Arbor Technology ARTS-4770 Bedienungsanleitung
1
ARTS-4770
Fanless In-Vehicle Surveillance with Intel®Core i7-3517UE
User’s Manual
Version 1.0
2014.05
P/N: 4012477000100P
2
Revision History
Version Release Time Description
1.0 May 2014 Initial release
- i -
Contents
Preface........................................................................................... iii
Copyright Notice .......................................................................................iii
Declaration of Conformity .........................................................................iii
CE......................................................................................................iii
FCC Class A.......................................................................................iii
RoHS .................................................................................................iv
SVHC / REACH .................................................................................iv
Important Safety Instructions.................................................................... v
Warning .................................................................................................... v
Replacing Lithium Battery.........................................................................vi
Technical Support .....................................................................................vi
Warranty ..................................................................................................vii
Chapter 1 - Introduction................................................................ 1
1.1. Product Highlights ............................................................................. 2
1.2. About this Manual .............................................................................. 2
1.3. Specications .................................................................................... 3
1.5. Ordering Information.......................................................................... 5
1.5.1. Optional Accessories ............................................................... 5
1.5.2. Congure-to-Order Service...................................................... 5
Chapter 2 - Getting Started........................................................... 7
2.1. Dimensions........................................................................................ 8
2.2. Take A Tour ........................................................................................ 9
2.3. Driver Installation Notes .................................................................. 11
Chapter 3 - System Conguration ............................................. 13
3.1. Board Layout ................................................................................... 14
3.1.1. CPU Boards........................................................................... 14
3.1.2. Carrier Board ......................................................................... 16
3.2. Jumpers and Connectors ................................................................ 18
3.2.1. Jumpers ................................................................................. 18
3.2.2. Connectors............................................................................. 21
Chapter 4 - Installation and Maintenance.................................. 43
4.1. Install Hardware............................................................................... 44
4.1.1. Open the Computer ............................................................... 44
4.1.2. Install/uninstall SIM Card ....................................................... 45
4.1.3. Install SATA HDD/SSD .......................................................... 47
4.1.4. Disassemble SSD bracket .................................................... 49
4.1.5. Install Memory Module on CPU Module ................................ 50
4.2. Mount the Computer........................................................................ 51
4.3. Wire DC-in Power Source................................................................ 53
4.31 Vehicle Application .................................................................. 53
4.3.2 Automation Application............................................................ 54
- ii -
Contents
Chapter 5 - BIOS.......................................................................... 55
5.1. ARTS-4770 BIOS............................................................................. 58
5.1.1. Main ....................................................................................... 58
5.1.2. Advanced ............................................................................... 59
5.1.3. Chipset................................................................................... 69
5.1.4. Boot........................................................................................ 74
5.1.5. Security.................................................................................. 76
5.1.6. Save & Exit ............................................................................ 77
Appendices .................................................................................. 79
Appendix A: HSPA-SI1400 Hardware Installation................................... 80
C.1. Install HSPA-SI1400................................................................. 80
Appendix B: WIFI-AT2350 Hardware Installation ................................... 85
D.1. Install WIFI-AT2350.................................................................. 85
Appendix C: GPS Module Hardware Installation.................................... 90
- iii -
Preface
Copyright Notice
All Rights Reserved.
The information in this document is subject to change without prior notice in order to
improve the reliability, design and function. It does not represent a commitment on the
part of the manufacturer.
Under no circumstances will the manufacturer be liable for any direct, indirect, special,
incidental, or consequential damages arising from the use or inability to use the product
or documentation, even if advised of the possibility of such damages.
This document contains proprietary information protected by copyright. All rights are
reserved. No part of this document may be reproduced by any mechanical, electronic, or
other means in any form without prior written permission of the manufacturer.
Declaration of Conformity
CE
The CE symbol on the computer indicates that it is in compliance with the directives of
the Union European (EU). A Certicate of Compliance is available by contacting Technical
Support.
This product has passed the CE test for environmental specications when shielded
cables are used for external wiring. We recommend the use of shielded cables. This
kind of cable is available from ARBOR. Please contact your local supplier for ordering
information.
Warning
This is a class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.
FCC Class A
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Preface
- iv -
Preface
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
RoHS
ARBOR Technology Corp. certies that all components in its products are in compliance
and conform to the European Union’s Restriction of Use of Hazardous Substances in
Electrical and Electronic Equipment (RoHS) Directive 2002/95/EC.
The above mentioned directive was published on 2/13/2003. The main purpose of
the directive is to prohibit the use of lead, mercury, cadmium, hexavalent chromium,
polybrominated biphenyls (PBB), and polybrominated diphenyl ethers (PBDE) in electrical
and electronic products. Member states of the EU are to enforce by 7/1/2006.
ARBOR Technology Corp. hereby states that the listed products do not contain
unintentional additions of lead, mercury, hex chrome, PBB or PBDB that exceed a
maximum concentration value of 0.1% by weight or for cadmium exceed 0.01% by
weight, per homogenous material. Homogenous material is dened as a substance or
mixture of substances with uniform composition (such as solders, resins, plating, etc.).
