Antec EarthWatts 350 Green Bedienungsanleitung

EARTHWATTS 350 GREEN

POWER SUPPLY

USER’S MANUAL

V1.0

USER’S MANUAL

EARTHWATTS SERIES

EA-350 GREEN POWER SUPPLY

THE ENERGY-EFFICIENT PSU

Get the power you need and the low electric bill you want with Antec’s EarthWatts 350 Green! One of

the most environmentally friendly power supplies on the planet, the EA-350 Green delivers 350 watts of

reliable, continuous power while meeting the Bronze level of performance from 80 PLUS®, the most

widely recognized independent standard in power supply efficiency.

STANDARDS AND FEATURES

The EA-350 Green PSU is compatible with ATX12V v2.32 and EPS12V v2.91 specifications. This PSU

features Universal Input, which automatically senses when you connect the power supply to any AC

power source between 100 ~ 240V, eliminating the need to set a voltage switch. The EA-350 Green also

features Active Power Factor Correction (Active PFC), which improves the power factor value of the PSU

by altering the input current wave shape, helping to transmit energy across the grid.

SYSTEM PROTECTION

A variety of industrial-grade safety circuitry will help protect your computer: OCP (Over Current

Protection), OVP (Over Voltage Protection), SCP (Short Circuit Protection), OPP (Over Power Protection)

and OTP (Over Temperature Protection). Sometimes the PSU will “latch” into a protected shutdown state.

This means that you will need to power off the PSU and clear the fault before it will function again. There

are no user-replaceable fuses in your EA-350 Green.

80 PLUS® BRONZE CERTIFICATION

80 PLUS® Bronze certification is among the highest

independent standards in power supply efficiency. This

allows the PSU to use less energy and generate less heat

so it stays cooler, runs more quietly, and lasts longer. The

EA-350 Green has been certified to be at least 82%

efficient at a wide range of operating loads and will

lower your operating costs while protecting the

environment.

Source: 80 PLUS Verification and Testing Report

DUAL +12 VOLT RAIL DISTRIBUTION

The EA-350 Green PSU uses dual +12 volt power rails. Different connectors are hooked up to separate

circuits to aid in the balanced distribution of power between devices in your computer. The +12V rails

have been assigned to different connectors, as shown in Table 2, to prevent voltage sags in one device

due to sudden demands for power by another device.

TABLE 2: POWER CONNECTORS AND RAIL ASSIGNMENTS

POWER OUTPUT

The EA-350 Green PSU distributes a varying maximum number of amps on each rail. To see the output

capacity and regulation for each different voltage, see Table 3.

Power Connectors

Description

+12V Rail

24(20+4)-pin main connector

1 x 8(4+4)-pin ATX12V / EPS12V

1 x 6-pin PCI-E

3 x Molex

3 x SATA

Floppy

TABLE 3: OUTPUT CAPACITY AND REGULATION

Output

Voltage

Load Max.

Regulation

Ripple & Noise

+3.3V

16A

±5%

40mV

+5V

16A

±5%

40mV

+12V1

18A

±5%

80mV

+12V2

18A

±5%

80mV

–12V

0.3A

±10%

120mV

+5Vsb

2.5A

±5%

40mV

The continuous maximum total output power shall not exceed 350W.

+12V1and +12V2DC maximum output power shall not exceed 330W.

+3.3V and +5V DC maximum combined output power shall not exceed 105W.

INSTALLATION:

1. Install the EA-350 Green PSU into your case with the four screws provided.

2. Connect the 24-pin main power connector to your motherboard. If your motherboard

uses a 20-pin connector, detach the 4-pin attachment on the 24-pin connector.

Note: The detachable 4-pin section cannot be used in place of a 4-pin +12V connector.

3. Connect the 8-pin or 4-pin ATX12V connector for the CPU to the appropriate connector

on your motherboard. If your motherboard has an 8-pin socket with a cover on some of

the openings, we recommend that you remove the cover and use the 8-pin connector.

Note: Please also refer to your motherboard user’s manual for any special instructions.

4. Connect the PCI-E connector(s) to your graphics card(s), if applicable.

5. Connect all Molex/SATA connector(s) to your hard drives, optical drives

(CD/DVD/BluRay™) and other accessories. Please note that some devices will use either

the older 4-pin Molex connectors, while others will use the newer 5-pin SATA connector.

