Step
Wireless Setting
After setting of Ethernet IP address, enter the
Wireless Setting page.
1
Start
Wireless Setting
Wireless Bandwidth
Primary time of WLAN or 802.11 b/g offers 11Mbps
or 54mbps share bandwidth. The WLAN bandiwdth is
much less than that offered by Ethernet switch which
can sustain multiple channels of milti-mega bits of
realtime stream data like video.
Due to the bandwidth limitation of WLAN, It is
HIGHLY recommended to set video Quality below
1.5Mbps and below.
If your signal strength from wireless router/AP is
below 50%, either you need to adjuest AP or
camera position or boost antenna power. Please
consult your network manager.
Camera will automatically scanned Wireless APs
when you enter the page, or you may press “scan”
again. Importantly, you need to ensure your
WLAN AP is shown and with encyption enable.
2
Search/Select Wireless AP
.
Select Infrastructure mode, auto and enter SSID,
Select WEP Encryption to be 64 bits or 128bits
depending on your wireless router/AP setting.
Enter the exact same KEY that your used for the
wireless router/AP. Select DHCP or enter static IP
address based on your network plan. Press “Save”.
3
Setting the Network Paramaters
4
Refresh/reload page. After few seconds, you
should see the new wireless IP address.
Wireless Setting Confirm
Relocate Camera and Final Test
Step
Unplug the RJ45 on both router and the
network camera so that you can start
to use wireless independently.
Unplugged Ethernet
1
Relocate & Mount Device
.
Please mount the device to the preferred
location and power on the device.
2
You may “Test” if it has been connected and
operated smoothly.
1) Set Up your PC on the same WLAN subnet.
2) Use IP Finder to identify the Network Camera.
3) Use IE brower to view the video
4) Check to make sure that wireless signal strength
is at least 50%.
5) Check to make sure that the Video Quality is set
lower than 1.5Mbps
6) View the video.
Test & RUN
3