Lead-free solder is used for all terminations (Sn(96-96.5%), Ag(3.0-3.5%) and Cu(0.5%)).
SVHC / REACH
To minimize the environmental impact and take more responsibility to the earth we live,
Arbor hereby conrms all products comply with the restriction of SVHC (Substances of
Very High Concern) in (EC) 1907/2006 (REACH --Registration, Evaluation, Authorization,
and Restriction of Chemicals) regulated by the European Union.
All substances listed in SVHC < 0.1 % by weight (1000 ppm)
- v -
Preface
Important Safety Instructions
Read these safety instructions carefully
1. Read all cautions and warnings on the equipment.
2. Place this equipment on a reliable surface when installing. Dropping it or letting it fall
may cause damage
3. Make sure the correct voltage is connected to the equipment.
4. For pluggable equipment, the socket outlet should be near the equipment and should
be easily accessible.
5. Keep this equipment away from humidity.
6. The openings on the enclosure are for air convection and protect the equipment
from overheating. DO NOT COVER THE OPENINGS.
7. Position the power cord so that people cannot step on it. Do not place anything over
the power cord.
8. Never pour any liquid into opening. This may cause re or electrical shock.
9. Never open the equipment. For safety reasons, the equipment should be opened
only by qualied service personnel.
10. If one of the following situations arises, get the equipment checked by service
personnel:
a. The power cord or plug is damaged.
b. Liquid has penetrated into the equipment.
c. The equipment has been exposed to moisture.
d. The equipment does not work well, or you cannot get it to work
according to the user’s manual.
e. The equipment has been dropped or damaged.
f. The equipment has obvious signs of breakage.
11. Keep this User’s Manual for later reference.
Product Heat
The computer generates heat during operation. Contact the computer's
chassis with your body could cause discomfort or even a skin burn.
Warning
- vi -
Preface
The Box PC and its components contain very delicately Integrated Circuits (IC). To protect
the Box PC and its components against damage caused by static electricity, you should
always follow the precautions below when handling it:
1. Disconnect your Box PC from the power source when you want to work on the inside.
2. Use a grounded wrist strap when handling computer components.
3. Place components on a grounded antistatic pad or on the bag that came with the Box
PC, whenever components are separated from the system.
Replacing Lithium Battery
Incorrect replacement of the lithium battery may lead to a risk of explosion.
The lithium battery must be replaced with an identical battery or a battery type
recommended by the manufacturer.
Do not throw lithium batteries into the trash can. It must be disposed of in
accordance with local regulations concerning special waste.
Technical Support
If you have any technical difculties, please consult the user’s manual rst at:
ftp://ftp.arbor.com.tw/pub/manual
Please do not hesitate to call or e-mail our customer service when you still cannot nd
out the answer.
http://www.arbor.com.tw
E-mail:info@arbor.com.tw
- vii -
Preface
Warranty
This product is warranted to be in good working order for a period of one year from the
date of purchase. Should this product fail to be in good working order at any time during
this period, we will, at our option, replace or repair it at no additional charge except as set
forth in the following terms. This warranty does not apply to products damaged by misuse,
modications, accident or disaster.
Vendor assumes no liability for any damages, lost prots, lost savings or any other
incidental or consequential damage resulting from the use, misuse of, or inability to use
this product. Vendor will not be liable for any claim made by any other related party.
Vendors disclaim all other warranties, either expressed or implied, including but not limited
to implied warranties of merchantability and tness for a particular purpose, with respect
to the hardware, the accompanying product’s manual(s) and written materials, and any
accompanying hardware. This limited warranty gives you specic legal rights.
Return authorization must be obtained from the vendor before returned merchandise will
be accepted. Authorization can be obtained by calling or faxing the vendor and requesting
a Return Merchandise Authorization (RMA) number. Returned goods should always be
accompanied by a clear problem description.
- viii -
This page is intentionally left blank.
Inhaltsverzeichnis
Andere Arbor Technology Touch-Terminal Handbücher
Beliebte Touch-Terminal Handbücher anderer Marken
Wincor Nixdorf
Wincor Nixdorf iPOS plus Advanced Bedienungsanleitung
Ingenico
Ingenico AXIUM EX4000 Bedienungsanleitung
Heisei Electronics
Heisei Electronics Q-POS 815 Bedienungsanleitung
Amano
Amano MTX-15 Bedienungsanleitung
FLOWBIRD
FLOWBIRD CWT Compact Touch Bedienungsanleitung
Demco
Demco SP7 Bedienungsanleitung
Motorola
Motorola MTP850 Bedienungsanleitung
YASKAWA
YASKAWA 62H-MDC0 Bedienungsanleitung
MVG industries
MVG industries NeptuLink Bedienungsanleitung
Price Industries Limited
Price Industries Limited FDC Gebrauchsanweisung
Honeywell
Honeywell TemaKey Bedienungsanleitung
EBN
EBN BPC65-B-A16G Bedienungsanleitung