Artila Matrix-752 Montageanleitung
Copyright © Artila Electronics Co., Ltd. All Rights Reserved.
Matrix-752
Linux-Ready Cortex-A7 Industrial
IoT Gateway
Hardware Guide
Version: 1.0
2020 JUNE
Matrix-752 ardware Guide
ARTILA
2
Trademarks
The Artila logo is a registered trademark of Artila Inc. All other trademarks or
registered marks in this manual belong to their respective manufacturers.
Disclaimer
Information in this document is subject to change without notice and does not
represent a commitment on the part of Artila.
Artila provides this document as is, without warranty of any kind, either expressed
or implied, including, but not limited to its particular purpose. Artila reserves the
right to make improvements and/or changes to this manual, or to the products
and/or the programs described in this manual, at any time.
Information provided in this manual is intended to be accurate and reliable.
owever, Artila assumes no responsibility for its use, or for any infringements on
the rights of third parties that may result from its use.
This product might include unintentional technical or typographical errors.
Changes are periodically made to the information herein to correct such errors,
and these changes are incorporated into new editions of the publication.
FCC AND IC INF RMATI N:
This Class A digital apparatus complies with Part 15 of the FCC rules and with
Canadian ICES-003
peration is subject to the following two conditions:
1. This device may not cause interference and
2. This device must accept any interference. Including interference that may
cause undesired operation of the device.
Matrix-752 ardware Guide
ARTILA
3
Document Amendment History
Revision
Date Remark
V 1.0 2020 June Initial
Matrix-752 ardware Guide
ARTILA
4
Table of Contents
1.
Introduction .................................................................................................... 5
1.1
Features .................................................................................................. 5
1.2
Specifications ( ardware)........................................................................ 5
1.3
Specifications (Software) ......................................................................... 7
1.4
Packing List ............................................................................................. 8
1.5
Optional Accessory.................................................................................. 8
1.6
Optional Communication Module ............................................................. 8
2.
Layout ............................................................................................................. 9
2.1
Connector & LED Indicator ...................................................................... 9
2.2
Dimension ............................................................................................... 10
3.
Pin Assignment and Definitions .................................................................... 11
3.1
Multi-function Reset Button ...................................................................... 11
3.2
LED Indicators ......................................................................................... 12
3.3
Ethernet LAN Port ................................................................................... 13
3.4
Power Connector ..................................................................................... 14
3.5
USB OTG Port ......................................................................................... 14
3.6
Serial Port ............................................................................................... 15
3.7
CAN Bus Port .......................................................................................... 17
3.8
Digital Input ............................................................................................. 18
3.9
Digital Out ............................................................................................... 19
3.10
Serial Console Port.................................................................................. 20
3.11
External Battery connection ..................................................................... 21
3.12
SD card Socket ....................................................................................... 21
3.13
miniPCIe Slot........................................................................................... 22
3.14
Micro-SIM card socket ............................................................................. 22
Matrix-752 ardware Guide
ARTILA
5
1. Introduction
Matrix-752 based on arm Cortex-A7, is a Linux-ready IoT gateway with highly
integrated and low power consumption. Matrix-752 provides an ideal building block
that easily integrates with a wide range of target markets, such as industrial control,