4-pin Molex connectors have two black wires, a yellow, and a red. The SATA connector

has an additional orange power wire.

6. Connect your floppy drive (if present) using the supplied FDD connector shown in Table

7. Connect an AC power cord to the power supply AC inlet. Turn the switch to the “|”

position after you have connected all the devices and are ready to turn on your

computer.

Antec, Inc.

47900 Fremont Blvd.

Fremont, CA 94538

tel: 510-770-1200

fax: 510-770-1288

Antec Europe B.V.

Stuttgartstraat 12

3047 A Rotterdam

Netherlands

tel: +31 (0) 10 462-2060

fax: +31 (0) 10 437-1752

Technical Support:

US & Canada

1-800-22ANTEC

customersupport@antec.com

Europe

+49-40-226-139-2

europe.techsupport@antec.com

www.antec.com

Specifications are subject to change without prior notice.

Actual product and accessories may differ from illustrations.

Omissions and printing errors excepted.

Content of delivery might differ in different countries or areas.

Some trademarks may be claimed as the property of others.

Inhaltsverzeichnis

Andere Antec Stromversorgung Handbücher

Antec

Antec TRUEPOWER TP-650 Bedienungsanleitung

Antec

Antec Micro ATX2.01 Bedienungsanleitung

Antec

Antec SmartPower 4 Serial-ATA Bedienungsanleitung

Antec

Antec HCG-620 Bedienungsanleitung

Antec

Antec TP-650C TRUEPOWER Classic Bedienungsanleitung

Antec

Antec HCP-1200 Bedienungsanleitung

Antec

Antec PowerUp 6000 Bedienungsanleitung

Antec

Antec Basiq 550 Plus Bedienungsanleitung

Antec

Antec VP350P Bedienungsanleitung

Antec

Antec TRUEPOWER NEW TP-550 Bedienungsanleitung

Antec

Antec TruePower Classic TP-450C Bedienungsanleitung

Antec

Antec NEO ECO 620C Bedienungsanleitung

Antec

Antec Basiq BP550 PLUS Bedienungsanleitung

Antec

Antec HCG-750 Bedienungsanleitung

Antec

Antec Mini P180 White Bedienungsanleitung

Antec

Antec TRUEPOWER TP2-550EPS12V Bedienungsanleitung

Antec

Antec TruePower 2.0 Gebrauchsanweisung

Antec

Antec HCG-850M Bedienungsanleitung

Antec

Antec HCG-520M Bedienungsanleitung

Antec

Antec Veris Fusion 430 Bedienungsanleitung

Antec

Antec EARTHWATTS 650 GREEN Bedienungsanleitung

Antec

Antec VP450F Bedienungsanleitung

Antec

Antec NSK 1380 Service-Handbuch

Antec

Antec EA-550 PLATINUM Bedienungsanleitung

Beliebte Stromversorgung Handbücher anderer Marken

Monacor

Monacor PS-12CCD Bedienungsanleitung

VOLTIMA

VOLTIMA MagicBox 15 Bedienungsanleitung

Miller

Miller Auto Deltaweld 452 Bedienungsanleitung

BCP

BCP PUOUBK Merkblatt

HC 2210 Bedienungsanleitung

Agilent Technologies

Agilent Technologies 6032A Bedienungsanleitung

Puls

Puls CT5.241 Bedienungsanleitung

OCZ

OCZ ZX1250W Bedienungsanleitung

iseg

iseg ECH 238 Bedienungsanleitung

Agilent Technologies

Agilent Technologies 6631B Bedienungsanleitung

Power

Power XXL A Series Bedienungsanleitung

Renogy

Renogy PHOENIX 300 Bedienungsanleitung

HP 6200B Service-Handbuch

Epson

Epson Stylus Scan 2500 Betriebsanleitung

Pulsar

Pulsar GREEN POWER CCTV PoE POE044816 Bedienungsanleitung

Puls

Puls MiniLine ML50.100 Bedienungsanleitung

Puls

Puls AS-Interface SLA4.100 Bedienungsanleitung

Kenwood

Kenwood PS-60 Bedienungsanleitung