AMP Lighting RenaissancePro ADL-2011-4-B-BZ Bedienungs- und Sicherheitshinweise

INSTALLATION & MAINTENANCE GUIDE

Help Hotline:

1-813-978-3900 • Mon-Fri 9am-6pm (EST)

www.amplighting.com

AMP®Low Voltage Landscape Lighting

AMP®RenaissancePro Deck Light

ADL-2011-4-B-BZ

AMP®RenaissancePro Deck Light

ADL-2011-4-B-BZ

INSTALLATION & MAINTENANCE GUIDE

www.amplighting.com

–2–

Important Safety Instructions: Read Before Installation

This luminaire is intended for installation in accordance with local codes

and the National Electric Code (NEC). Failure to adhere to these codes and

instructions may result in serious injury, property damage and void the

warranty.

These instructions do not intend to cover all variations in installation,

operation maintenance or mounting situations.

1. Make sure the power is turned OFF before installing or servicing this

luminaire.

2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M)

or more from pool, spa or fountain.

3. This luminaire is intended to be used only with a power supply

(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.

4. Wiring connections must be made with UL listed wire connectors that are

suitable for outdoor use.

5. Position the low voltage wire and wire connector so that it is located

within 6 inches (15.2 cm) from a building structure, a luminaire or

tting.

6. The main low voltage cable is intended for shallow burial - less than 6

inches (152 mm).

7. If additional lengths of low voltage cable are required, please contact

www.amplighting.com or call 1-813-978-3900.

Important Safety Instructions

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS

Lighted lamp is HOT!

WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.

1. Turn off/unplug and allow to cool before replacing lamp.

2. Lamp gets HOT quickly! Contact only switch/plug when turning on.

3. Do not touch the hot lens, guard or enclosure.

4. Keep lamp away from materials that may burn.

5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may dam-

age lamp.

6. Do not operate the luminaire tting with a missing or damaged shield.

SAVE THESE INSTRUCTIONS

[email protected] • 813.978.3900

Product Dimensions

–3–

Package Contents

A. (1) Fixture

B. (2) Lock Screws

4.25” 2.75”

3.5” 2”

ProTip for Hiding Lead Wire

Determine the location for the xture. Drill a hole straight through the

desired mounting location and run the lead wire out the backside of

the location so that the wires are not visible from the front side. Use a

matching trim piece and cut a groove in the back of trim. Cover the lead

wires with the matching trim piece.

ProTip for Hiding Splice Connections

All xtures come with 4’ of lead wire enabling you to hide the splice

connections out of sight. If you must make a splice connection in view, use

an inline heat shrink style connection that is less visible than traditional

twist caps.

Parts Required

A. (1) Lamp

INSTALLATION & MAINTENANCE GUIDE

–4–

www.amplighting.com

–4–

Remove Face Cover

AMP®RenaissancePro Deck Light

ADL-2011-4-B-BZ

Face Cover

Fixture Body

Rotate Rotate the face cover until it

stops and then lift the cover

straight off.

Note: The rst time it may be

difcult because the xture

has a very tight o-ring seal and

a grease sealant for moisture

protection.

Install Fixture Body

Fixture Body

Lock Screw

Wall Anchor

(optional)

Hole

Attach the xture body to your

desired location and secure with lock

screws.

Note: Wall anchors may be required

for certain installation conditions

(e.g. Brick walls, Concrete Walls,

etc.). Mark on the wall using holes

on the xture body to drill holes for

your wall anchors. Remove base and

drill proper holes in the wall, then

insert wall anchors.

Install Lamp

Insert lamp with the correct

wattage and type marked on

xture label and push into place.

CAUTION: Do not exceed

maximum wattage marked on

luminaire label.

Lamp

Socket

[email protected] • 813.978.3900

–5–

INSTALLATION & MAINTENANCE GUIDE

Install Face Cover

Wire Connections

AMP®RenaissancePro Deck Light

ADL-2011-4-B-BZ

Fixture Body

Face Cover

Push face cover back onto the

xture body aligned with the gaps

in the xture body. Once the face

cover is ush with the xture body,

rotate the face cover until it stops

and locks into place.

Fixture

Wire

Connectors

Main Supply Cable

Pigtail

Strip both leads from luminaire

pigtail. Using two wire connectors

(sold separately), connect leads

from luminaire to main supply cable

leads.

Install/Replace Lamp

Rotate the face cover and remove it to expose the lamp. Replace it with the

correct wattage and type marked on the xture label. Then, reinstall the

face cover.

IMPORTANT: Halogen bulbs must be protected from moisture and dust at all

times. Always reinstall the face cover when removed.

INSTALLATION & MAINTENANCE GUIDE

–6–

www.amplighting.com

–6–

AMP®RenaissancePro Deck Light

ADL-2011-4-B-BZ

Decorative Arms

Install Decorative Arms

Decorative arms are sold as

additional options for this deck light.

Please read the following steps for

installation of the decorative arms.

5.5”

3.5”

Attach the decorative arms on the

top or bottom of the xture body

and secure with lock screws. Multiple

decorative arms can be added going

up or down to create your own unique

look.

Note: Wall anchors may be required

for certain installation conditions (e.g.

Brick walls, Concrete Walls, etc.).

Mark on the wall using holes on the

xture body to drill holes for your wall

anchors. Remove base and drill proper

holes in the wall, then insert wall

anchors.

Fixture

Body

Decorative

Arms

Decorative

Arms

Hole

Decorative

Arms

Lock Screw

Wall Anchor

(optional) Hole

–6––6–

[email protected] • 813.978.3900

–7–

IS-ADL-2011-4-B-BZ-ver1.pdf

Specications and product details subject to change without notice.

[email protected] • 813.978.3900

Help Hotline:

1-813-978-3900 • Mon-Fri 9am-6pm (EST)

www.amplighting.com

Inhaltsverzeichnis

Andere AMP Lighting Beleuchtungsausrüstung Handbücher

AMP Lighting

AMP Lighting ASDL-2016-B-BZ Bedienungs- und Sicherheitshinweise

AMP Lighting

AMP Lighting G2 AAC-HUB2-LI-SS Bedienungs- und Sicherheitshinweise

AMP Lighting

AMP Lighting AAL-1045-B-BK Bedienungs- und Sicherheitshinweise

AMP Lighting

AMP Lighting VAC-HUB5-PBK Bedienungs- und Sicherheitshinweise

AMP Lighting

AMP Lighting BDL-ASI-9009-25-BK Bedienungs- und Sicherheitshinweise

AMP Lighting

AMP Lighting VAC-HS-6718-YMP Bedienungs- und Sicherheitshinweise

AMP Lighting

AMP Lighting PilotPro APL-3022-L-B-BZ Bedienungs- und Sicherheitshinweise

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung

Silvair

Silvair MESH-CEDRP Bedienungsanleitung

S&P

S&P PCRL80 Bedienungsanleitung