Arbor Technology ARES-1965 Bedienungsanleitung

ARES-1965

Machine Vision Controller with 6th/7th Gen.

Intel®Core™ Processor

User’s Manual

Version 1.0

2019.03

P/N: 4016196500100P

- II -

Revision History

Version Date Description

1.0 2019.03 Initial release

- i -

Contents

Revision History ................................................................................II

Contents..............................................................................................i

Preface...............................................................................................iii

Declaration of Conformity .......................................................................iii

CE....................................................................................................iii

FCC Class A ....................................................................................iii

RoHS .............................................................................................. iv

SVHC / REACH .............................................................................. iv

Important Safety Instructions .................................................................. v

Warning.................................................................................................. vi

Lithium Battery Replacement................................................................. vi

Technical Support .................................................................................. vi

Warranty.................................................................................................vii

Chapter 1 - Introduction....................................................................1

1.1. Features...........................................................................................2

1.2. About this Manual ............................................................................2

1.3. Specications...................................................................................3

1.4. Inside the Package ..........................................................................5

Chapter 2 - Getting Started...............................................................7

2.1. Dimensions ......................................................................................8

2.2. Tour the Computer ...........................................................................9

2.3. LED Status.....................................................................................10

2.4. Driver Installation ...........................................................................10

Chapter 3 - Engine of the Computer.............................................. 11

3.1. Main Board - FMB-i89U2 ...............................................................12

3.1.1. Jumpers ..............................................................................14

3.1.2. Connectors .........................................................................15

3.2. Daughter Board - SCDB-348B / SCDB-348C ................................20

Chapter 4 - Installation and Maintenance......................................23

4.1. Disassembling and Assembling the Computer ..............................24

4.1.1. Disassembling the Computer............................................... 24

4.1.2. Assembling the Computer....................................................26

4.2. Installing Hardware ........................................................................28

4.2.1. Installing Memory Module....................................................28

4.2.2. Installing mSATA Module .....................................................28

4.3. Mounting ........................................................................................30

4.3.1 Wall Mount............................................................................ 30

4.3.2 DIN-Rail Mounting ...............................................................31

Contents

- ii -

Contents

4.4. Ground the Computer ....................................................................32

4.5. Wire DC-in Power Source..............................................................33

Chapter 5 - BIOS..............................................................................35

5.1. Main ...............................................................................................38

5.2. Advanced ....................................................................................... 39

5.2.1. CPU Conguration...............................................................40

5.2.2. PCI Sybsystem Settings ......................................................41

5.2.3. ACPI Settings.......................................................................42

5.2.4. F871869A Super IO Conguration....................................... 43

5.2.5. Hardware Monitor ................................................................44

5.2.6. S5 RTC Wake Settings ........................................................45

5.2.7. Serial Port Console Conguration .......................................46

5.2.8. SATA Conguration..............................................................47

5.2.9. CSM Conguration ..............................................................48

5.2.10. USB Conguration .............................................................49

5.3. Chipset...........................................................................................51

5.3.1. System Agent (SA) Conguration ........................................52

5.3.2. PCH-IO Conguration..........................................................55

5.4. Security ..........................................................................................57

5.5. Boot................................................................................................58

5.6. Save & Exit ....................................................................................59

Appendix ..........................................................................................61

Appendix A. 32-bit DIO Signal Connections ......................................... 62

A.1. Isolated Digital Input Connections..........................................62

A.2. Isolated Digital Output Connections.......................................63

- iii -

Preface

The information in this document is subject to change without prior notice in

order to improve the reliability, design and function. It does not represent a

commitment on the part of the manufacturer.

Under no circumstances will the manufacturer be liable for any direct, indirect,

special, incidental, or consequential damages arising from the use or inability

to use the product or documentation, even if advised of the possibility of such

damages.

This document contains proprietary information protected by copyright. All rights

are reserved. No part of this document may be reproduced by any mechanical,

electronic, or other means in any form without prior written permission of the

manufacturer.

Declaration of Conformity

The CE symbol on your product indicates that it is in compliance with the

directives of the Union European (EU). A Certicate of Compliance is available

by contacting Technical Support.

This product has passed the CE test for environmental specications when

shielded cables are used for external wiring. We recommend the use of shielded

cables. This kind of cable is available from ARBOR. Please contact your local

supplier for ordering information.

Warning

This is a class A product. In a domestic environment this product may cause

radio interference in which case the user may be required to take adequate

measures.

FCC Class A

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference

that may cause undesired operation.

- iv -

Preface

NOTE:

This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to

cause harmful interference in which case the user will be required to correct the

interference at his own expense.

RoHS

ARBOR Technology Corp. certies that all components in its products are

in compliance and conform to the European Union’s Restriction of Use of

Hazardous Substances in Electrical and Electronic Equipment (RoHS) Directive

2002/95/EC.

The above mentioned directive was published on 2/13/2003. The main purpose

of the directive is to prohibit the use of lead, mercury, cadmium, hexavalent

chromium, polybrominated biphenyls (PBB), and polybrominated diphenyl

ethers (PBDE) in electrical and electronic products. Member states of the EU are

to enforce by 7/1/2006.

ARBOR Technology Corp. hereby states that the listed products do not contain

unintentional additions of lead, mercury, hex chrome, PBB or PBDB that exceed

a maximum concentration value of 0.1% by weight or for cadmium exceed

0.01% by weight, per homogenous material. Homogenous material is dened as

a substance or mixture of substances with uniform composition (such as solders,

resins, plating, etc.). Lead-free solder is used for all terminations (Sn(96-96.5%),

Ag(3.0-3.5%) and Cu(0.5%)).

