APEN GROUP SPA reserves the right to make changes deemed to be required to its products or documentation
AH-New condensing air handling unit
4
code HG0310.05GB ed.A-2010 AH 5code HG0310.05GB ed.A-2010
AH
HG0030.00_IM 001
2.3. Power supply
Cautions:
•
• Check that the mains power supply is the same as the
power input stated on the equipment nameplate and in
this manual.
•
to the mains power supply with a plug-socket only if the
•
•
sources.
NOTE: It is compulsory to install, upstream of the
power cable, a switch with a protection (fuses or
automatic), as required by existing regulations.
The switch must be visible, accessible and placed
at a distance lower than 3 metres from the control
compartment;anyelectricaloperation(installation
and maintenance) must be performed by qualied
sta.
2.4. Use
Do not allow children or inexperienced people to use any
electrically powered equipment.
T
• do not touch the equipment with wet or damp parts of your
•
sun etc...) unless it is adequately protected;
• do not use the gas pipes to earth electrical equipment;
•
•
• do not touch the moving parts of the unit.
open the main electrical switch of the thermal station and close
•
from the main switch;
• close the manual valve on the duct supplying fuel to the
2.5. Air Vents
provided with one or more air vents.
• to the ceiling for gases with density lower than 0.8;
•
2
maximum output rate and the room ventilated only through the
closed. C02
the same time.
•
•
that prevents water from penetrating into the machine.
DO NOT COVER IT WITH YOUR HAND OR OTHER
OBJECTS!
