Aprilaire 65 Bedienungsanleitung

Model 65 Humidifier Control

Installation Instructions

READ AND SAVE THESE INSTRUCTIONS

CAUTION

1. Read all instructions before beginning installation.

2. Do not adjust humidity set-point above recommended level or to recommended

level if condensation occurs on inside surface of windows or on other surfaces.

Excess condensation can cause damage to structure or furnishings. Excess

moisture can also allow the possibility for mold growth to occur.

3. Do not use solvents or cleaners on or near the display and circuit board.

Chemicals can damage components.

WARNING

1. Improper installation may cause property damage or injury. Installation, service,

and maintenance must be performed by a qualiﬁed service technician.

2. 120 Volts may cause serious injury from electric shock. Disconnect electrical

power before starting installation or servicing. Leave power disconnected until

installation/service is completed. This control is not a 120 Volt (line voltage)

device.

SAFETY INSTRUCTIONS

The Model 65 is for use with any humidifier

requiring an ON/OFF signal for a 24 volt circuit.

61000790B AA Model 65 Humidifier Control Install.indd 1 10/12/11 9:47 AM

TABLE OF CONTENTS

Safety Instructions.................. 1

Overview .......................... 2

Specifications...................... 2

Materials Provided ................. 3

Location Recommendations ......... 3

Installation

Mount Control . . . . . . . . . . . . . . . . . . . . . 4

Wiring ........................... 5

System Checkout

Power Up ......................... 9

Test Mode ....................... 10

Humidity Setting .................. 10

Offset ........................... 10

Turning On and Setting Control....... 11

Sequence of Operation ............. 11

Troubleshooting

Error Codes ...................... 11

Troubleshooting Guide.............. 12

OVERVIEW

The Aprilaire®Model 65 Humidifier Control provides control of the humidifier from the living

space. The control allows the homeowner to set and adjust the humidity setting and turn

the humidifier on or off from a convenient location. The Model 65 uses an onboard sensor to

monitor the relative humidity in the space in which it is located and displays the measured

relative humidity on the digital display.

ELECTRICAL

Input Voltage and Current Voltage: 24V AC +/-20%

Current: 25mA (nominal), 50mA (max.) at 24V AC

Output Dry Contact, Normally Open – H Terminals

SPECIFICATIONS

CONTROL

Humidity Setting Range 10% – 50% RH

Accuracy +/-5% RH

Differential 3%

Low Temp 40°F

High Temp 99°F

61000790B AA Model 65 Humidifier Control Install.indd 2 10/12/11 9:47 AM

LOCATION RECOMMENDATIONS

MOUNT CONTROL

•Inanareathehomeownerwantsto

monitor and control moisture levels.

•Onaninteriorwall.

•Approximately5’offthefloor.

•Atleast18”fromanoutsidewall.

See Figure 1.

DO NOT MOUNT CONTROL

• Intheflowofasupplyregister.

•Behinddoors,incornersorotherdeadairspaces.

•Indirectsunlight,nearlightingfixtures,orother

appliances that give off heat.

•Onanoutsideorunconditionedareawall.

•Instairwellsornearoutsidedoors.

•Onawallwithconcealedpipesorductwork.

FIGURE 1 – Mounting Location

90-1666

MATERIALS PROVIDED

•Wall-MountControl

•MountingScrews

•DrywallAnchors

•RHSettingLabel

MATERIALS NOT PROVIDED

•Wires

•WireNuts

A self-adhesive label (RH Setting Label) showing recommended RH settings based on outdoor

temperature is provided. The label can be attached to the front of the control to serve as a

guideline and a reminder for the homeowner to adjust the RH setting as outdoor temperature

changes.

61000790B AA Model 65 Humidifier Control Install.indd 3 10/12/11 9:47 AM

INSTALLATION

MOUNT CONTROL

PULL APART

FRONT COVER

BACK

PLATE

RH SETTING

LABEL

FIGURE 2 – Disassemble Control

90-1667

See Figures 2 & 3.

1. Remove front cover by pulling straight out.

2.Positionthebackplateonthewallandmarkthelocationsforthewireaccessholeandthe

mounting screws. NOTE:Themountingholescanalsobeusedtosecurethebackplatetoa

standard horizontally mounted junction box.

3.Formountingondrywall,drilltwo3/16”dia.mountingholesanda3/4”openingforthewires.