SVHC / REACH

To minimize the environmental impact and take more responsibility to the earth

we live, Arbor hereby conrms all products comply with the restriction of SVHC

(Substances of Very High Concern) in (EC) 1907/2006 (REACH --Registration,

Evaluation, Authorization, and Restriction of Chemicals) regulated by the

European Union.

All substances listed in SVHC < 0.1 % by weight (1000 ppm)

- v -

Preface

Important Safety Instructions

Read these safety instructions carefully

1. Read all cautions and warnings on the equipment.

2. Place this equipment on a reliable surface when installing. Dropping it or

letting it fall may cause damage

3. Make sure the correct voltage is connected to the equipment.

4. For pluggable equipment, the socket outlet should be near the equipment

and should be easily accessible.

5. Keep this equipment away from humidity.

6. The openings on the enclosure are for air convection and protect the

equipment from overheating. DO NOT COVER THE OPENINGS.

7. Position the power cord so that people cannot step on it. Do not place

anything over the power cord.

8. Never pour any liquid into opening. This may cause re or electrical shock.

9. Never open the equipment. For safety reasons, the equipment should be

opened only by qualied service personnel.

10. If one of the following situations arises, get the equipment checked by

service personnel:

a. The power cord or plug is damaged.

b. Liquid has penetrated into the equipment.

c. The equipment has been exposed to moisture.

d. The equipment does not work well, or you cannot get it to work according

to the user’s manual.

e. The equipment has been dropped or damaged.

f. The equipment has obvious signs of breakage.

11. Keep this User’s Manual for later reference.

- vi -

Preface

Warning

The Box PC and its components contain very delicately Integrated Circuits (IC).

To protect the Box PC and its components against damage caused by static

electricity, you should always follow the precautions below when handling it:

1. Disconnect your Box PC from the power source when you want to work on

the inside.

2. Use a grounded wrist strap when handling computer components.

3. Place components on a grounded antistatic pad or on the bag that came

with the Box PC, whenever components are separated from the system.

Lithium Battery Replacement

Incorrect replacement of the lithium battery may lead to a risk of explosion.

The lithium battery must be replaced with an identical battery or a battery type

recommended by the manufacturer.

Do not throw lithium batteries into the trash can. It must be disposed of in

accordance with local regulations concerning special waste.

Technical Support

If you have any technical difculties, please consult the user’s manual rst at:

http://www.arbor.com.tw

Please do not hesitate to call or e-mail our customer service when you still cannot

nd out the answer.

https://www.arbor-technology.com

E-mail:info@arbor.com.tw

- vii -

Preface

Warranty

This product is warranted to be in good working order for a period of one year

from the date of purchase. Should this product fail to be in good working order

at any time during this period, we will, at our option, replace or repair it at no

additional charge except as set forth in the following terms. This warranty does

not apply to products damaged by misuse, modications, accident or disaster.

Vendor assumes no liability for any damages, lost prots, lost savings or any

other incidental or consequential damage resulting from the use, misuse of, or

inability to use this product. Vendor will not be liable for any claim made by any

other related party.

Vendors disclaim all other warranties, either expressed or implied, including but

not limited to implied warranties of merchantability and tness for a particular

purpose, with respect to the hardware, the accompanying product’s manual(s)

and written materials, and any accompanying hardware. This limited warranty

gives you specic legal rights.

Return authorization must be obtained from the vendor before returned

merchandise will be accepted. Authorization can be obtained by calling or faxing

the vendor and requesting a Return Merchandise Authorization (RMA) number.

Returned goods should always be accompanied by a clear problem description.

- viii -

This page is intentionally left blank.

Inhaltsverzeichnis

Andere Arbor Technology Controller Handbücher

Arbor Technology

Arbor Technology ARES-1980 Series Bedienungsanleitung

Arbor Technology

Arbor Technology ARES-530WT Bedienungsanleitung

Arbor Technology

Arbor Technology ARES-1973 Series Bedienungsanleitung

Arbor Technology

Arbor Technology ELIT-1270 Bedienungsanleitung

Arbor Technology

Arbor Technology ARES-1231 Series Bedienungsanleitung

Arbor Technology

Arbor Technology ARES-5423-TP Bedienungsanleitung

Arbor Technology

Arbor Technology ARES-1970-E Bedienungsanleitung

Beliebte Controller Handbücher anderer Marken

Digiplex

Digiplex DGP-848 Betriebsanleitung

YASKAWA

YASKAWA SGM series Bedienungsanleitung

Sinope

Sinope Calypso RM3500ZB Bedienungsanleitung

Isimet

Isimet DLA Series Style 2 Installationshandbuch

LSIS

LSIS sv-ip5a Bedienungsanleitung

Airflow

Airflow Uno hab Bedienungsanleitung

ABB

ABB ACS580-01 drives Bedienungsanleitung

Panasonic

Panasonic GM1 Series Bedienungsanleitung

Emerson

Emerson SW93 Bedienungsanleitung

AutoAqua

AutoAqua Smart ATO micro SATO-120P Bedienungsanleitung

Panasonic

Panasonic FP? Positioning Unit RTEX Bedienungsanleitung

Alpha IP

Alpha IP MIOB 21001 Bedienungsanleitung

Siemens

Siemens OpenAir GMA 1 Series Bedienungsanleitung

Surecom

Surecom SR-629 Bedienungsanleitung

Regulus

Regulus SRS1 T Bedienungsanleitung

3M MicroTouch EX113 Bedienungsanleitung

KUHN

KUHN TKS Bedienungsanleitung

S&C

S&C PMH Bedienungs- und Wartungshandbuch