment has been dropped or damaged.

f. The equipment has obvious signs of breakage.

17. The sound pressure level at the operator’s position, according to IEC 704-

1:1982, is no more than 70dB(A).

18. Keep this User’s Manual for later reference.

19. DO NOT LEAVE THIS EQUIPMENT IN AN UNCONTROLLED

ENVIRONMENT WHERE THE STORAGE TEMPERATURE IS BELOW

-20° C (-4° F) OR ABOVE 85° C (185° F). THIS MAY DAMAGE THE

EQUIPMENT.

Andere Handbücher für IOT-800

Inhaltsverzeichnis

Andere AMobile Touch-Terminal Handbücher

AMobile

AMobile IOT-500 Bedienungsanleitung

Beliebte Touch-Terminal Handbücher anderer Marken

Wincor Nixdorf

Wincor Nixdorf iPOS plus Advanced Bedienungsanleitung

Ingenico

Ingenico AXIUM EX4000 Bedienungsanleitung

Heisei Electronics

Heisei Electronics Q-POS 815 Bedienungsanleitung

Amano

Amano MTX-15 Bedienungsanleitung

FLOWBIRD

FLOWBIRD CWT Compact Touch Bedienungsanleitung

Demco

Demco SP7 Bedienungsanleitung

Lathem

Lathem PC600 Series Bedienungsanleitung

Partner

Partner MF-2352 Bedienungsanleitung

NCR

NCR RealPOS 7460-2 Handbuch

Simrad

Simrad MS50 Montageanleitung

Unitech

Unitech MR350 MKII Kurzanleitung

Jungheinrich

Jungheinrich WMT 210 Bedienungsanleitung

Motorola

Motorola MTP850 Bedienungsanleitung

YASKAWA

YASKAWA 62H-MDC0 Bedienungsanleitung

MVG industries

MVG industries NeptuLink Bedienungsanleitung

Price Industries Limited

Price Industries Limited FDC Gebrauchsanweisung

Honeywell

Honeywell TemaKey Bedienungsanleitung

EBN

EBN BPC65-B-A16G Bedienungsanleitung