4. Insert the drywall anchors provided into the mounting holes flush with the wall surface.

5. Run 4-wire cable from the humidifier to the control location.

6.Securebackplateusingthetwo#8x1-1/2”screwsprovided.

7.Afterconnectingthewires,tuckexcesswireintothewallandfilltheopeningwithinsulating

material. Failure to seal the opening may result in inaccurate operation due to drafts.

61000790B AA Model 65 Humidifier Control Install.indd 4 10/12/11 9:47 AM

BACK PLATE

ANCHOR

SCREW

MOUNTING HOLES

WIRE ACCESS OPENING

4-CONDUCTOR WIRE

FIGURE 3 – Mount Back Plate

90-1668

WIRING

WIRING – Model 65 with Aprilaire Model 400, 500, 600, and 700 Series

Evaporative Humidifiers

The Model 65 control requires 24VAC. Drawing power from the HVAC system is the

recommended method for this installation. See Figures 4 & 5.

1. Disconnect power to the humidifier and HVAC system.

2. Connect the C and R terminals on the Model 65 to the HVAC or thermostat C and R terminals.

3. Connect Model 65 H terminals to the humidifier solenoid valve control circuit as shown.

4.Snapthefrontcoverontothebackplate.The4-pinterminalalignswiththeterminalblock

receptacleonthebackplate.

5. Proceed to SYSTEM CHECKOUT on page 9.

61000790B AA Model 65 Humidifier Control Install.indd 5 10/12/11 9:47 AM

APRILAIRE

EVAPORATIVE

HUMIDIFIER

SOLENOID VALVE

CIRCUIT WIRES

ACCESSORY

TERMINALS

MODEL 65 CONTROL HVAC EQUIPMENT

FIGURE 4 – Recommended Wiring for Model 65 Control and Evaporative Humidifier

90-1669

APRILAIRE

EVAPORATIVE

HUMIDIFIER

SOLENOID VALVE

CIRCUIT WIRES

MODEL 65 CONTROL HVAC EQUIPMENT

24VAC

CONTINUOUSLY

POWERED

TRANSFORMER

COMMON

MOTOR

LEAD

HVAC BLOWER

MODEL 50

RELAY

FIGURE 5 – Alternate Wiring for Model 65 Control and Evaporative Humidifier

90-1671

61000790B AA Model 65 Humidifier Control Install.indd 6 10/12/11 9:47 AM

WIRING – Model 65 with Model 800 Steam Humidifier

The Model 65 control requires 24VAC. See Figure 6.

1.DisconnectpowerfromtheModel800andHVACsystem.

2. Connect 24VAC to the C and R terminals on the Model 65.

3.ConnecttheHterminalsontheModel800totheHterminalsontheModel65.

4.SnaptheModel65frontcoveronthebackplate.The4-pinterminalalignswiththeterminal

blockreceptacleonthebackplate.

5. Proceed to SYSTEM CHECKOUT on page 9.

NOTE:IftheModel800SteamHumidifierisinstalledwithaModel850FanPack,theModel

65Controlcanbepoweredfromthe24VACsecondarywiresontheModel800transformer,by

splicing into the wires using tap connectors. See Figure 7.

MODEL 800

STEAM HUMIDIFIER

MODEL 65 CONTROL

HVAC EQUIPMENT

HUMIDISTAT

TERMINALS

COMMON

MOTOR LEAD MODEL 50

RELAY

HVAC BLOWER

FIGURE 6 – Recommended Wiring for Model 65 Control

and Model 800 Steam Humidifier

90-1672

61000790B AA Model 65 Humidifier Control Install.indd 7 10/12/11 9:47 AM

FAN PACK HUMIDISTAT

TRANSFORMER

24VAC

24V COM

MODEL 850 STEAM HUMIDIFIER FAN PACK

MODEL 65

DIGITAL CONTROL

APRILAIRE MODEL 800 HUMIDIFIER

WIRE – 18 AWG ACCEPTABLE FOR

24 VAC APPLICATION.

TAP CONNECTORS

CIRCUIT BOARD

TRANSFORMER

FIGURE 7 – Recommended Wiring for Model 65 Control and Model 800 Steam

Humidifier with Model 850 Fan Pack

90-1662

61000790B AA Model 65 Humidifier Control Install.indd 8 10/12/11 9:47 AM

SYSTEM CHECKOUT

POWER UP

1.Checkallwiring.

