10
3. CLOSING THE FRONT SECTION
To close the front section follow the instructions below. If necessary, consult
Figures 7 to 12.
3.1. Remove the hitch pins from the front section. Fig. 1
3.2. Remove the tipping pin. Fig. 7
3.3. Disconnect the electrical wiring harness between the front section and
the tongue.
OBSERVATION:
Not disconnecting the electrical wiring harness between the front section
and the tongue before closing the front section of the trailer could damage
the harness.
CAUTION:
If the tailgate pins are not in position, the tailgate may open when you attempt
to lift up the front section.
3.4. Put one foot on the tongue then lift and close the front section.
Fig. 8 and Fig. 9
3.5. As you did when closing the rear section, put the hitch pins in their corre-
sponding storage location. Fig. 10
3.6. Tip the trailer onto the stops of the rear section. This removes the
weight of the trailer from the tongue making it easier to remove
the tongue pin. Fig. 11
3.7. Completely remove the tongue pin. Fig. 12
3.8. In order not to lose the tipping pin and tongue pin, put them back into
their corresponding positions on the trailer.
WARNING:
Always check that the hitch pins are in their proper position when the trailer is
in the closed or open position.