automation, mobile gateway and other applications.
1.1 Features
NXP iMX6ULL 800M z Cortex-A7 Processor
Linux kernel 5.4.x and file system
Support Toolchain: gcc 9.3.0 + glibc 2.31
512MB LvDDR3 SDRAM
Two 10/100Mbps Ethernet port
One USB OTG port
One RS-485 / RS-232 port & One RS-232 port
One CAN port
Two channels Digital Input
Two channels Digital out
One micro-SD socket
One full size miniPCIe socket inside
One micro-SIM socket
Two SMA-type Antenna holes reserved
+9 to +48VDC power input
Ultra-low power consumption
Wall-mounting, Optional DIN RAIL mounting adaptor
1.2 Specifications (Hardware)
CPU / Memory
• CPU: NXP iMX6ULL Cortex-A7 MPCore, up to 800M z
• SDRAM: 512MB, LvDDR3
Network Interface
• Type: 2 x 10/100Mbps Ethernet
• Connector Type: RJ45 (with LED indicator)
USB Interface
• 1 x USB OTG Port
• Micro-USB connector
Matrix-752 ardware Guide
ARTILA
6
TTY (Serial) Ports
• 1 x RS-485 or RS-232 Port
• 1 x RS-232 Port
• Direction Control (RS-485): Auto, by software
• Connector: Terminal block
• RS-485 Signal: Data+, Data-
• RS-232 Signal: TX, RX
TTY (Serial) Port Parameters
• Baud Rate: Up to 921.6Kbps
• Parity: None, Even, Odd, Mark, Space
• Data Bits: 5, 6, 7, 8
• Stop Bits: 1, 1.5, 2
• Flow Control: RTS / CTS, XON / XOFF, None
CAN Bus Ports
• 1 x CAN Bus 2.0 A/B compliant ports
• Speed: Up to 1Mbps
• Isolation: 2500Vrms
Digital Input
• 2 x Digital Input Channels
• Isolation Protection: 2500Vrms (Photo Coupler)
• Logical igh: 5~24VDC
• Logical Low: 0~1.5VDC
Digital utput
• 2 x Digital Output Channels (Solid State Relay)
• Solid State Relay: Normal Open (NO) Type
• Contact Rating: 80VDC@1.5A
Console / Debug Ports
• Serial console port
• 4PIN Box header (inside the box)
Matrix-752 ardware Guide
ARTILA
7
SD Slot
• 1 x microSD socket
• SD 2.0 compliant, supports SD C
• Storage capacity: Support up to 128G
Expansion Slot
• 1 x Full-Size miniPCIe socket
• 1 x micro-SIM card socket reserved, USB interface
• 2 x SMA-type Antenna holes reserved
Power Requirement
• Input Voltage: +9~+48VDC (terminal block)
• Typical Power Consumption: 12VDC@250mA
(miniPCIe module, SD card are not included)
General
• Watchdog: Yes
• Realtime Clock: Yes, backup by super capacitor
• Dimensions (W x L x ): 89 x 112 x 30mm (3.5 x 4.4 x 1.18in)
• Net Weight: 350g (0.77lb), miniPCIe module and antenna are NOT included.
• Operating Temperature: 0~70°C (32~158°F)
• Regulation: CE Class A, FCC Class A
• Installation: Wall mounting, DIN-rail mounting (with optional kit)
1.3 Specifications (Software)
peration System
• Linux Kernel 5.4.x
• Supports bootup from eMMC or SD card
• Support Backup/Restore from SD card or USB device
• Boot Loader: U-Boot
• File System: EXT4/EXT3/EXT2, VFAT/FAT, NFS
Software Development
• Toolchain: gcc 9.3.x + glibc 2.31
• Supports in-place C/C++ code compilation
Matrix-752 ardware Guide
ARTILA
8
Package Management
• Package repository: Artila self-maintained repository
• Command: Using standard apt-get command
Popular Packages
Web server: Apache/Nginx/Lighttpd
Database: MySQL/SQLite3/PostgreSQL
Script Language: P P/Python/Perl/NodeJS
Text editor: vim/nano/sed
Administration: Webmin
1.4 Packing List
Matrix-752: Linux-ready Cortex-A7 800M z Industrial IoT Gateway
with 512MB SDRAM, 16G eMMC
1.5 ptional Accessory
DK-35A (36-DK35A-000): DIN RAIL Mounting Kit
PWR-12V-1A (31-62100-000): 110~240VAC to 12VDC 1A Power Adaptor
Console Cable (CB-P DF9-050): 4Pin Wafer Box to DB9 Female, 50cm
1.6 ptional Communication Module
4G/LTE miniPCIe Module with Antenna
Wifi miniPCIe Module with Antenna
Matrix-752 ardware Guide
ARTILA
9
2. Layout
2.1 Connector & LED Indicator
RS485(D+/D-)
or RS232(TX1/RX1)
US OTG
CAN
Digital Output
Ready LED
Serial Port LED 1
Serial Port LED 2
Micro-SD (internal)
Micro-SIM (internal)
Console
Power
Input
LAN
Hole
(Reserved
for Antenna)
Hole
(Reserved
for Antenna)
Reset
RS232(TX2/RX2)
Digital Input
GND
Matrix-752 ardware Guide
ARTILA
10
2.2 Dimension
Unit: mm
112.0mm 30.0mm
89.0mm
111.0mm
Inhaltsverzeichnis
Andere Artila Tor Handbücher
Artila
Artila Matrix-710 Montageanleitung
Artila
Artila Matrix-702 Montageanleitung
Artila
Artila Aport-212 Bedienungsanleitung
Artila
Artila Aport-211S Bedienungsanleitung
Artila
Artila Aport-213 Bedienungsanleitung
Artila
Artila Matrix-713 Montageanleitung
Artila
Artila Matrix-310 Montageanleitung
Artila
Artila Matrix-750 Montageanleitung
Beliebte Tor Handbücher anderer Marken
LST
LST M500RFE-AS Bedienungsanleitung
Kinnex
Kinnex Media Gateway Bedienungsanleitung
2N Telekomunikace
2N Telekomunikace 2N StarGate Bedienungsanleitung
Mitsubishi Heavy Industries
Mitsubishi Heavy Industries Superlink SC-WBGW256 Bedienungsanleitung
ZyXEL Communications
ZyXEL Communications ZYWALL2 ET 2WE Bedienungsanleitung
Telsey
Telsey CPVA 500 - SIP Bedienungsanleitung