2. Restore power to the HVAC system and humidifier.

3. After a 4 second start up sequence all buttons on the Model 65 will be functional.

 •ThecontrolwillbeOFF.

 •Thehumiditysettingwillbe30%.

 •Thecontrolwilldisplaythemeasuredhumidity.

FIGURE 8

90-1670

Model 65 Control

Model 65 LCD Display

Blinking ON +*: Temp Limits Exceeded.

See Operating Limits, page 11.

Solid ON:

Control On

Blinking ON:

Humidifying

Measured

Humidity or

Setting

Control On/Off

Humidity Setting

and Offset

Adjustment

Control must be

ON to adjust offset

and setting.

SET: Shows when

humidity setting is

displayed or being

changed.

OFF: Control Off

61000790B AA Model 65 Humidifier Control Install.indd 9 10/12/11 9:47 AM

TEST MODE

1. Press and hold the ON button for 5 seconds to enter Test Mode.

 a.VerifyallLCDsegmentsblinkeverysecond.

b. Verify humidifier turns on.

2. After 5 minutes or after pressing the OFF button, the control will enter Off mode.

Verify the humidifier turns off.

HUMIDITY SETTING

•ThecontrolmustbeONtoadjustthehumiditysetting.

•The (up) and (down) buttons are used to increase or decrease the humidity setting.

•ThefirstpressofeitherbuttonwilldisplaythecurrentsettingontheLCDdisplayandSET

will be displayed below the % sign.

•Eachsubsequentpushoftheupordownbuttonswillchangethesettingby1%.

•Ifabuttonishelddown,thesettingwillcontinuallychangeby1%every1/2secondforas

long as the button is pressed.

•ThecontrolwillreturntoNormalMode,displayingthemeasuredhumidity,5secondsafter

the last button press/release.

OFFSET

An offset can be applied to the humidity reading to

avoid discrepancies with other humidity measuring

devicesinthehome.Allow48hoursforthecontrolto

acclimate before applying an offset. The control must

be ON to enter the Offset screen.

•PressandholdtheOFFbuttonfor5secondsto

enter the Offset screen. See Figure 9.

•The buttons can be used to set an offset

value between -5% RH and +5% RH.

•ThecontrolwillreturntoNormalMode,displaying

the measured humidity, 5 seconds after the last

button press/release.

FIGURE 9 – Offset Screen

90-1638

61000790B AA Model 65 Humidifier Control Install.indd 10 10/12/11 9:47 AM

Andere Handbücher für 65

Inhaltsverzeichnis

Andere Aprilaire Steuereinheit Handbücher

Aprilaire

Aprilaire 76C Bedienungsanleitung

Aprilaire

Aprilaire Premium Digital Humidifier Control Einrichtungshandbuch

Aprilaire

Aprilaire 70 Living Space Control Bedienungsanleitung

Aprilaire

Aprilaire 76 Bedienungsanleitung

Aprilaire

Aprilaire 65 Bedienungsanleitung

Aprilaire

Aprilaire 1700 Bedienungsanleitung

Beliebte Steuereinheit Handbücher anderer Marken

Festo

Festo Compact Performance CP-FB6-E Stücklistenhandbuch

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung

JS Automation

JS Automation MPC3034A Bedienungsanleitung

JAUDT

JAUDT SW GII 6406 Series Kurzanleitung

Spektrum

Spektrum Air Module System Bedienungsanleitung

BOC Edwards

BOC Edwards Q Series Bedienungsanleitung

KHADAS

KHADAS BT Magic Bedienungsanleitung

Etherma

Etherma eNEXHO-IL Bedienungsanleitung

PMFoundations

PMFoundations Attenuverter Bedienungsanleitung

GEA

GEA VARIVENT Bedienungsanleitung

Walther Systemtechnik

Walther Systemtechnik VMS-05 Bedienungsanleitung

Altronix

Altronix LINQ8PD Montageanleitung

Eaton

Eaton Powerware Series Bedienungsanleitung

WAGO

WAGO 750-407/040-000 Bedienungsanleitung

Sony

Sony CCU-590 Bedienungsanleitung

Graco

Graco 25D614 Bedienungsanleitung

Task Force Tips

Task Force Tips YE-RF-900 Programmierhandbuch

Shini

Shini SPV-U Series Bedienungsanleitung