Arlo Telguard Go Bedienungsanleitung
1
Arlo Go Quick Start Guide
Welcome
Thank you for choosing Arlo Go.
3
What’s in the box
Arlo Go camera Rechargeable
battery
Mount and screws Synthetic
grease
Arlo Go
USB port cap
Arlo Go
wind bracket
Outdoor power adapter
(varies by region)
4
Activate your SIM card
Your Arlo Go camera uses Telguard’s cellular partners to send pictures
and videos to your Arlo account in the cloud.
Only authorized Telguard dealers can activate Telguard services.
¾To activate your Telguard service plan:
1. Locate your camera’s ICCID.
This number is on the bottom of the Arlo Go box. If you cannot
find your Arlo Go box, contact Telguard customer service for
assistance.
2. Enter www.telguard.com/portal in the address bar of your
favorite browser.
3. Follow the registration process prompts.
4. Register the SIM card using the ICCID provided.
After the registration is complete, the SIM card is active and
ready to use.
5
Insert your SIM card
1. Unlock the Arlo Go battery compartment by pressing and holding
the latch.
2. Gently pull the battery door back to open the compartment.
3. Align the gold SIM contacts.
4. Insert the SIM card into the SIM card slot.
6
Insert the battery
1. Unlock the battery compartment by pressing and holding the
latch.
2. Gently pull the battery door back to open the compartment.
3. If you plan to store video recordings on an SD card, insert the SD
card now.
4. Align the battery contacts.
5. Insert the battery.
6. Close the battery door.
7
Get the Arlo app
Download the free Arlo app to get started.
The app guides you through installation.
8
Mount your camera
1. Place the wall plate and secure it with three screws.
2. Attach the camera to the wall plate.
If you’re mounting the camera to drywall, be sure to use the
included plastic drywall anchors.
9
If you’re plugging in the camera outdoors
Pay attention to the weather and to power outlet safety considerations:
• You must use an Arlo Go outdoor
power adapter. Do not use any other
power adapter.
• Install the wind bracket for support
between the camera and the power
adapter.
• Connect the Arlo Go outdoor power
adapter only to a weatherproof power
outlet.
10
Install the wind bracket
1. Remove the USB port cap from the camera by pulling firmly on
the cap.
2. Slide the wind bracket onto the power adapter cable.
3. Apply a thin layer of synthetic grease around the cable
connector end.
4. Connect the cable connector to the USB port on your camera
and press in firmly.
Extra USB port caps
are included so that
you can use the camera
wire‑free later.
Inhaltsverzeichnis
Andere Arlo Digitalkamera Handbücher
Arlo
Arlo Pro 3 Bedienungsanleitung
Arlo
Arlo Pro 5 Bedienungsanleitung
Arlo
Arlo VMS4240B Bedienungsanleitung
Arlo
Arlo Pro 4 Bedienungsanleitung
Arlo
Arlo Pro 2 Bedienungsanleitung
Arlo
Arlo Pro 3 Bedienungsanleitung
Arlo
Arlo QC9204 Bedienungsanleitung
Arlo
Arlo Pro 4 Handbuch
Arlo
Arlo Pro 5 Handbuch
Arlo
Arlo Ultra Bedienungsanleitung
