7
A. Water dividing pipe：with nine little holes, water will flow out from these little holes. And if no
water flows out, can be disassembled and cleaned.
B. Evaporator (ice-making module)
C. Ice full detecting board: Use to detect the inner cabinet is full of ice or not, and to check the the
ice-harvest process is over or not.
D．Water tank：
E．Water supplying pipe：
F．Cover board on the right side of the evaporator：
G．Water level switch installing plate：
H．Water drain pipe of the water tank：when ice-making, this pipe should be clamped in the slot of
the water tank wall; And when draining, this pipe should be pulled out.
I．Water pump：
J．Water level detecting switch
3) Operation panel
A．“TIMER CLEAN”button：
Quickly press this button once, to enter the Time
setting program; And press this button for more than
seconds, to enter the Cleaning program.
B．“ON/OFF”button：
When the unit is off, press this button to turn on th
unit; And during the Self-cleaning program, or norma
ice-making state, press this button to turn off the uni
at once; And also if the unit is set with the Timer
press this button to cancel the Timer setting.
When the unit is making the ice cube, press thi
button for more than 5 seconds, the unit will switch t
ice harvest process by force.
C．LCD display window
1.Environmental temperature display and ice - makin
time countdown display.Display ice-making tim
countdown with M as the unit display,and displa
environmental temperature with F as the unit display
2．Making ice and deice symbol display,the machine i
making ice when the symbol rotate,and the machin
is deice when the symbol flash. .
3．Automatic self-cleaning symbol display
4．On/off symbol display
5．Error code display，E1 means the environmental temperature sensor is damaged.，E2 means
ice making anomaly or the refrigerant leaked
6．Water flow in and water shortage display, the arrow flashing indicates that the machine is in
the water, the whole symbol is bright to indicate that the machine is short of water.
7．Ice full alarm,the machine will making ice again when you take out the ice.
8．Setting display.Display timing switch machine with the H as unit display;Display ice making
time setting with M as unit display.
D&E．“+”、“-”button：
Use to adjust the ice-making process duration period length, the default setting is zero, 1
minute adding or decreasing per each pressing of “+” or “-” button.
Also to adjust the delay time of the timer, the default setting is zero, 1 hour adding or
decreasing per each pressing of “+” or “-” button.
ON/OFF
TIMER
CLEAN +
-
