CHAPTER 1 DECADE II DCC upgrade kit install guide, edition 5 7
CHAPTER 1
Dual Cell Control upgrade kit
Congratulations on your purchase of the DECADE II Dual Cell Control
upgrade kit, p/n 171.0216, 171.0218 or 171.0220. This DCC kit enables you
to upgrade your DECADE II to an electrochemical workstation with two flow
cells allowing serial or independent parallel operation.
Important notice
Your DECADE II is factory installed with a LM35 temperature sensor mounted
in the heater compartment. The LM35 sensor has a cable with three wires
(red/white/ black) and a 6-pin Molex KK connector (white) . This cable is
originally not connected to any board and is fixed into the grey cable clamp on
the left side panel of the DECADE II inside the housing.
Only a few DECADE II detectors on the market do not have the LM35 sensor
preinstalled (first series s/n, < 171.00025).
If your DECADE II has a s/n < 17100025 DO NOT procede with the
installation of the DCC kit, but please contact the manufacturer. In that
case the DECADE II should be upgraded at the factory.
There are three versions of the DECADE II DCC kit available. The particular
kit required for the upgrade of your detector is depending on the serial
number of the DECADE II.
P/n Description
171.0216 DECADE II DCC upgrade kit, s/n 92 -
171.0218 DECADE II DCC upgrade kit, s/n 72 - 91
171.0220 DECADE II DCC upgrade kit, s/n 25 - 71
Depending on the upgrade kit purchased some of the installation steps
can be skipped. Please follow further instructions in the description of
the installation procedure on page 11 of this manual.
