Safety and Compliance Information
For safety, compliance, recycling, and other important information regarding your Device,
please refer to the Legal & Compliance section in the User Manual.
Caution: risk of explosion if the batteries are replaced by an incorrect type. Dispose of used
batteries according to the instructions.
Using Your Device Around Other Electronic Devices
The Device, uses, and can radiate radio frequency (RF) energy and, if not used in accordance
with its instructions, may cause interference to radio communications and electronic
equipment. External RF signals may affect improperly installed or inadequately shielded
electronic operating systems, entertainment systems, and personal medical devices.
While most modern electronic equipment is shielded from external RF signals, if in doubt, check
with the manufacturer. For personal medical devices (such as pacemakers and hearing aids),
consult with your physician or the manufacturer to determine if they are adequately shielded
from external RF signals.
There are some places where RF signals could constitute a hazard, such as health care facilities,
and construction sites. If you are not sure, look around for signs indicating that two-way radios
or mobile phones should be turned off.
FCC – regulatory user information
This equipment complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Modifications of the equipment which are not expressly approved by the party responsible for
it’s compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
