Arcatron SAS 100 Bedienungsanleitung
1
USER MANUAL SAS 100
www.arcatron.com
SAFETY GUIDELINES:
INTRODUCTION:
Arcatron SAS100/SSS100 Shower and Commode wheelchair is to be used only
after reading and understanding this user manual. If some parts of the manual are
not understood, clarification shall be sought prior to using the product. Updated
manual can be accessed online at our website www.arcatron.com product
page. Failure to comply with this manual fully, may result in injury, damage and
warranty void and we will be in anyways not liable for the same.
DO’s
•This wheelchair is designed and meant to be used indoors including but
not limited to accessible bathrooms for persons weighing up to 90 kg.
•The most dangerous part associated with using any shower chair is
transfers. It is strongly recommended to review and learn the necessary
transfer techniques with the help of consultant physiotherapist before
using this wheelchair.
•Long period of sitting shall be avoided without consulting from a doctor
or a professional physiotherapist.
•It shall be ensured that all caster wheel locks are engaged while in
outward position before shifting to or from the wheelchair.
•It is recommended that transfers to/from this wheelchair is carried out
on dry, non-slippery surfaces.
•If used as a Self-Propelled wheelchair (using Arcatron SSS100 Expansion
Pack), the big wheels shall be locked along with casters while shifting
from/to the wheelchair.
•If any need for maintenance is felt, it is recommended that
users/caregivers shall contact nearest Arcatron distributor or reach us
•It is recommended to use straps/restraints while constrained on the
wheelchair.
•Store the wheelchair in only dry conditions (Ambient Temp: 0-45 *C
Relative humidity: 30%-70%) and keep away from direct sunlight
2
USER MANUAL SAS 100
www.arcatron.com
DONT’s
•This wheelchair is not meant for outdoor use and especially over uneven
surfaces (depressions/bump > 10 mm).
•This wheelchair shall not be used unsupervised without taking consent
and guidelines from consulting doctor or a professional physiotherapist.
•Don’t immerse this wheelchair in part or whole, in water or any other
liquid as it may lead to damage of the components.
•Don’t ever use the footplate to assist in transfers. This is extremely
hazardous and causes the chair to topple resulting in injury.
•Don’t lean too much in front while sitting on the wheelchair to avoid
tipping
•Don’t tilt or lift the wheelchair in part or whole while the user is sitting
on it.
•Don’t reach the hinge areas to avoid pinching hazards.
•Don’t push or pull the wheelchair up or down ramps that exceed 1:12
grade (5-degree slope)
3
USER MANUAL SAS 100
www.arcatron.com
In the box:
1. Seat frame with Seat Cushion
2. Backrest frame with Armrests
3. Rear Caster Pipes
4. Front Caster Pipes (With a Bent pipe)
5. Footrest Pipe with footrest plate
6. Footrest Restraint
7. C-Pin
8. Quick Release Clip
If bought as self-propelled series then,
9. Mag-wheels
10. Quick release axle
9
1.
2.
3.
4.
5.
6.
7.
8.
4
USER MANUAL SAS 100
www.arcatron.com
ASSEMBLY INSTRUCTIONS
Difference between front and back caster pipes
Keep the Seat Frame upside down on a smooth and clean surface.
5
USER MANUAL SAS 100
www.arcatron.com
Insert the castor pipe and adjust it to the required height.
Insert front caster pipe:
Release the Quick release tab. Remove the C-pin.
6
USER MANUAL SAS 100
www.arcatron.com
Repeat the same process for rest three caster pipes. Make sure all pipes
are at same levels.
Align the hole of castor pipe with the hole on frame and insert the C-Pin.
Close the Quick release tab. Make sure the Caster pipe is fixed and there is
no play.
7
USER MANUAL SAS 100
www.arcatron.com
Take the Footrest pipe. Notice the notch on the end of the pipe. This notch
should align/rest on the peg of the C-Pin that is inserted in the footrest
pipe socket.
Flip the chair right side up. Engage all the brakes on caster wheels. Pic
shows how to engage brakes.
8
USER MANUAL SAS 100
www.arcatron.com
Height adjustment of footrest:
There are 3 levels of height adjustments in footrest. Height of footrest can
be adjusted with the help of C-pin
9
USER MANUAL SAS 100
www.arcatron.com
To swivel the footrest inside or outside, lift it and turn it inside or outside.
Setting up the footrest restraint: Make sure Velcro side comes behind.
Fold the flaps inside to attach the footrest restraint. The tension in the
footrest can be adjusted with the help of Velcro.
10
USER MANUAL SAS 100
www.arcatron.com
To assemble the backrest, remove the C-pins.
Insert the backrest and align the hole on backrest with the hole on frame
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Arcatron Rollstuhl Handbücher
