Clip-On Light - drip loop
POWER
SUPPLY
CORD
DRIP LOOP
AQUARIUM
APPLIANCE
IMPORTANT SAFETY INSTRUCTIONS
WARNING – To guard against injury, basic safety precautions should be observed including the
following:
1.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
2. DANGER – To avoid possible electric shock, special care should be taken since water is employed
in the use of aquarium equipment. For each of the following situations, do not attempt to
repair yourself; return the appliance to an authorized service facility for service or discard the
appliance:
A. If the appliance falls into the water, DON'T reach for it! First unplug it and then retrieve it. If
electrical components of the appliance get wet, unplug the appliance completely.
B. Carefully examine the appliance after installation. It should not be plugged in if there is water
on the parts not intended to be wet.
C. Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or if it
is dropped or damaged in any manner.
D. To avoid the possibility of the appliance plug or receptacle getting wet, position aquarium
stand and tank to one side of the wall-mounted receptacle to prevent water from dripping
onto the receptacle or plug. As shown in the figure, a “drip loop” should be arranged by the
user for each cord connecting an aquarium appliance to the receptacle. The “drip loop” is
the part of the cord below the level of the receptacle, or the connector if an extension cord is
used, to prevent water travel along the cord and coming in contact with the receptacle. If the
plug or the receptacle does get wet,
DON’T unplug the cord. Disconnect the fuse to the circuit breaker that supplies power to the
appliance. Then unplug and examine for the presence of water in the receptacle.
3. Close supervision is necessary when any appliance is
used by or near children.
4. To avoid injury, do not contact moving parts or hot
parts such as heaters, reflectors, lamp bulbs, etc.
5. Always unplug an appliance from the outlet when
not in use, before putting on or taking off parts, and
before cleaning. Never yank the cord to pull plug from
the outlet. Grasp the plug and pull to disconnect.
6. Do not use an appliance for other than intended use.
The use of attachments not recommended or sold
by the appliance manufacturer may cause an unsafe
condition.
7. Do not install or store the appliance where it will be
exposed to the weather or to temperatures below
freezing.
8. Make sure an appliance mounted on a tank is securely
installed before operating it.
9. Read and observe all the important notices on the
appliance.
10. If an extension cord is necessary, a cord with a proper
rating should be used. A cord rated for less amperes
or watts than the appliance rating may overheat. Care
should be taken to arrange the cord so that it will not
be tripped over or pulled.
11. This appliance is recommended for use over a glass aquarium cover or panel. The appliance is
intended FOR HOUSEHOLD USE ONLY.
ONLY FOR POLARIZED ATTACHMENT PLUG APPLIANCES
12. If this appliance has a polarized plug (one blade is wider than the other) as a safety feature, this
plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord
unless plug can be fully inserted. Do not attempt to defeat this safety feature.
13.
SAVE THESE INSTRUCTIONS
